CLEAR 35.1168.02 - Weather Station TFA - Free user manual and instructions

USER MANUAL CLEAR 35.1168.02 TFA

Operating Instructions

Mode d'emploi

Thank you for choosing this instrument from TFA. Before you use this product

.

Please make sure you read the Instruction manual carefully.

• The operating instructions are enclosed with the device or can be downloaded at
  www.tfa-dostmann.de/en
  service/downloads/instruction-manuals
• This product should only be used as described within these instructions.
• Following and respecting the instructions in your manual will prevent damage to your instrument and loss of your statutory rights arising from defects due to incorrect use. We shall not be liable for any damage occurring as a result of non-following of these instructions.
• Please take particular note of the safety advice!
• Please keep this instruction manual safe to future reference.

service/downloads/instruction-manuals

www.tfa-dostmann.de/en/ service/downloads/instruction-manuals

Wireless Weather Station

1. Delivery contents

• Wireless weather station (base station)
• Temperature-humidity sensor (Cat.-No.: 30.3256.02)
- Instruction manual

2. Range of application and all the benefits of your new instrument at a glance

• Outdoor temperature and humidity wireless
(433 MHz), distance range up to 100 m (open field)
- Indoor temperature and humidity
• Relative atmospheric pressure
- Weather forecast with symbols and atmospheric pressure trend
• Wall mounting or table stand
- Optional: Expandable up to 3 temperature-humidity-transmitters (sold separately), also for the climate control of remote rooms, e.g. children's room, wine-cellar etc.

3. Safety notices

- This product is exclusively intended for the range of application described above.

WARNING

• Keep these devices and the batteries out of reach of children.
• Small parts can be swallowed by children (under three years old).
• Batteries contain harmful acids and may be hazardous if swallowed. If a battery is swallowed, this can lead to serious internal burns and death within two hours. If you suspect a battery could have been swallowed or otherwise caught in the body, seek medical help immediately.
• Batteries must not be thrown into a fire, short-circuited, taken apart or recharged. Risk of explosion!
• Low batteries should be changed as soon as possible to prevent damage caused by leaking.
• Never use a combination of old and new batteries together, nor batteries of different types.
• Make sure the polarities are correct. Remove the batteries if the device will not be used for an extended period of time. Avoid contact with skin, eyes and mucous membranes when handling leaking batteries. In case of contact, immediately rinse the affected areas with water and consult a doctor.

Wireless Weather Station

CAUTION

• Unauthorised repairs, alterations or changes to the product are prohibited.
• Do not expose the device to extreme temperatures, vibrations or shocks.
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
• The base station is suitable for indoor use only. Protect it from moisture!
• The transmitter is splashproof, but not watertight.

4. Elements

Base station (Receiver)

A: Display (Fig. 1):

A 1: Weather forecast with symbols
A 2: Atmospheric pressure trend
A 3: Outdoor humidity
A 4: Indoor humidity
A 5: Battery symbol for the transmitter
A 6: Battery symbol for the base station
A 7: Indoor temperature
A 8: Outdoor temperature
A 9: Transmitter reception symbol

A 10: Channel number
A 11: Symbol for alternating channels
A 12: Relative atmospheric pressure

B: Buttons (Fig. 2):

B 1: DOWN button
B 2: IIP button
B 2: OP button B 3: CHANNEL button
B 4: SET button

C: Housing (Fig. 2):
C 1: Wall mounting hole
C 2: Battery compartment
C 3: Stand (fold out)

D: Transmitter (Fig. 3):

D 1: Temperature
D 2: Battery symbol
D 3: Humidity
D 4: Channel 1.2.3
D 5: Transmission signal
D 6: LED light
D 7: Suspension device
D 8: *C/*F button

Wireless Weather Station

D 9:321 switch for channel selection

D 10: Battery compartment

5. Getting started

5.1 Insert the batteries

• Place the base station and the transmitter on a table at a distance of about 1.5 meters from each other. Avoid being close to possible sources of interference such as electronic devices and radio equipment. Remove the two display protection films.
• Open the battery compartment of the base station and insert two new AAA 1.5V batteries, polarity as illustrated. All LCD segments will be displayed for a short moment. The indoor temperature and humidity appear on the display.
• Insert two new batteries 1.5 V AAA into the battery compartment of the transmitter. Make sure the polarities are correct.
• All LCD segments will be displayed for a short moment and the LED light flashes.
• The transmitter's display shows the current temperature and humidity. The switch is set to channel 1. Press the °C/°F button to change between °C (Celsius) or °F (Fahrenheit) as temperature unit.
• Close the battery compartments.

