Durablade Pro - Shaver REMINGTON - Free user manual and instructions

Product Type	Electric Shaver / Beard Trimmer
Brand	Remington
Model	Durablade Pro
Power Source	Rechargeable Li-Ion battery via USB cable (adapter included)
Battery Life	Up to 60 minutes
Charging Time	4 hours
Charge Indicator	LED: on during charging, off when charged, flashes when low
Comb Guides	4 combs (1, 2, 4, 6 mm)
Precision Blade	Removable, rotate counterclockwise to remove
Usage	Dry or with shaving gel
Wet Use	Yes, waterproof (can be used in the bath or shower)
Cleaning	Under hot water after each use
Lubrication	Recommended after cleaning (sewing machine oil)
Safety	Do not use if cord damaged; do not leave plugged in unattended
Recycling	Removable battery; dispose of in a proper recycling center
Box Contents	Trimmer, USB cable, USB adapter, 4 comb guides
Main Functions	Beard trimming, close shaving, contour shaping

Frequently Asked Questions - Durablade Pro REMINGTON

How to charge the Remington Durablade Pro?

Make sure the device is off. Connect the USB cable to the device and to the included USB adapter or a live USB port. The LED indicator stays on during charging and turns off when the battery is fully charged (about 4 hours).

How long does the battery last after a full charge?

The battery life can last up to 60 minutes after a full charge. To preserve the battery, let it fully discharge every 6 months, then fully recharge.

Can I use the device in the shower?

Yes, the Durablade Pro trimmer can be used in the bath or shower. It is designed for wet and dry use.

How to clean the blades after use?

After each use, rinse the blade under hot water to remove hair and gel residue. For the blades, it is recommended to lubricate them with a few drops of sewing machine oil after cleaning.

How to change the blade heads?

To remove a blade head, rotate it counterclockwise and lift it off the body. To replace, place it on the body and rotate it clockwise until it locks.

How to use the comb guides?

Select the guide of the desired length (1, 2, 4 or 6 mm). Place it on top of the blade and push until it clicks. To remove, pull it upward. Use the guide by placing it flat against the skin and moving slowly.

What to do if the device does not turn on?

First check that the battery is charged. If the LED indicator flashes quickly, the battery is low. Plug in the device to recharge. Make sure the device is off before plugging in.

How to get a close shave?

For a close shave, do not use a comb guide. Place the flat top of the blade against the skin and glide it slowly in the opposite direction of hair growth.

How to lubricate the blades?

After cleaning, apply a few drops of sewing machine oil to the blades, then wipe off excess. This ensures lasting performance.

How to recycle the battery at end of life?

The battery must be removed before disposal. Open the device by removing the comb guide and blade head. Extract the internal structure, disconnect the battery from the board, and dispose of it at a proper recycling center.

USER MANUAL Durablade Pro REMINGTON

Two black-and-white product photos of a pair of hairbrushes, one with teeth and the other with a textured handle (no text or symbols visible)

MB070

Four-panel diagram showing a car interior with arrows indicating motion, no text or symbols present

Thank you for buying your new Remington ^® product. Please read these instructions carefully and keep them safe. Remove all packaging before use.

IMPORTANT SAFEGUARDS

- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.

Suitable for use in a bath or shower.

• Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres.
• Do not leave the appliance unattended while plugged in except when charging.
• Do not use attachments other than those we supply.
• Do not use the appliance if it is damaged or malfunctions.
• Do not plug or unplug the appliance with wet hands.
• This appliance is not intended for commercial or salon use.

PARTS

1. On/Off switch
2. Blade
3. Combs (1, 2, 4, 6mm) (not shown)

4. LED charging indicator

5. USB charging cable

6. USB adapter (not shown)
7. Detail blade

GETTING STARTED

CHARGING YOUR APPLIANCE

It is recommended to fully charge your appliance before using for the first time. Please refer to the charge times shown in this book.

• Ensure the product is switched off.
• Connect the product to the USB cable. Connect the other end of the cable to the supplied USB adapter or to a powered USB port.

CHARGE LEVEL INDICATORS

Charge Level Indicator

Charging LED shows solid

Low charge LED flashes rapidly

Full charge LED will turn off

• Run time from fully charged is up to 60 minutes.
• Charge time from empty is 4 hours.

Note: To preserve the life of your batteries, let them run out every 6 months then fully charge.

INSTRUCTIONS FOR USE

Switch the product on by pressing the On/Off switch.

Always comb your beard or moustache with a fine comb before you start trimming.

CHANGING BLADE HEADS

1. To remove a blade head, twist it anticlockwise and pull it away from the body.
2. To refit, place the blade on to the body and twist it clockwise until it locks.

ATTACHING AND REMOVING THE COMBS

1. Select the desired trimming length comb. Place the comb over the top of the blade and gently push this down onto the blade until it clicks into place.
2. To remove the comb, grasp the comb and pull firmly upwards and away from the groomer.

TO TRIM THE BEARD

1. Select your desired trimming length comb. If you are trimming for the first time start with the maximum trimming length setting.
2. Turn the unit on.
3. Place the flat top of the fixed comb against the skin.
4. Slowly slide through the hair. Repeat from different directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit off, pull off the comb and brush the hair off.

TO GET A SHAVEN LOOK

To trim any length of beard or stubble hair for a clean, shaven look then follow the above steps without a comb attached to the blade head.

Place the flat top of the blade against the skin and slowly slide through the hair against the direction of growth.

TRIMMING AND EDGING

1. Fit the detail blade.
2. Hold the groomer with the back side of the blade facing you with no combs attached.
3. Start with the blades resting lightly against your skin, use motions towards edge of beard line to trim to desired locations in facial area.
4. Shape as desired.

TRIMMING WITH SHAVING GEL

Follow the same instructions as dry shaving if using shaving gel.

Caution: After use with shaving gel, please rinse the blade under warm water to clean away any excess gel and debris.

To ensure long lasting performance of the groomer, clean after each use.

The easiest and most hygienic way to clean the groomer is by rinsing the head under the tap after use while the blades are running.

To keep the unit in optimal condition we recommend re-oiling the blades after cleaning.

Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.

BATTERY REMOVAL

The battery must be removed from the appliance before it is scrapped.

The appliance must be disconnected from the supply mains when removing the battery.

1. Ensure the trimmer is discharged of all power.
2. Remove the comb attachment.
3. Detach the blade head.
4. Pry off the bottom gap below the grips.
5. Press in exposed tabs and pull internal frame out.
6. Disconnect the battery from the circuit board and internal frame.
7. The battery is to be disposed of safely.

RECYCLING

To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/collection point.

UW APPARAAT VERZORGEN

FÖR ATT TRIMMA SKÄGGET

Solid gray rectangular shape with no text, symbols, or discernible features

Solid gray rectangular shape with no text, symbols, or discernible features

Model No MB070

Remington ^® is a Registered Trade Mark of Spectrum Brands, Inc.,

or one of its subsidiaries

VARTA Consumer Batteries GmbH & Co. KGaA, Alfred-Krupp-Str. 9, 73479 Ellwangen, Germany

www.remington-europe.com