REMINGTON Durablade Hybrid Groomer MB055 - Beard trimmer

Durablade Hybrid Groomer MB055 - Beard trimmer REMINGTON - Free user manual and instructions

Find the device manual for free Durablade Hybrid Groomer MB055 REMINGTON in PDF.

📄 88 pages English EN Download 💬 AI Question 10 questions ⚙️ Specs
Notice REMINGTON Durablade Hybrid Groomer MB055 - page 3
Pick your language and provide your email: we'll send you a specifically translated version.
Product type Beard trimmer
Brand Remington
Model Durablade Hybrid Groomer MB055
Power source Rechargeable via USB, mains adapter included
Battery life Up to 60 minutes
Charging time 4 hours
Cutting guides included 4 combs: 1, 2, 4, 6 mm
Blades Interchangeable blade head, stainless steel
Usage Dry or with shaving gel, can be used in the shower/bath
Cleaning Rinse with hot water after use, lubricate blades regularly
Safety Not suitable for children under 8 without supervision; unplug before cleaning
Included accessories USB cable, USB adapter, travel case

Frequently Asked Questions - Durablade Hybrid Groomer MB055 REMINGTON

How to charge the Durablade Hybrid Groomer trimmer?
Make sure the device is turned off. Connect the USB cable to the trimmer and to the provided mains adapter or a powered USB port. The LED indicator shows charging: it stays on during charging, flashes quickly when battery is low, and turns off when fully charged.
How long does a full charge last?
The full charging time is 4 hours. The battery life can reach 60 minutes of use.
Can I use the trimmer in the shower?
Yes, the device can be used in the bathtub or shower. After use with shaving gel, rinse the blade with hot water.
How to install the cutting guides?
Select the cutting guide of the desired length. Position it on the upper part of the blade and push gently until it clicks. To remove, pull it upwards.
How to clean the trimmer?
After each use, remove the guide and blade head if necessary. Rinse the blade under hot water to remove hair and residue. Dry thoroughly. Lubricate the blades with a few drops of oil (sewing machine oil) and wipe off excess.
How to replace the blade head?
To remove the blade head, rotate it counterclockwise and separate it from the body. To reattach, place it on the body and rotate it clockwise until it locks.
Can I use the trimmer with shaving gel?
Yes, you can apply shaving gel to your beard and trim as dry. After use, rinse the blade thoroughly with hot water to remove any gel residue.
How to get a close shave without a guide?
For a clean-shaven look, use the trimmer without a cutting guide. Place the flat top of the blade against the skin and slide it slowly against the direction of hair growth.
What if the trimmer does not turn on?
Check that the battery is charged. Plug it into the charger for at least 4 hours. If the LED indicator does not light up, the cable or adapter may be faulty. Contact customer service.
How to maintain the blades for peak performance?
Clean the blades after each use and lubricate them regularly with sewing machine oil. Wipe off excess. This extends the life and ensures optimal cutting.

User questions about Durablade Hybrid Groomer MB055 REMINGTON

0 question about this device. Answer the ones you know or ask your own.

Ask a new question about this device

The email remains private: it is only used to notify you if someone responds to your question.

No questions yet. Be the first to ask one.

Download the instructions for your Beard trimmer in PDF format for free! Find your manual Durablade Hybrid Groomer MB055 - REMINGTON and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Durablade Hybrid Groomer MB055 by REMINGTON.

USER MANUAL Durablade Hybrid Groomer MB055 REMINGTON

Official Electrical Styling Partner of Manchester United

Durablade Hybrid Groomer

REMINGTON Durablade Hybrid Groomer MB055 - Durablade Hybrid Groomer - 1

natural_image Black and gray Remington brand hairbrush with circular head and silver handle (no text or symbols visible)

MB055

2 1 4 5

REMINGTON Durablade Hybrid Groomer MB055 - Durablade Hybrid Groomer - 3

natural_image Four-panel diagram showing a mechanical component being rotated, with arrows indicating motion direction (no text or symbols)

Thank you for buying your new Remington® product. Please read these instructions carefully and keep them safe. Remove all packaging before use.

REMINGTON Durablade Hybrid Groomer MB055 - Durablade Hybrid Groomer - 4

IMPORTANT SAFEGUARDS

- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.

Suitable for use in a bath or shower.

  • Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres.
  • Do not leave the appliance unattended while plugged in except when charging.
  • Do not use attachments other than those we supply.
  • Do not use the appliance if it is damaged or malfunctions.
  • Do not plug or unplug the appliance with wet hands.
  • This appliance is not intended for commercial or salon use.

PARTS

  1. On/Off switch
  2. Blade
  3. LED charging indicator
  4. USB charging cable

Not shown:

  • Combs (1, 2, 4, 6mm)
  • USB adapter
  • Travel pouch

GETTING STARTED

CHARGING YOUR APPLIANCE

It is recommended to fully charge your appliance before using for the first time. Please refer to the charge times shown in this book.

  • Ensure the product is switched off.
  • Connect the product to the USB cable. Connect the other end of the cable to the supplied USB adapter or to a powered USB port.

CHARGE LEVEL INDICATORS

Charge Level Indicator
Charging LED shows solid
Low charge LED flashes rapidly
Full charge LED will turn off
  • Run time from fully charged is up to 60 minutes.
  • Charge time from empty is 4 hours.

Note: To preserve the life of your batteries, let them run out every 6 months then fully charge.

INSTRUCTIONS FOR USE

Switch the product on by pressing the On/Off switch.

Always comb your beard or moustache with a fine comb before you start trimming.

CHANGING BLADE HEADS

  1. To remove a blade head, twist it anticlockwise and pull it away from the body.
  2. To refit, place the blade on to the body and twist it clockwise until it locks.

ATTACHING AND REMOVING THE COMBS

  1. Select the desired trimming length comb. Place the comb over the top of the blade and gently push this down onto the blade until it clicks into place.
  2. To remove the comb, grasp the comb and pull firmly upwards and away from the groomer.

TO TRIM THE BEARD

  1. Select your desired trimming length comb. If you are trimming for the first time start with the maximum trimming length setting.
  2. Turn the unit on.
  3. Place the flat top of the fixed comb against the skin.
  4. Slowly slide through the hair. Repeat from different directions as necessary.
  5. If hair builds up in the trimmer comb during the trimming process, switch the unit off, pull off the comb and brush the hair off.

TO GET A SHAVEN LOOK

To trim any length of beard or stubble hair for a clean, shaven look then follow the above steps without a comb attached to the blade head.

Place the flat top of the blade against the skin and slowly slide through the hair against the direction of growth.

TRIMMING AND EDGING

  1. Hold the groomer with the back side of the blade facing you with no combs attached.
  2. Start with the blades resting lightly against your skin, use motions towards edge of beard line to trim to desired locations in facial area.
  3. Shape as desired.

TRIMMING WITH SHAVING GEL

Follow the same instructions as dry shaving if using shaving gel.

Caution: After use with shaving gel, please rinse the blade under warm water to clean away any excess gel and debris.

To ensure long lasting performance of the groomer, clean after each use.

The easiest and most hygienic way to clean the groomer is by rinsing the head under the tap after use while the blades are running.

To keep the unit in optimal condition we recommend re-oiling the blades after cleaning.

Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.

BATTERY REMOVAL

The battery must be removed from the appliance before it is scrapped.

The appliance must be disconnected from the supply mains when removing the battery.

  1. Ensure the trimmer is discharged of all power.
  2. Remove the comb attachment.
  3. Detach the blade head.
  4. Pry off the bottom gap below the grips.
  5. Press in exposed tabs and pull internal frame out.
  6. Disconnect the battery from the circuit board and internal frame.
  7. The battery is to be disposed of safely.

RECYCLING

REMINGTON Durablade Hybrid Groomer MB055 - RECYCLING - 1

To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/collection point.

REMINGTON Durablade Hybrid Groomer MB055 - RECYCLING - 2

UW APPARAAT VERZORGEN

FÖR ATT TRIMMA SKÄGGET

natural_image Solid gray rectangular shape with no text, symbols, or discernible features

Model No. MB055

Type No. MB12A

Remington ^® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries

VARTA Consumer Batteries GmbH & Co. KGaA, Alfred-Krupp-Str. 9, 73479 Ellwangen, Germany www.remington-europe.com

Manual assistant
Powered by Anthropic
Waiting for your message
Product information

Brand : REMINGTON

Model : Durablade Hybrid Groomer MB055

Category : Beard trimmer