5.2 Outdoor values reception

• After the batteries are inserted, the outdoor values will be transmitted to the base station. The reception symbol for the transmitter flashes.
- If the reception of the outdoor values fails, “- -,-” remains on the base station display. Check the batteries and try it again. Check if there is any source of interference.
- You can also start the outdoor transmitters search manually later (e.g. if the transmitter is lost or if the batteries are changed). Press and hold the CHANNEL button for three seconds. The last registered transmitter (channel) will be cancelled.
- The reception symbol of the transmitter flashes and the base station will scan the outdoor values.

6. Operation

6.1 Manual settings

• Press the DOWN button to change between °C (Celsius) or °F (Fahrenheit) as temperature unit.
• Press and hold the SET button for three seconds to enter the setting mode.
  • The weather symbol flashes on the display.
• For a correct weather forecast the actual weather conditions have to be set (see "weather symbol").

Wireless Weather Station

• Use the UP or DOWN button to make the desired setting, while the value flashes.
• Confirm with the SET button and go to the atmospheric pressure setting.
• The relative atmospheric pressure is referred to the sea level's pressure and has to be adjusted first to your local altitude. Ask for the current atmospheric pressure of your home area (Local weather service, Internet, optician, calibrated instruments in public buildings and airport).
• Use the UP or DOWN button to make the desired setting, while the value flashes. Press and hold the UP or DOWN button in setting mode for fast mode.
• The device will automatically quit the setting mode if no button is pressed for 8 seconds.
• Briefly press the SET button again, confirm the entry and return to normal mode.

7. Forecast

7.1 Weather forecast symbols (Fig. 4)

• The 4 weather icons "Sunny, Partly Cloudy, Cloudy and Rainy" represent the weather forecast.
  • The weather forecast relates to a range of 12 to 24 hours and indicates only a general weather trend.

For example, if the current weather is cloudy and the rain symbol is displayed, it does not mean the product is faulty because it is not raining. It simply means that the air pressure has dropped and the weather is expected to get worse but not necessarily rain.

7.2 Trend arrows

- The trend arrows on the display will show whether the atmospheric pressure of the last hour is increasing, steady or decreasing.

Increase (> + 1 hPa) Weather improvement

Steady (<1hPa) Stable weather conditions

Decrease (> -1 hPa) Weather deterioration

8. Location and mounting

- When placed outdoors, choose a shady and dry place for the transmitter. Direct sunlight may trigger incorrect measurement and continuous humidity damages the electronic components needlessly.

Wireless Weather Station

• Place the base station in any room of the house. Make sure to avoid the vicinity of any source of interference such as computer screens, TV sets or solid metal objects.
• Once the desired location is chosen, check whether the transmission from the transmitter to the base station is possible (transmission range of up to 100 m in open areas). Within solid walls, especially ones with metal parts, the transmission range can be reduced considerably.
• If necessary, choose, another position for the outdoor transmitter and/or receiver.
• If the transmission is successful, you can place or wall mount the base station and the outdoor transmitter with the suspension device.

9. Battery replacement

• As soon as the battery symbol will appear on the outdoor values display of the base station or on the display of the outdoor transmitter, change the batteries of the outdoor transmitter.
• Change the batteries of the base station, when the battery symbol appears on the indoor values display.

• Please note:

When the batteries are changed, the contact between the transmitter and the receiver must be restored — so always insert new batteries into both devices or start the manual search for the transmitter.

