Cesti - Faucet Schütte - Free user manual and instructions

Brand	Schütte
Model	Cesti
Product type	Sink mixer tap
Intended use	Domestic, indoor (ambient temperature > 0 °C)
Recommended flow pressure	1.5 bar (max. 6 bar with pressure reducer)
Maximum water temperature	80 °C
Material	Chrome-plated brass (chrome surfaces), colored surfaces available
Main functions	Hot/cold water mixing, flow regulation
Care and cleaning	Clean water and soft cloth; avoid acidic, abrasive or alcoholic products
Safety instructions	Turn off water supply before installation; check for leaks after installation
Wear parts	Ceramic cartridge, mixing nozzle (aerator)
Repairability	Spare parts available; cartridge and aerator can be replaced
Warranty (chrome surfaces)	2 years from date of purchase
Warranty (colored surfaces)	1 year from date of purchase
Installation	By a qualified professional; turn off water before; rinse after installation
Supply	Cold water and hot water (standard connections)
Frost protection	Drain the faucet if there is a risk of frost

Frequently Asked Questions - Cesti Schütte

What water pressure is recommended for the Schütte Cesti tap?

The recommended flow pressure is 1.5 bar. If the pressure exceeds 6 bar, install a pressure reducer.

How do I clean the Cesti tap without damaging it?

Use only clean water and a soft cloth. Avoid descaling agents, acidic or abrasive products, as well as those containing alcohol.

What should I do if the water flow decreases?

Unscrew the mixing nozzle (aerator) and clean it from limescale deposits or foreign matter. If it is very dirty, replace it with a new one.

What is the maximum supported water temperature?

The water temperature must not exceed 80 °C to avoid damaging the tap.

How do I install the tap?

Entrust the installation to a qualified professional. First turn off the main water supply, then check that all seals are correctly positioned. After installation, flush the piping and the faucet before use.

What to do in case of a leak?

Check the tightness of the connections after the first use. If a leak persists, have it checked by a professional. Leaks can be caused by improperly seated seals or worn parts.

Is the tap under warranty?

Yes, the warranty is 2 years for chrome surfaces and 1 year for colored surfaces, from the date of purchase. It covers material and manufacturing defects.

Can I use the tap with a low-pressure water heater?

No, these faucets are not designed for small electric water heaters or low-pressure systems. Use them only with suitable water pressure.

How do I maintain the colored surfaces of the tap?

Clean them only with clear water and a soft cloth. Never use abrasive, corrosive, or alcohol-containing products, as this will damage the surface and void the warranty.

What to do in case of frost?

If there is a risk of frost, turn off the water supply and drain the faucet to avoid damage. The tap is only designed for use in rooms with temperatures above 0 °C.

USER MANUAL Cesti Schütte

Line drawing of a bathroom faucet with two fixtures and a handle, labeled '51' (no text or symbols on the diagram itself)

DE Montageanleitung 2 Garantiekarte 4
© Návod pro montáž .... 6 Záruční list 7
DK Monteringsanvisning 9 Garantibevis 10
ES Instrucciones de montaje 12 Tarjeta de garantía 13
FR Instructions de montage 15 Carte de garantie 16
GB Installation instructions .... 18 Guarantee card 19
MR Uputstvo za montažu 21 Garancijski list 22
HNU Szerelési útmutatás ..... 24 Garanciakártya 25
Istruzioni di montaggio 27 Certificato di garanzia 28
NL Montagehandleiding .... 30 Garantiekaart .... 31
RO Instrucțiuni de montaj 33 Certificat de garanție 34
RU Руководство По Монтажу 36 Гарантийная карточка 37
⑧ Monteringsanvisning 39 Garantikort 40
Sl Navodila za montažo 42 Garancijska kartica 43
SK Návod na montáz 45 Záručný list 46
Montaj kılavuzu 48 Garanti belgesi 49

FJS-KUE-ZG-SP-WD_0316

Montageanleitung

Installation instructions

Dear customer,

You have purchased a high-quality and long-lasting product from our line of goods. Please read these instructions carefully before assembling and observe the notes.

Therefore, keep the instructions in a safe place and pass them on to possible subsequent owners.

Safety notes

• Only allow experts carry out the installation work.
  • CAUTION DAMAGE BY WATER!
  Prior to installation please turn the general water supply off.
• Ensure that all gaskets have the correct fit.
  • These taps are not suitable for use on low pressure and small electrical storage heaters.
• We recommend the installation of a filter into the appliance or at least the use of angle valves with filter, in order to avoid the inflow of foreign matter, which could damage the upper parts of the valves.
• This tap is only intended for use in private households! Only suitable for use in rooms with a temperature over 0 °C, when there is danger of frost, sut off the water supply and empty the tap.
• If the tap not used for a longer period, we recommend to initially let a larger quantity of water flow through before withdrawing drinking water.
  • Take care when adjusting the warm water. Danger of scalding!
• Incorrectly installed fittings can cause water damages!
• Despite careful production, sharp edges can occur. Please exercise caution!

