Durablade MB010 - Shaver REMINGTON - Free user manual and instructions

Brand	Remington
Model	Durablade MB010
Category	Shaver
Power Source	Rechargeable via USB
Charging Time	12 hours
Runtime	Up to 40 minutes
Included Comb Guides	1 mm, 2 mm, 4 mm
Precision Blade	Yes, for contours
Wet Use	Yes, water resistant
Cleaning	Rinse with warm water
Lubrication	Sewing machine oil recommended
On/Off Button	Yes
Charging Indicator Light	Yes
Battery Type	Built-in rechargeable battery
Battery Removal	Possible before disposal
Recycling	Do not dispose of with household waste
Child Safety	Do not leave unattended while plugged in
Included Accessories	USB cable, comb guides
Commercial Use	Not intended for professional use
Periodic Maintenance	Full discharge every 6 months

Frequently Asked Questions - Durablade MB010 REMINGTON

How long does a full charge last?

A full charge takes about 12 hours.

What is the runtime of the trimmer?

Runtime can reach 40 minutes after a full charge.

Can I use the trimmer in the shower?

Yes, this appliance is designed for use in the bathtub or shower.

How do I clean the trimmer?

After each use, rinse the blade under warm water. For optimal maintenance, lubricate the blades with a few drops of oil.

How many comb guides are included?

The trimmer comes with three combs: 1 mm, 2 mm, and 4 mm.

How do I remove the battery for recycling?

Unplug the appliance, remove the comb guide, detach the blade head, extract the internal structure, and disconnect the battery from the printed circuit board.

Can I use the trimmer with shaving gel?

Yes, you can use shaving gel. Rinse the blade thoroughly with warm water after use.

How do I maintain the battery?

To preserve battery life, let the battery fully discharge every 6 months, then fully recharge it.

What if the appliance does not work?

Check that the appliance is charged and that the on/off button is pressed. If the problem persists, contact consumer service.

Are the blades replaceable?

The manual does not mention replacement parts, but in case of wear, contact Remington consumer service.

USER MANUAL Durablade MB010 REMINGTON

Black and gray Remington 1000 electric toothbrush with no visible text or symbols on body

MB010

Thank you for buying your new Remington® product. Please read these instructions carefully and keep them safe. Remove all packaging before use.

IMPORTANT SAFEGUARDS

- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.

Suitable for use in a bath or shower.

• Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres.
• Do not leave the appliance unattended while plugged in except when charging.
• Do not use attachments other than those we supply.
• Do not use the appliance if it is damaged or malfunctions.
• Do not plug or unplug the appliance with wet hands.
• This appliance is not intended for commercial or salon use.

PARTS

1. On/Off switch
2. Blade
3. Charging connector

4. Charging indicator

5. 1 mm comb

6. 2 mm comb
7. 4 mm comb
8. USB cable (not shown)

GETTING STARTED

CHARGING YOUR APPLIANCE

It is recommended to fully charge your appliance before using for the first time. Please refer to the charge times shown in this book.

• Ensure the product is switched off.

• Connect the product to the USB cable and then connect the USB end of the cable to a powered USB port.

• When fully charged, the charging indicator will come on.

• Run time from fully charged is up to 40 minutes.
• Charge time from empty is 12 hours.
  Note: To preserve the life of your batteries, let them run out every 6 months then fully charge.

INSTRUCTIONS FOR USE

Switch the product on by pressing the On/Off switch.

Always comb your beard or moustache with a fine comb before you start trimming.

ATTACHING AND REMOVING THE COMBS

1. Select the desired trimming length comb. Place the comb over the top of the blade and gently push this down onto the blade until it clicks into place.
2. To remove the comb, grasp the comb and pull firmly upwards and away from the groomer.

TO TRIM THE BEARD

1. Select your desired trimming length comb. If you are trimming for the first time start with the maximum trimming length setting.
2. Turn the unit on.
3. Place the flat top of the fixed comb against the skin.
4. Slowly slide through the hair. Repeat from different directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit off, pull off the comb and brush the hair off.

TO GET A SHAVEN LOOK

To trim any length of beard or stubble hair for a clean, shaven look then follow the above steps without a comb attached to the blade head.

Place the flat top of the blade against the skin and slowly slide through the hair against the direction of growth.

TRIMMING AND EDGING

1. Fit the detail blade.
2. Hold the groomer with the back side of the blade facing you with no combs attached.

3. Start with the blades resting lightly against your skin, use motions towards edge of beard line to trim to desired locations in facial area.

4. Shape as desired.

TRIMMING WITH SHAVING GEL

Follow the same instructions as dry shaving if using shaving gel.

Caution: After use with shaving gel, please rinse the blade under warm water to clean away any excess gel and debris.

To ensure long lasting performance of the groomer, clean after each use.

The easiest and most hygienic way to clean the groomer is by rinsing the head under the tap after use while the blades are running.

To keep the unit in optimal condition we recommend re-oiling the blades after cleaning.

Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.

BATTERY REMOVAL

The battery must be removed from the appliance before it is scrapped.

The appliance must be disconnected from the supply mains when removing the battery.

1. Ensure the trimmer is discharged of all power.
2. Remove the comb attachment.
3. Detach the blade head.
4. Pry off the bottom gap below the grips.
5. Press in exposed tabs and pull internal frame out.
6. Disconnect the battery from the circuit board and internal frame.
7. The battery is to be disposed of safely.

RECYCLING

To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/collection point.

UW APPARAAT VERZORGEN

FÖR ATT TRIMMA SKÄGGET

Solid gray rectangular shape with no text, symbols, or discernible features

Ref. No. MB010

Remington ^® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries

VARTA Consumer Batteries GmbH & Co. KGaA, Alfred-Krupp-Str. 9, 73479 Ellwangen, Germany

www.remington-europe.com