AR353 - Fireplace ARDES - Free user manual and instructions

USER MANUAL AR353 ARDES

EN - This product is only suitable for well insulated spaces or occasional use.

Diagram of a device with an internal fan-like structure and directional arrows, enclosed in a rectangular frame (no text or symbols)

IT

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision.

Children of less than 3 years should be kept away unless continuously supervised.

Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.

CAUTION — Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.

If the power cable gets damaged, it has to be replaced only at a service centre approved by the manufacturer.

WARNING: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.

WARNING: Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.

DO NOT COVER

WARNING: In order to avoid overheating, do not cover the heater.

Do not place the appliance immediately below a socket outlet.

Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.

Warnings

GB

ATTENTION : read this booklet carefully it contains important instructions for a safe installation, use and maintenance. Important instructions to be kept for future reference.

Keep handy the guarantee, receipt of payment and these instructions for future use and reference.

After removing the packaging, check the appliance for any signs of damage.

In case of visible damage, do not use it and contact a qualified technician. Do not leave parts of the packaging with in the reach of children. This appliance is not a children's toy: it is an electrical device and must be treated with the necessary caution.

Before connecting the appliance, make sure that the power supply voltage matches the indication on the data plate.

If the plug and socket are not compatible, the socket has to be replaced with a suitable type by skilled persons.

Do not use adapters or extension cables which do not meet current safety standards or that exceed the current carrying capacity limits.

When you don't use the appliance disconnect it from the power supply and assure that the interruptor is off.

Do not tug on the power cable or on the appliance itself to remove the plug from the socket.

The use of any electrical appliance requires that a number of basic rules are observed, namely:

• Never touch the appliance with wet or humid hands.
• Do not leave the appliance exposed to weathering (rain, sunlight).
• Do not subject it to rough handling.

In case of a breakdown or malfunctioning of the appliance, disconnect it at once.

Do not attempt to repair it, but take it to a service centre approved by the manufacturer.

If you decide you do not want to use this appliance any longer, disable it by cutting the power cable - of course, after disconnecting it from the socket.

The power cable should be extended to its full lenght to avoid over heating.

For safety reasons, the appliance should never be opened.

The appliance has been designed and manufactured to operate in the home.

Any other use is considered inappropriate and dangerous.

Do not insert objects through the safety grill or the air inlets.

During use, rest the appliance on a flat surface.

Do not use this heating appliance with programmers, timers, separate remote control systems (different to the ones provided with the appliance) or any other device that automatically turns on the appliance, as there is a risk of fire in the event the appliance is covered or positioned incorrectly. Do not use the heater in presence of flammable substances (petrol, paints, etc.).

Do not place the cord near sources of heat.

WARNING: DO NOT COVER THIS PRODUCT NEAR CURTAINS OR OTHER COMBUSTIBLE MATERIAL.

WARNING: DO NOT COVER THE APPLIANCE OR OBSTRUCT THE AIR INLETS TO AVOID OVERHEATING.

Technical informations

GB

1 - Ventilation grid.
2 - Dimmer
3 - Function switch

4 - Adjusting the thermostat.
5 - Lamp compartement (behind the appliance)

Technical data indicated on the appliance.

Before connecting or disconnecting the appliance, make certain the function selector is in the OFF position.

To turn the appliance on, insert the plug in the power outlet, place the switch on ON and then select the low (I) or high (II) heating switch.

The heating switches are not independent, so in order for the appliance to operate at the highest heating power, the switch I must also be activated.

All the switches have an indicator light which turns on when the switches are ON.

max min Dimming ON OFF I II Temp Adj max min

The appliance is equipped with a thermostat which is adjustable (Temp Adj) only when the appliance is operating at the maximum power with both the switches in the ON position. When the thermostat intervenes the appliance continues to operate at half power until the room temperature drops enough to restart the flow of hot air at maximum power.

The regulator (Dimming) can be used to adjust the luminosity of the aesthetic front panel.

Before replacing the appliance in its package, make sure it has cooled sufficiently.

Maintenance

GB

Disconnect the plug from the socket and let the appliance cool down well before cleaning it.

This appliance does not require any special maintenance.

In order to clean the appliance, use a soft or slight damp cloth.

Never use abrasives or chemical solvents.