Disposal

Your washbasin tap is delivered in a solid packaging, in order to protect it against transport damages. The packaging consists of recyclable materials. Dispose it in an environmentally suitable manner.

Do not throw the product into the normal domestic waste at the end of its service life, but ask your municipal administration about the possibility of an environmentally friendly disposal.

Technical data

• Flow pressure: recommended 1.5 bar; install a pressure reducer at more than 6 bar
  • Water temperature: max. 80 °C

Installation Instructions

• Shut off the water supply before beginning installation
• After installation unscrew the mixer nozzle, flush the pipeline and the tap very well (warm/cold water supply), in order to flush out contaminations (swarf and hemp remainders). After flushing, screw the mixing nozzle onto the spout again.
• We do not assume any warranty for in correct installation - in particular for subsequent damages!
• Check all connections carefully after first-time use to make sure that they are tight.

Instructions for care

Sanitary taps require special care. Therefore, please observe the following instructions:

- Chrome-plated surfaces are sensitive to lime-dissolving agents, acidic cleaning agents and all kinds of abrasives.

• Never clean coloured surfaces with abrasive, corrosive, or alcoholic agents.
• Only clean your taps with clear water and a soft cloth or a shammy.

Surface damage is to be expected, if the care instructions are not observed. This makes any warranty claims invalid.

Do not forget to unscrew the mixing nozzle in regular intervals and to remove possibly calcareous residues or foreign matter. It is advisable to replace the mixing nozzle with a new one in the case of extreme contamination.

Maintenance

• Please note that a valve top is a wearing part and that in the case of very hard or soiled water the valve must be replaced every 1 to 2 years, as required.
• Please check all joints and connections for leaks or visible damages at regular intervals.
• In case of any leaks or visible damages to the fitting or connection hoses, these should be immediately checked by a specialist and replaced if necessary.

Decommissioning

• Cut off the water supply before dismantling the product.
• Pay attention to escaping residual water.
• Disassemble the product in the reverse order of the assembly instructions.

The illustrations are to be considered as figurative representations, deviations of the product are possible. Subject to technical modifications.

GUARANTEE CARD

The Franz Joseph Schütte GmbH grants a manufacturer guarantee for the tap you have acquired according to the following guarantee conditions. This guarantee does not limit your warranty claims resulting from the sales contract with the vendor as well as your statutory rights.

Guarantee conditions:

1. Scope of the guarantee

The Franz Joseph Schütte GmbH guarantees for perfect, material condition and processing suitable for the intended purpose, professional assembly, leaktightness, and function.

The guarantee does not cover:

• Corrosion in the mixing nozzles (aerator)
- Valves
- Damage by inappropriate installation, start-up and handling
- Damage by outside effects, such as fire, water, abnormal environmental conditions
- Mechanical damage by accident, fall, impact
- Negligent or intentional destruction
- Normal wear or malfunctions due to lack of maintenance
- Damages due to repairs by non-qualified persons
- Inappropriate handling, insufficient care as well as the use of unsuitable cleaning agents
- Chemical or mechanical effects during transport, storage, connection, repair and use of the tap

2. Guarantee

The guarantee covers at our discretion free repair, delivery of spare parts free of charge or of an equivalent tap against return of the faulty part and/or faulty tap. If the model concerned should not be manufactured any longer, we reserve the right to supply a replacement tap from our product range at our discretion,

which complies to the returned model as far as possible. Replaced taps or parts there of become our property. The buyer bears the transport costs as well as the transport risk, if a tap is returned.

Refunding of expenditures for disassembly and assembly, examination, claims for loss of profit and compensation are likewise excluded from the guarantee, as well as all further claims for damages and losses, which are caused by the tap or its use.

3. Asserting of the warranty claim

The warranty claim must be asserted within the guarantee period in regard to the Franz Joseph Schütte GmbH by submitting the original sales slip and only applies to the country, in which the tap was bought.

4. Guarantee period

The valid guarantee period is indicated on the packaging label. If no guarantee period is imprinted there, then a guarantee period of 2 years applies starting from purchase date. The date on the original sales slip is decisive.

For all not high-gloss chrome-plated surfaces, e.g. bronzed or coloured surfaces, the guarantee period is 1 year irrespective of the label on the packaging starting from purchase as specified by the purchase date, whereby the date on the original sales slip is also relevant here. The guarantee period for the tap is neither extended nor renewed by guarantee performances.

5.

This guarantee is governed by German law under exclusion of the United Nations Convention on Contracts for the International Sale of Goods (CISG).

This guarantee card is only valid with the pertinent original sales slip.

Service address

49134 Wallenhorst (NEMECKO)

+49 (0) 54 07 / 87 07-0

[e-mail]

www.fjschuette.de

Montaj kılavuzu

Line drawings of four different tools: a zigzag saw, a wrench, a pliers, and a spool (no text or symbols)

3 2 1.1 1.2 4 5

1 3 3 X

2 PTFE 4-5 x PTFE

3 ⚠ = ✗

4 1.1

5 4 4 4

6 2 1.1 2

7 1.1 1.2 1.2

8 5 9 10 5 2 min