10. Additional outdoor transmitters (optional)

• When having more than one external transmitter (max. 3), select a different channel for each one with the 3 2 1 switch inside the transmitter's battery compartment. Insert two new AAA 1.5 V batteries, polarity as illustrated. Start the base station operation or the manual search for the outdoor transmitter:
• Choose the respective channel by pressing the CHANNEL button.
• Press and hold the CHANNEL button for three seconds. The last registered transmitter (channel) will be cancelled and the manual search begins.
• The outdoor values and the channel number will be shown on the base station display. If you have installed more than one outdoor transmitter, press the CHANNEL button on the base station to change between the channels 1 to 3.
• You can also choose an alternating channel display. Press the CHANNEL button. After the last registered channel (1 to 3) a circle symbol will appear.

Wireless Weather Station

• To deactivate the function press the CHANNEL button again.
  • After a successful installation close the transmitters battery compartments carefully.

11. Troubleshooting

Problem Solution

No display on the base station/transmitter
→ Ensure the batteries' polarities are correct
→ Change the batteries
No transmitter reception – Display “- -” or channel 1/2/3
→ No transmitter installed
→ Check the outdoor transmitter's batteries (only use batteries/rechargeable batteries with 1.5V voltage!)
→ Restart the transmitter and the base station according to the manual
→ Start the outdoor transmitter manual search
→ Choose another place for the outdoor transmitter and/or the base station
→ Reduce the distance between the outdoor
transmitter and the base station
→ Check if there is any source of interference

Indication: LL,L / HH,H

→ Temperature is outside measuring range

Incorrect indication

→ Change the batteries

If your device fails to work despite these measures, please contact the retailer where you purchased the product from for advice.

12. Waste disposal

This product and its packaging have been manufactured using high-grade materials and components which can be recycled and reused. This reduces waste and protects the environment. Dispose of the packaging in an environmentally friendly manner using the collection systems that have been set up.

Disposal of the electrical device

Remove non-permanently installed batteries and rechargeable batteries from the device and dispose of them separately.

This product is labelled in accordance with the EU Waste Electrical and Electronic Equipment Directive (WEEE).

Wireless Weather Station

This product must not be disposed of in ordinary household waste. As a consumer, you are required to take end-of-life devices to a designated collection point for the disposal of electrical and electronic equipment. In order to ensure environmentally-compatible disposal. The return service is free of charge. Observe the current regulations in place!

Never dispose of empty batteries and rechargeable batteries with ordinary household waste. They contain pollutants which, if improperly disposed of, can harm the environment and human health. As a consumer, you are required by law to take them to your retail store or to an appropriate collection site depending on national or local regulations in order to protect the environment. The return service is free of charge. The symbols for the contained heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead.

13. Specifications

Measuring range indoor

Temperature -10 °C... +50 °C (14...122°F)

GB

Humidity 20...95 %rH

Measuring range outdoor

Temperature -20 °C... +60°C (-4 °F ... 140 °F)

Humidity 20...95%rH

Accuracy temperature ±1°C (0 °C...+40°C), otherwise ±2°C

Accuracy humidity ±5%@25°C (40%...80% rH)

Range max. 100 m (open field)

Transmission frequency 433 MHz

Maximum

radio-frequency power < 10mW

Power consumption

Base station:

Batteries 2 x 1.5 V AAA (not included)

Outdoor transmitter:

Batteries 2 x 1.5 V/AM (not included)

We recommend Alkaline batteries

Wireless Weather Station

Base station

Dimensions 94x20(58)x105 (101) mm

Weight 109 g (device only)

Outdoor transmitter

Dimensions 45 x 20 x 102 mm

Weight 43 g (device only)

No part of this manual may be reproduced without written consent of TEA Destmann. The technical data are correct at the time of going to print and may change without prior notice.

The latest technical data and information about this product can be found in our homepage by simply entering the product number in the search box.

EU Declaration of conformity

Hereby, TFA Dostmann declares that the radio equipment type 35.1168 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.tia-dostmann.de/service/downloads/co

www.tla-dostmann.de

E-Mail: [e-mail]

www.fla-dostmann.de/service/downloads/ce

www.lfa-dosimann.de

E-Mail: [e-mail]

Zum Ottersberg 12. 97877 Wertheim, Alemania

12/23

Fig. 4
Wettersymbole / Weather symbols / Symboles météo / Simboli meteorologici / Weersymbolen / Símbolos meteorológicos

sunny slightly cloudy cloudy rainy

ensoleillé partiellement nuageux nuageux pluvieux