IKEA STYRBAR - Lighting

STYRBAR - Lighting IKEA - Free user manual and instructions

Find the device manual for free STYRBAR IKEA in PDF.

📄 64 pages English EN Download 💬 AI Question 10 questions ⚙️ Specs
Notice IKEA STYRBAR - page 4
Pick your language and provide your email: we'll send you a specifically translated version.
Product Type Smart lighting remote control
Brand IKEA
Model STYRBAR (E2001 stainless steel / E2002 white)
Power supply 2 AAA/HR03 batteries (recommended: IKEA LADDA 900, 1.2 V, 900 mAh Ni-MH)
Battery life Approximately 2 years under normal use
Range 10 m in free field
Operating frequency 2405 – 2480 MHz
Output power 12.6 dBm (EIRP)
Protection rating IP44
Operating temperature 0 °C to 40 °C
Main functions On/off, dimming, change white spectrum / colors
Pairing Press the pairing button 4 times within 5 seconds (within 5 cm of the source)
Max number of pairable sources 10 light sources per remote control
Remote control reset Press the pairing button 4 times within 5 seconds
Light source reset Turn the main switch on/off 6 times
Synchronization Press and hold < or > to return to default setting (2700K)
Compatibility IKEA DIRIGERA or TRÅDFRI gateway, IKEA Home smart app
Cleaning Soft cloth slightly dampened with mild detergent, wipe and dry
Safety Indoor use only, do not expose to direct sunlight or heat source
Replaceable batteries Yes, by user (accessible battery compartment)

Frequently Asked Questions - STYRBAR IKEA

How to pair the STYRBAR remote control with a light source?
Place the remote control within 5 cm of the light source, then press the pairing button 4 times within 5 seconds. The light source flashes once to confirm pairing. You can repeat the operation for up to 10 sources.
What to do if the remote control stops responding?
Reset the remote control by pressing the pairing button 4 times within 5 seconds. If the problem persists, check the batteries and replace them if necessary.
How to replace the batteries of the STYRBAR remote control?
Open the battery compartment cover on the back of the remote control. Replace the two batteries with new AAA/HR03 batteries (recommended: IKEA LADDA 900 1.2 V). Observe polarity.
Why does the red LED flash when I press a button?
This means the batteries are low and need to be replaced. The remote control will still work for a while, but it is advisable to change them promptly.
Can I use the STYRBAR remote control with the DIRIGERA gateway?
Yes, the STYRBAR remote control is compatible with the DIRIGERA gateway (as well as the TRÅDFRI). Use the IKEA Home smart app to configure and control your devices.
How to adjust brightness with the remote control?
To increase brightness, press and hold the on button (the top button). To decrease brightness, press and hold the off button (the bottom button). A short press turns the light on or off.
How to change color or color temperature?
Use the left (<) and right (>) buttons to browse different shades of white or colors, depending on the capabilities of your light source.
What is the maximum range of the STYRBAR remote control?
The range is 10 meters in free field. Obstacles (walls, furniture) may reduce the range.
Is the STYRBAR remote control waterproof?
No, it is designed for indoor use only. Its IP44 rating protects against water splashes, but it must not be immersed or exposed to rain.
How to clean the STYRBAR remote control?
Wipe it with a soft cloth slightly dampened with mild detergent, then dry it with a clean, dry cloth. Never use abrasive products or solvents.

User questions about STYRBAR IKEA

0 question about this device. Answer the ones you know or ask your own.

Ask a new question about this device

The email remains private: it is only used to notify you if someone responds to your question.

No questions yet. Be the first to ask one.

Download the instructions for your Lighting in PDF format for free! Find your manual STYRBAR - IKEA and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. STYRBAR by IKEA.

USER MANUAL STYRBAR IKEA

natural_image Simple line drawing of a rounded rectangular device with circular and directional symbols on both sides (no text or labels)

IKEA STYRBAR - 1

Design and Quality IKEA of Sweden

English 4 Svenska 36
Deutsch 8 Español 40
Français 12 Portugues 44
Nederlands 16 Ελληνικά 48
Dansk 20 Türkçe 52
Íslenska 24 عربى 56
Norsk 28 Italiano 60
Suomi 32

English

IKEA STYRBAR - English - 1

For Apple devices, download the app using the App Store. For Android devices, download the app using Google Play store.

