MLW-25 - Curling iron MPM - Free user manual and instructions
Find the device manual for free MLW-25 MPM in PDF.
User questions about MLW-25 MPM
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Curling iron in PDF format for free! Find your manual MLW-25 - MPM and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. MLW-25 by MPM.
USER MANUAL MLW-25 MPM
EN We wish you satisfaction from using the product and invite you to check a wide range of other MPM appliances.
3 A/1 B, N I A J S / A R I O I S H A C S A V A R O
3 IN THE ALUKUZ/ICVIN LVAS18-PLAUK1SUK LVAS
3 IN 1 MATU ZAVELAUS UN LOKSKERES
3 IN THAAROROGLRN KHULLER
natural_image
Close-up of a black and gold hair roller with spiky bristles (no text or symbols visible)CZ NÁVOD K OBSLUZE 3
text_image
Diagram showing numbered items of hair bristles with labels 6, 7, 8, and 9 indicating different components.
3-stage temperature and airflow regulation
Ionization
- prevents electrification of hair
Two curling attachments (right and left) using the Coanda effect
Volumizing oval-shaped brush styling hair
Focusing nozzle for quicker drying of hair
BEZPEČNOSTNÍ POKYNY PŘI POUŽÍVÁNÍ
natural_image
Technical line drawing of a device with two circular components and a handle (no text or symbols)natural_image
Line drawing of a device with two circular components and a handle (no text or symbols)natural_image
Technical line drawing of a device component with two circular ports and a handle (no text or symbols)natural_image
Technical line drawing of a mechanical component with circular and rectangular features (no text or symbols)SAFETY INSTRUCTIONS FOR USE
- Read the operating instructions carefully before use.
- Do not hold the device with wet hands.
- Take special care when children are around the device.
- Do not use the device for any other purpose than it was intended.
- Do not immerse the device, cable and plug in water or other liquids.
- Do not leave the device unattended during operation.
- Always remove the plug from the mains socket when not using the appliance or before cleaning.
- Do not use a damaged appliance, even if the mains cable or plug is damaged - in this case, have the appliance repaired at an authorised service centre.
- Do not use the device outdoors.
- Do not hang the power cord on sharp edges or allow it to come into contact with hot surfaces.
- Do not place the unit on hot surfaces or near other electrical appliances, burners, cookers, ovens, etc.
- Place the device on a dry, flat and stable surface.
- The device is intended for home use only.
- Always ensure that all components of the appliance are correctly fitted before starting work.
- The use of accessories not recommended by the manufacturer may cause damage to the unit, fire or injury.
- This equipment may be used by children of at least 8 years of age and by persons of diminished physical and mental capabilities and persons with inexperience and lack of familiarity with the equipment if supervision or instruction is provided on how to use the equipment safely so that the associated risks are understood. Unsupervised children should not perform cleaning and maintenance of equipment.
- The device is not a toy and should not be used as such by children. - Keep the device and its cable out of reach of children under 8 years old.
- Do not pull the plug out of the mains socket by pulling the cord.
- The equipment is not designed to work with external timers or a separate remote control system.
- Do not connect the plug to the mains socket with wet hands.
- For the safety of children, please do not leave freely accessible parts of the packaging (plastic bags, cardboard boxes, polystyrene, etc.).
- WARNING! Do not allow children to play with the film. Danger of suffocation!
- Check that the power supply parameters on the unit's rating plate match those of your mains supply.
- NOTE! Unplug the unit from the mains supply and wait until it has cooled down completely after use before carrying out any cleaning or maintenance work. Do not immerse the device in water!
- NOTE! Sharp objects, abrasive pastes, solvents and other strong chemicals must not be used for cleaning - their use may damage the unit.
- Keep the device away from water!
- Do not use the device while bathing!
- If the device accidentally falls into water, unplug it from the mains socket immediately!
- When drying, take care that hair does not get caught in the air outlet and air inlet openings.
- Hot air must not be directed towards the eyes or other sensitive areas.