Do not use very wet substances, liquids or cloths to prevent water from entering into the appliance and irreparably damaging it.

NEVER IMMERSE THE APPLIANCE INTO THE WATER.

Replacing the lamps.

Unscrew the two screws clamping the panel located on the lower back part of the appliance.

Replace the lamp which is not working with another having the same technical characteristics indicated on the same.

Close the panel correctly.

Diagram of a device with a light bulb inside a rectangular frame, showing no text or symbols.

EN

Information requirements for electric local space heaters - REGULATION (EU) 2015/1188
Model identifier(s): AR353
Item	Symbol	Value	Unit	Item	Unit
Heat output				Type of heat input, for electric storage local space heaters only (select one)
Nominal heat output	P_nom	1,8-2,0	kW	manual heat charge control, with integrated thermostat	N.A.
Minimum heat output (indicative)	P_max	1,0	kW	manual heat charge control with room and/or outdoor temperature feedback	N.A.
Maximum continuous heat output	P_maxc	2,0	kW	electronic heat charge control with room and/or outdoor temperature feedback	N.A.
Auxiliary electricity consumption				fan assisted heat output	N.A.
At nominal heat output	el_max	N.A.	kW	Type of heat output/room temperature control (select one)
At minimum heat output	el_min	N.A.	kW	single stage heat output and no room temperature control	no
In standby mode	el_su	0,000	kW	Two or more manual stages, no room temperature control	no
				with mechanic thermostat room temperature control	yes
				with electronic room temperature control	no
				electronic room temperature control plus day timer	no
				electronic room temperature control plus week timer	no
				Other control options (multiple selections possible)
				room temperature control, with presence detection	no
				room temperature control, with open window detection	no
				with distance control option	no
				with adaptive start control	no
				with working time limitation	no
				with black bulb sensor	no
Contact details	POLY POOLS p.A. - via Sottocorna 21/B, 24020 Parre (BG) - Italy

FR

max dimming ON OFF I II Temp Adj max min

Simple line drawing of a device with a bulb inside, mounted on a base with supports (no text or symbols)

FR

Prohibition sign with a diagonal line crossing over a document icon, indicating no text or document.

NICHT ABDECKEN

Diagram of a device with a light bulb inside a container, showing internal components and directional arrows (no text or symbols)

DE

max dimming ON OFF I II Temp Adj max min

Simple line drawing of a device with an internal fan or bulb, mounted on a base with mounting points (no text or symbols)

ES

max dimming ON OFF I II Temp Adj max min

Simple line drawing of a device with a central fan and base, no text or symbols present

HU

Diagram of a device with an internal fan-like structure and labeled ports (no text or symbols)

CS

max dimming ON OFF I II Temp Adj max min

Terms and Conditions

The guarantee is valid for 24 months.

This guarantee applies only if it has been duly filled in and is submitted with the receipt showing the date of purchase.

The guarantee covers the replacement or repair of parts making up the appliance which were faulty at source due to manufacturing faults.

After the guarantee has expired, the appliance will be repaired against payment.

The manufacturer declines any responsibility for damage to persons, animals or property due to misuse of the appliance and failure to observe the directions contained in the instructions.

Limits

All rights under this guarantee and any responsibility on our part will be voided if the appliance has been:

- mishandled by unauthorized persons

- improperly used, stored or transported.

The guarantee does not cover damage to the outward appearance or any other that does not prevent regular operation.

If any faults should be found despite the care taken in selecting the materials and in creating the product, or if any information or advice are required, please contact your local dealer.

USER INFORMATION

“Implementation of Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE)”, pertaining to reduced use of hazardous substances in electrical and electronic equipment, as well as to waste disposal”.

The symbol of the crossed-out wheelie bin on the equipment or on its packaging indicates that the product must be disposed of separately from other waste at the end of its service life.

The user must therefore take the dismissed equipment to suitable separate collection centres for electrical and electronic waste, or return it to the dealer in case they purchase a new device of equivalent type, at a one-to-one-ratio.

Suitable segregated collection of the equipment for subsequent recycling, treatment or environmentally-friendly disposal helps prevent damage to the environment and to human health, and encourages the re-use and/or recycling of the materials that make up the equipment.

Abusive disposal of the product by the user shall result in the application of administrative fines in accordance with the laws in force.

Conditions