WK 20 - Kettle STEBA - Free user manual and instructions

USER MANUAL WK 20 STEBA

Attention! Device gets hot. Danger of burns! Dur- ing operation, steam escapes the devices. ∙ If an extension cable is used, it has to have a cross-section of 1,5mm²11 ∙ If a GS-tested 16 A multi-pin extension is used, it may not be charged with more than 3680 watts due to fire hazard. ∙ Make sure that children do not tease the cable or that a trip hazard occurs. ∙ The device must always be disconnected from the power supply if it is not supervised and before assembling, disassembling or cleaning. ∙ Do not use the device for cooking on a cooktop. Cleaning ∙ Attention! Pull the plug before cleaning and allow the device to cool down. ∙ Never immerse the unit into water. ∙ Do not use abrasives, oven spray or solvents. ∙ Clean the housing with a damp cloth with detergent and dry. Occasionally rinse with clean water. ∙ To clean the particle filter, take it out of the device. ∙ Superficial stains on the heating plate can be removed with stainless steel cleaner. ∙ Depending on the hardness of water, the device needs to be scaled regularly. To do this, fill the kettle with water and des- caler or vinegar. Heat the mixture and then rinse the device with fresh water. Workplace Important: Never place this device on or next to hot surfaces (e.g. hot stoves). Only use it on a even, stable and a heat resisting surface. It is im- portant that no inflammable items are near to the device. Do not place the device on the edge of the table so that it cannot be touched by children or fall down when touched. Make sure that the ON/OFF switch is not blocked by any objects. The device may overheat and destroy itself.12

Getting started ∙ Unwind the cable from the cable storage und plug it in. ∙ Open the lid, fill the device with water and close the lid.