- Do not coil the power cord around the unit!
- Do not cover the air outlet and air inlet openings!
- For additional protection, it is advisable to install a residual current device (RCD) with a rated residual current of not more than 30mA in the electrical circuit supplying the bathroom. A specialist electrician should be consulted in this respect.
- When the hair dryer is used in the bathroom, disconnect it from the power source after use, as proximity to water is a hazard even when the hair dryer is switched off.
WARNING! Do not use this equipment near water.
WARNING! Do not use this equipment near bathtubs, showers, swimming pools and similar bodies of water.
DESCRIPTION OF THE DEVICE
- Mode changeover switch
- ON/OFF button
- Housing
- Air inlet grille
-
Power cable
-
Right-hand curl attachment
- Left-hand curl attachment
- Oval styling brush
- Focusing cap
BEFORE FIRST USE
- Unpack the device from the carton, remove all bags, labels, cardboard and fillers. Inspect the device for any damage that may have occurred during transportation. If you have any doubts, contact your dealer.
- Make sure that the parameters of your mains supply correspond to the technical data on the product's rating plate.
USE OF A HAIRDRYER
- Fit the chosen attachment to the curling iron as shown. Make sure that the groove of the cap and the hook of the body are aligned with respect to each other. Insert the hairstyling tip into the cap, then rotate it and attach it
- Press the ON/OFF button (2) to start the device.
- Use the change mode switch (1) to select your preferred speed and temperature settings:
natural_image
Line drawing of a device with two circular components and a rectangular button (no text or symbols)▶ 1 — strong warm air blast for gentle drying
▶ 2 — medium blast of hot air for drying and styling
▶ 3 — strong hot air blast for quick drying.
- When drying is complete, press the ON/OFF button (2) and disconnect the device from the power source.
Use high settings to dry your hair and low settings to style it.
The unit is equipped with an air ionisation function. Thanks to this function, negative ions are released when the device is switched on and settle on the hair, causing positive charges to be neutralised. This prevents hair from becoming static and individual strands are smoothed out.
NOTE! During use, do not cover the air inlet grille (4), which is located at the back of the dryer, as the appliance can then easily overheat.
The dryer has an overheating protection system - in the event of a clogged air outlet openings or overheating, it will switch off automatically. Unplug the unit from the power supply and allow it to cool down for about 10-15 minutes before restarting.
CLEANING AND MAINTENANCE
For proper operation, the device should be kept clean.
Simply follow the rules below before you start cleaning.
- Always disconnect the device from the power supply after use.
- Once the dryer has cooled down, you can wipe the outside of the housing with a damp cloth.
- Do not wrap the cable around the device, but coil it loosely at the side.
NOTE! Sharp objects, abrasive pastes, solvents and other strong chemicals must not be used for cleaning - their use may damage the unit.
TECHNICAL DATA
| Model MLW-25 | |
| Power supply 220-240V ~ 50-60HZ | |
| Power 1200W | |
| Off and standby mode available available | |
| Power consumption in standby mode - | |
| Power consumption in off mode 0,08W | |
| Power consumption in standby mode with display | - |
| Power consumption in network standby mode | - |
| It automatically goes into standby mode after - | |
| Automatically goes into shutdown mode after - | |
| Network standby mode, if the device has a connection function with the appli cation | - |
| Length of mains cable 1.7 m |
CAUTION! MPM agd S.A. reserves the right to technical changes.
Proper disposal of the product (waste electrical and electronic equipment)
Marking on the product indicates that after the service-life of the product expires, it should not be disposed with other type of municipal waste. Used equipment may have a negative impact on the environment and health of people due to potentially containing hazardous substances, mixtures and components. Mixing electric waste with other types of waste or disassembling those in an unprofessional manner may cause a release of substances that are hazardous to the environment and health.
Used equipment should be handed-over to a point for collection of electric waste. In order to obtain detailed information regarding the electric waste collection points, the user should contact the municipal point of electric waste collection or used equipment processing department.
