ManualGo.com 
DuraBlade MB050 - Beard trimmer REMINGTON - Free user manual and instructions
Find the device manual for free DuraBlade MB050 REMINGTON in PDF.
| Technical Specifications | REMINGTON DuraBlade MB050 Beard Trimmer |
|---|---|
| Blade Type | Stainless steel blade |
| Cutting Length | 3 adjustable cutting lengths (1, 2, 3 mm) |
| Power Supply | Operates on rechargeable battery |
| Battery Life | 60 minutes of cordless use |
| Charging Time | 4 hours |
| Usage | Wet and dry use |
| Maintenance | Removable and washable blades under water |
| Included Accessories | Cutting comb, cleaning brush |
| Warranty | 2 years |
| Safety Precautions | Do not use on irritated or damaged skin |
| General Information | Ideal for all beard types |
Frequently Asked Questions - DuraBlade MB050 REMINGTON
Download the instructions for your Beard trimmer in PDF format for free! Find your manual DuraBlade MB050 - REMINGTON and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. DuraBlade MB050 by REMINGTON.
USER MANUAL DuraBlade MB050 REMINGTON
Thank you for buying your new Remington® product. Please read these instructions carefully and keep them safe. Remove all packaging before use. IMPORTANT SAFEGUARDS
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years. E Suitable for use in a bath or shower.
- Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres.
- Do not leave the appliance unattended while plugged in except when charging.• Do not use attachments other than those we supply.• Do not use the appliance if it is damaged or malfunctions.• Do not plug or unplug the appliance with wet hands.• This appliance is not intended for commercial or salon use. PARTS 1. On/O switch2. Blade3. Combs (1, 2, 4, 6mm) (not shown)4. LED charging indicator5. USB charging cable6. USB adapter (not shown) GETTING STARTED CHARGING YOUR APPLIANCEIt is recommended to fully charge your appliance before using for the rst time. Please refer to the charge times shown in this book.• Ensure the product is switched o.• Connect the product to the USB cable. Connect the other end of the cable to the supplied USB adapter or to a powered USB port. ENGLISH
Charge Level Indicator Charging LED shows solid Low charge LED ashes rapidly Full charge LED will turn o
- Run time from fully charged is up to 60 minutes.
- Charge time from empty is 4 hours. Note: To preserve the life of your batteries, let them run out every 6 months then fully charge.
INSTRUCTIONS FOR USE
Switch the product on by pressing the On/O switch. Always comb your beard or moustache with a ne comb before you start trimming.
CHANGING BLADE HEADS
1. To remove a blade head, twist it anticlockwise and pull it away from the body.
2. To ret, place the blade on to the body and twist it clockwise until it locks.
ATTACHING AND REMOVING THE COMBS
1. Select the desired trimming length comb. Place the comb over the top of the blade and
gently push this down onto the blade until it clicks into place.
2. To remove the comb, grasp the comb and pull rmly upwards and away from the
1. Select your desired trimming length comb. If you are trimming for the rst time start
with the maximum trimming length setting.
2. Turn the unit on.
3. Place the at top of the xed comb against the skin.
4. Slowly slide through the hair. Repeat from dierent directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit o,
pull o the comb and brush the hair o.
TO GET A SHAVEN LOOK
To trim any length of beard or stubble hair for a clean, shaven look then follow the above steps without a comb attached to the blade head. Place the at top of the blade against the skin and slowly slide through the hair against the direction of growth. ENGLISH5
1. Hold the groomer with the back side of the blade facing you with no combs attached.
2. Start with the blades resting lightly against your skin, use motions towards edge of
beard line to trim to desired locations in facial area.
3. Shape as desired.
TRIMMING WITH SHAVING GEL
Follow the same instructions as dry shaving if using shaving gel. Caution: After use with shaving gel, please rinse the blade under warm water to clean away any excess gel and debris.
CARE OR YOUR GROOMER
To ensure long lasting performance of the groomer, clean after each use. The easiest and most hygienic way to clean the groomer is by rinsing the head under the tap after use while the blades are running. To keep the unit in optimal condition we recommend re-oiling the blades after cleaning. Place a few drops of cutter or sewing machine oil onto the blades. Wipe o excess oil. BATTERY REMOVAL The battery must be removed from the appliance before it is scrapped. The appliance must be disconnected from the supply mains when removing the battery.
1. Ensure the trimmer is discharged of all power.
2. Remove the comb attachment.
5. Press in exposed tabs and pull internal frame out.
6. Disconnect the battery from the circuit board and internal frame.
7. The battery is to be disposed of safely.
To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate ocial recycling/ collection point. ENGLISH