Note: If you have a TRÄDFRI gateway please use IKEA Home smart 1 app

Getting started with DIRIGERA hub

Download the IKEA Home smart app and follow the instructions on screen to add the product to your IKEA Home smart system.

Remote control functions

IKEA STYRBAR - Remote control functions - 1

Short press to turn on. To dim up, press and hold the button.

IKEA STYRBAR - Remote control functions - 2

Short press to turn off. To dim down, press and hold the button.

IKEA STYRBAR - Remote control functions - 3

Change white spectrum or colours.

IKEA STYRBAR - Remote control functions - 4

Pairing: Add IKEA Smart Lighting products to your system. See instructions below.

Adding devices to your remote control

When the remote control is sold together with a light source (in the same package), they are already paired. If the remote control is purchased separately, you must manually pair it to your light source.

To add light sources, just repeat the steps below.

  1. Make sure that your light source is installed and the main power switch is turned on.
  2. Hold the remote control close to the light source you want to add (no more than 5 cm away).
  3. Press the pairing button 54 times within 5 seconds. A red light will shine steadily on the remote control. Your light source will begin to dim and flash one time to indicate that it has been successfully paired.

Up to 10 light sources can be paired with 1 remote control. Make sure to pair them one at a time. If the light sources are close to each other, disconnect those that have already been paired from the main power switch.

Factory reset your devices For light sources:

Toggle the main switch 6 times.

For remote control:

Press the pairing button 4 times within 5 seconds.

Synchronizing

If your light source becomes unsynchronized, a long press on the left (<) or right (>) buttons will return the light source to its default setting (2700K).

Changing the battery

When the remote control is used regularly and as intended, the batteries will last for approximately 2 years.

When it's time to replace the battery, a red LED indicator will flash when you press any button on the remote control.

Open the battery lid and replace the battery with two new AAA/HR03 batteries.

Caution!

Risk of explosion if battery is replaced by an incorrect type.

Dispose of used batteries according to the instructions.

Important!

  • The remote control is for indoor use only and can be used in temperatures ranging from 0°C to 40°C.
  • Do not leave the remote control in direct sunlight or near any heat source, as it may overheat.
  • The range between the remote control and the receiver are measured in open air.
  • Different building materials and placement of the units can affect the wireless connectivity range.

Care instructions

To clean the remote control, wipe with a soft cloth moistened with a little mild detergent. Use another soft, dry cloth to wipe dry.

Note!

Never use abrasive cleaners or chemical solvents as this can damage the product.

2 x IKEA LADDA 900 (AAA/HR03, 1.2V, 900mAh, Ni-MH) (Not included)

Do not mix batteries of different capacities, types or date stamps.

TECHNICAL DATA

Type: E2001

Name: STYRBAR Remote control stainless

Type: E2002

Name: STYRBAR Remote control white

Input: 3V, 2x AAA/HR03 LADDA batteries

Range: 10 m in open air.

For indoor use only

Operating frequency: 2405-2480 MHz

Output power: 12.6 dBm (EIRP)

IP-class: IP44

Manufacturer: IKEA of Sweden AB

Address: Box 702, SE-343 81 Älmhult, SWEDEN

Declaration of Conformity

Hereby, IKEA of Sweden AB declares that the radio equipment type E2001/E2002 is in compliance with Directive 2014/53/EU.

The full text of the EU declaration of conformity can be found at http://www.ikea.com

  • Choose the country you are in
  • Search your product in the search field
  • Go to Assembly Instructions and Manuals (downloads) Here will you find a pdf file of the full DoC.

IKEA STYRBAR - Declaration of Conformity - 1

The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or landfill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.

Deutsch

IKEA STYRBAR - Deutsch - 1

Fabricant : IKEA of Sweden AB

Adresse : Box 702, SE-343 81 Älmhult, SUÈDE

Producent: IKEA of Sweden AB

Adresse: Box 702, SE-343 81, Älmhult, SVERIGE

Framleiðandi: IKEA of Sweden AB

Heimilisfang: Box 702, SE-343 81 Älmhult, SWEDEN

Samræmisyfirlýsing

Produsent: IKEA of Sweden AB

© Inter IKEA Systems B.V. 2020

AA-2251005-4

Manual assistant
Powered by Anthropic
Waiting for your message
Product information

Brand : IKEA

Model : STYRBAR

Category : Lighting