GGPC1 - Pump Salus - Free user manual and instructions

Product Type	Circulator Pump
Brand	Salus
Model	GGPC1
Power Supply	230 V AC, 50 Hz
Power Consumption	60 W
Dimensions (H x W x D)	150 mm x 100 mm x 100 mm
Weight	1.5 kg
Max Flow Rate	30 L/min
Max Head	6 m
Functions	On/Off, 3-speed manual control
Maintenance	Clean pump body regularly; check for leaks and unusual noise
Safety Features	Overheating protection, IPX4 water resistance
Spare Parts Available	Impeller, shaft seal, capacitor, gaskets
Intended Use	Circulation of water in heating systems
Connection Size	1 inch (25 mm) threaded

Frequently Asked Questions - GGPC1 Salus

How do I install the GGPC1 pump?

Ensure power is off. Connect the pump to the pipework using appropriate fittings. Wire the pump to a 230V AC supply following the wiring diagram in the manual. Secure all connections and purge air from the system.

What should I do if the pump is not starting?

Check the power supply and ensure the pump is correctly wired. Verify that the thermal overload protection hasn't tripped. If the pump is stuck, turn off power and manually rotate the shaft using a screwdriver.

Can the pump be used with antifreeze?

Yes, the pump is compatible with water and water-glycol mixtures up to 30% concentration. Ensure the viscosity does not exceed the pump's specifications.

How do I set the speed?

The GGPC1 has a three-speed selector switch on the terminal box. Choose speed I, II, or III for low, medium, or high flow respectively.

What is the maximum operating temperature?

The pump is designed for water temperatures from -10°C to +110°C. Exceeding this range may damage the pump.

How often should I maintain the pump?

Inspect the pump annually for leaks, noise, and proper operation. Clean the pump casing if dusty. The shaft seal should be replaced every 2-3 years in heavy use.

Why is the pump noisy?

Noise can be due to air in the system, cavitation, loose mountings, or worn bearings. Bleed the system, tighten mounting bolts, or replace the pump if bearings are damaged.

Is the pump suitable for potable water?

No, this pump is intended for closed-loop heating systems only. It should not be used for drinking water.

How do I replace the impeller?

Disconnect power, drain the pump, remove the motor housing, and unscrew the impeller. Install a new impeller and reassemble. Refer to the manual for detailed steps.

Where can I buy spare parts?

Spare parts are available from authorized Salus distributors or online. Use part numbers from the manual: impeller (P-IMP-001), shaft seal (P-SEAL-002).

USER MANUAL GGPC1 Salus

Northfield Business Park Forge

Way, Parkgate, Rotherham S60

TSD, United Kingdom

Computime

www.saluscontrols.com

SALUS Controls je členem skupiny Computime limited.

Two-step diagram showing internal components with arrows indicating movement, no text or symbols present

Technické informace