537008 - Juicer Emga - Free user manual and instructions

USER MANUAL 537008 Emga

The unit is not for hot beverage serving.

Do not immerse the base in water.

Do not leave or drop beverage onto the top of the base or it may cause malfunction of the unit.

Do not block the Venting Holes at the back of the base, or drop beverage or dirt into the holes as it may cause malfunction of the unit.

Place the unit in an upright position on a at surface.

Make sure the power is cut o󰀨 before cleaning.

This appliance must be earthed and is for indoor use only.

Product Disposal: Dispose in accordance with any local and national disposal regulations relating to the reuse, recovery and recycling of waste electrical and electronic equipment (WEEE ).

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their saftey.

Children should be supervised to ensure that they do not play with the unit.537008 G23M 6 ENGLISH Product Drawing Diagram 1 Adapter Venting Holes Top of the Base Green Light Strainer Drip Tray Power On/Off Switch Cover Faucet Power Cord PC Container Comparisons between Electric and Traditional Beverage Dispenser Diagram 2 17°

Minute Test area: at the bottom of the PC container Room temperature: 25°C TraditionalBeverage Dispenser (with Ice Tube

ElectricBeverageDispenser The Strengths of Electric Beverage Dispenser

Economical and safe as it only consumes 60w / hour, DC12v.

Save space as no need to have ice tube to contain ice.

Convenient, hygienic and save cost as it keeps cool automatically, no need to rell ice.537008 G23M 7 ENGLISH How to Use

1. Electric Beverage Dispenser is equipped with PN Junction Semi conductor to steadily

keep beverage cool for a long time.

2. To enable the dispenser to perform properly, it is necessary that the dispenser should

be lled with cold or refrigerated beverage.

3. When the dispenser is plugged in, the voltage 220 - 240vac will be converted to low

voltage DC12v through the Adapter.

4. When the Power On/O󰀨 Switch is turned on in “I” position, the Green Light is on and

the dispenser starts keeping the beverage cool.

5. When the Power On/O󰀨 Switch is turned o󰀨 in “0” position, the Green Light is o󰀨 and

the Dispenser stops keeping the beverage cool How to Clean

1. Before cleaning, turn o󰀨 the Power On/O󰀨 Switch to “0” position and unplug the unit.

2. Remove the Cover, the PC Container, Strainer and Drip Tray, wash them with clean,

soapy water using a mild detergent. Rinse thoroughly with clean water. Dry them completely before assembling the unit.

3. For the outer surface of the Base, only wipe it over with a damp cloth using a mild

Minute Test area: at the bottom of the PC container Room temperature: 25°C TraditionalBeverage Dispenser (with Ice Tube

Minute Test area: at the bottom of the PC container Room temperature: 25°C TraditionalBeverage Dispenser (with Ice Tube