WG411J5U - Uncategorized Atag - Free user manual and instructions

USER MANUAL WG411J5U Atag

• This appliance is only designed for household use.

• CAUTION: Accessible parts may become hot when used with cooking appliances.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

• Do not allow children to play with the appliance.

• Do not allow children to clean or maintain the appliance unless supervised.

• Always provide adequate ventilation!

• There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels.

• When the range hood and appliances supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4 × 10

• Local regulations concerning the discharge of air have to be fulfilled.

• Never use a pressure cleaner or steam cleaner to clean the appliance. ELECTRIC SHOCK! Avoid the risk of electric shock; make sure the appliance is switched off before cleaning the appliance.

• Only use the appliance inside the home.

• Do not use the cooker hood if the grease filter has not been fitted properly!

Safe useCOOKER HOODS EN 4

• Do not lean against the cooker hood.

• Never use the cooker hood as a working surface unless this is indicated explicitly.

• Grease and oil are inflammable when overheated. Remain in the cooking area when preparing meals.

• To prevent hot fat from catching fire, you should only deep-fry under continuous supervision.

• The cooker hood should be cleaned regularly both on the outside as well as the inside (at least 1 x per month). Insufficient cleaning or a delay in the replacement of filters can cause a fire hazard.

• Clean the filters on time.

• The grease filters can become hot during use. After cooking wait at least 30 minutes before cleaning.

• Please note! Intensive use can lead to condensation on the cooker hood. Condensation is simple to remove with a dry cloth.

• Follow the instructions in the manual for cleaning or replacing the grease filters and/or carbon filters! DANGER OF FIRE! There is a risk of fire if the instructions for cleaning or replacing grease filters and/or carbon filters are not followed. Through grease deposits in the metal grease filter. Never work with open flame under the appliance (eg. flambéing). Always use the appliance with the metal grease filter. Clean the grease filter regularly. Through overheated fat or oil. Never extinguish a fire with water; always use a fire blanket, lid or plate.

• The appliance may have sharp edges; please be careful during cleaning.

• The light emitted by LED lights is very dazzling and can damage the eyes. Do not look directly into the switched on LED lights for longer than 100 seconds.

Safe useCOOKER HOODS EN 5

• Do not lean against the cooker hood.

• Never use the cooker hood as a working surface unless this is indicated explicitly.

• Grease and oil are inflammable when overheated. Remain in the cooking area when preparing meals.

• To prevent hot fat from catching fire, you should only deep-fry under continuous supervision.

• The cooker hood should be cleaned regularly both on the outside as well as the inside (at least 1 x per month). Insufficient cleaning or a delay in the replacement of filters can cause a fire hazard.

• Clean the filters on time.

• The grease filters can become hot during use. After cooking wait at least 30 minutes before cleaning.

• Please note! Intensive use can lead to condensation on the cooker hood. Condensation is simple to remove with a dry cloth.

• Follow the instructions in the manual for cleaning or replacing the grease filters and/or carbon filters! DANGER OF FIRE! There is a risk of fire if the instructions for cleaning or replacing grease filters and/or carbon filters are not followed. Through grease deposits in the metal grease filter. Never work with open flame under the appliance (eg. flambéing). Always use the appliance with the metal grease filter. Clean the grease filter regularly. Through overheated fat or oil. Never extinguish a fire with water; always use a fire blanket, lid or plate.

• The appliance may have sharp edges; please be careful during cleaning.

• The light emitted by LED lights is very dazzling and can damage the eyes. Do not look directly into the switched on LED lights for longer than 100 seconds. Safe use

• When washing grease filters in the dishwasher it is recommended to use a short, non-intensive programme. Check the grease filter after washing in the dishwasher for wear (loose material). Wear can occur as a result of frequent washing. If loose material is visible, replace the filters in order to prevent this loose material from ending up in the food that is cooked.

• Do not use the appliance in temperatures below 5 °C.

• Keep a 20 cm separation distance to the appliance.

WARNING! This appliance should only be connected by a registered installer.

• Always follow the installation instructions in the installation manual provided.

• Check the appliance for transport damage. Do not connect a damaged appliance.

• Faulty parts may only be replaced by original parts. The manufacturer can only guarantee that original parts meet safety requirements.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

• Always use the original Supply cord to connect the appliance.

• The electrical connection must comply with national and local regulations.

• The wall plug socket and plug should always be accessible.

• If a stationary appliance is not fitted with a supply cord and a plug, or with other means for disconnection from the supply mains having a contact separation in all poles that provide full disconnection under overvoltage category III conditions, the means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules. This is also applicable for appliances with a supply cord and plug when the plug is not accessible after installing the appliance. Using an omnipolar switch with a contact separation of at least 3 mm fitted in the fixed wiring will fulfil this requirement.

• The appliance should not be connected to the mains via a multi-plug adapter or extension cable, as the safe use of the equipment cannot be guaranteed.

WARNING! This appliance should only be connected by a registered installer.

• Always follow the installation instructions in the installation manual provided.

• Check the appliance for transport damage. Do not connect a damaged appliance.

• Faulty parts may only be replaced by original parts. The manufacturer can only guarantee that original parts meet safety requirements.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

• Always use the original Supply cord to connect the appliance.

• The electrical connection must comply with national and local regulations.

• The wall plug socket and plug should always be accessible.

• If a stationary appliance is not fitted with a supply cord and a plug, or with other means for disconnection from the supply mains having a contact separation in all poles that provide full disconnection under overvoltage category III conditions, the means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules. This is also applicable for appliances with a supply cord and plug when the plug is not accessible after installing the appliance. Using an omnipolar switch with a contact separation of at least 3 mm fitted in the fixed wiring will fulfil this requirement.

• The appliance should not be connected to the mains via a multi-plug adapter or extension cable, as the safe use of the equipment cannot be guaranteed. Installation

WARNING! Extraction hoods and other appliances that extract cooking vapours can affect the safe operation of appliances that burn gas or other fuel (including those in other rooms) by backflowing combustion gases. These gases can potentially lead to carbon monoxide poisoning. After installing an extraction hood or other vapour extractor, the operation of appliances with flue gas extraction must be tested by a competent person to ensure that the combustion gases do not flow back. WARNING! Never open the casing of the appliance.

• Disconnect the appliance from the mains supply before starting any repair work.

• We advise you to wear protective gloves when assembling the cooker hood because of the possible sharp edges.

• The distance between the lowest point of the cooker hood and the supporting surface for the cooking vessels gas hob should be at least 65 cm.

• If the instructions of the gas hob specify a greater distance, this has to be taken into account. WARNING! Failure to install screws or fixing devices in accordance with these instructions may result in an electrical hazard. If the safety instructions and warnings are not followed, the manufacturer cannot be held responsible for any resulting damage. If you decide to discontinue using the appliance because of a fault, we recommend you cut off the cable after removing the plug from the plug socket. Take the appliance to your municipality’s waste disposal site.

Place the appliance in an environment that meets the following conditions:

• Ambiant temperature range: +5….+40 °C;

• Humidity: 30….70% RH;

• Maximum altitude: 2000 meters above sea level.