WAP Aqua 1200.2 B - Pressure washer NILFISK - Free user manual and instructions

Product Type	Pressure Washer
Brand	Nilfisk
Model	WAP Aqua 1200.2 B
Power Supply	230 V / 50 Hz
Power Consumption	1200 W
Max Pressure	100 bar
Rated Pressure	80 bar
Water Flow	400 L/h
Max Water Temperature	40 °C
Hose Length	5 m
Power Cord Length	3 m
Weight	5.2 kg
Dimensions (LxWxH)	31 x 20 x 31 cm
Nozzle Type	Adjustable spray lance
Detergent Tank	Built-in, 0.5 L
Safety Features	Auto-stop system, trigger lock, thermal cut-out
Protection Class	IPX5
Noise Level	75 dB(A)
Vibration Level	2.5 m/s²
Spare Parts Availability	Yes, via Nilfisk service centers

Frequently Asked Questions - WAP Aqua 1200.2 B NILFISK

How do I start the pressure washer?

Ensure the unit is connected to a water supply and power. Turn on the water tap, squeeze the trigger on the lance to release air, then switch on the power button. Wait for the motor to start and press the trigger to use.

What type of detergent can I use?

Use only pH-neutral detergents designed for pressure washers. Do not use corrosive or flammable chemicals. Fill the detergent tank and adjust the nozzle for low-pressure application.

Why is the pressure washer not building pressure?

Check if the water supply is fully open and the hose is not kinked. Ensure the nozzle is not clogged. If the auto-stop function is activated, release the trigger to reset.

How often should I clean the water filter?

Inspect the water inlet filter before each use. Clean it with lukewarm water if debris accumulates. A clogged filter can reduce performance.

Can I use an extension cord?

Yes, but use a heavy-duty extension cord rated for outdoor use with a minimum cross-section of 2.5 mm² and a length not exceeding 10 m to avoid voltage drop.

How do I store the pressure washer after use?

Disconnect water and power. Squeeze trigger to release residual pressure. Disconnect lance and hose. Drain any remaining water from the system. Store in a frost-free place.

What does the auto-stop function do?

The auto-stop system switches off the motor when the trigger is released, saving energy and reducing wear. The motor restarts when the trigger is pulled again.

Why does the unit shut off during use?

This may be due to thermal overload protection. Let the unit cool for at least 15 minutes. Check for blocked nozzles or low water pressure causing overheating.

How do I clean the nozzle?

First, disconnect the lance. Use the provided nozzle cleaning tool (if included) or a fine needle to remove debris from the nozzle orifice. Rinse with clean water.

Where can I find replacement parts?

Contact Nilfisk authorized service centers or visit the official Nilfisk website for spare parts such as hoses, nozzles, and seals. Use only genuine components.

USER MANUAL WAP Aqua 1200.2 B NILFISK