Lissea RW5360 - Shaver ROWENTA - Free user manual and instructions

Frequently Asked Questions - Lissea RW5360 ROWENTA

USER MANUAL Lissea RW5360 ROWENTA

1. DESCRIPTION OF YOUR APPLIANCE

A - Pivoting shaving head
B-Micro-foil
C - Trimmer
D-Blade-block release button
E - Shaving head release buttons
F-On/Off switch
G-Bikini accessory-6mm (RF5360)

H - Cleaning brush
I - Power unit (RF5360/RF7360)
J-Light (RF7360)
K-Bikini head (RF7360)
L - 2 interchangeable combs - 3mm and 6mm (RF7360)
M - Battery compartment (RF3330/RF7360)

- Vision function (RF7360)

By diffusing an ultraluminous halo on the skin, this system makes all your hair - even the finest, shortest and fairest hairs - easier to see.

- Pivoting head function

For comfort of use, your appliance is fitted with a pivoting head that adapts to every contour of the areas to be shaved (legs, armpits, bikini line) for a smooth, efficient result.

2. SAFETY ADVICE

Read carefully before use...
- The safety of this appliance conforms with current technical rules and standards (Electromagnetic Compatibility, Low Voltage, Environment).
- Battery-operated model (RF3330) and mains/rechargeable model (RF7360): 3 LR03 AAA 1.5Volt batteries.
- Mains model (RF5360/7360), operating voltage: 230 V. Check that this voltage matches that of your installation.
- The appliance must be turned off (button in the Off position) and unplugged (mod. RF5360/7360):
- before any cleaning, or fitting or removal of the combs
- in the event of an operating anomaly
- as soon as you have finished using it.
- When the appliance is operating, it must not come into contact with eyelashes, clothing or any other object, in order to avoid all risk of injury or jamming.
- Do not use the appliance:
-on the face
-on injured skin.
- if you are suffering from any skin ailment: eczema, varicose veins, skin inflammation, moles, acne, warts, birth marks, etc.
- For hygienic reasons, do not lend your appliance.
- This appliance must only be used to cut hair as intended. Any other use is prohibited. Do not use the appliance on animals.
- We shall not be held liable for any damage resulting from improper use of the appliance or for any use other than that stated in these instructions.
- Do not leave the appliance for extended periods at temperatures below 0^ or above 35^ (behind glass in full sunlight, for instance).
- Keep the appliance away from any heat source.

• This appliance requires special tools for its disassembly. Any maintenance operation must be performed by the manufacturer, its after-sales service or a person with similar qualifications in order to avoid hazards.
• For any malfunction, refer to the paragraph entitled "in the event of a problem" or contact our consumer service or your retailer.
• Do not use your appliance and contact an Approved Service Centre if:
• your appliance has fallen (invisible damage may be a threat to your safety),
• if it is not operating normally.
• This appliance should not be used by persons (including children) with reduced physical, sensory or mental capacities or persons devoid of experience or knowledge, unless they have received prior instructions on the use of the appliance from a person responsible for their safety or are kept under close surveillance during its use.

Children should be kept under close surveillance to make sure they do not play with the appliance.

• Do not use an extension cord.
• Never use the appliance with wet hands.
• Do not expose the appliance to sunlight.
• Do not use the appliance at cold temperatures.
• Do not immerse the appliance or put it under running water.
• Do not use abrasive products or solvents to clean the appliance.

Guarantee

Your appliance is intended for personal home use only. It is not intended for professional purposes. In the event of improper use, the guarantee will be null and void.

3. SHAVING INSTRUCTIONS

Recommendations:

• Do not use any lotions that contain alcohol either immediately before or after shaving. To relax the skin we recommend using a moisturising cream after shaving.
• To avoid any possible skin irritations do not press the foil too hard against the skin.
• Before you start, thoroughly wash the areas of the body to be shaved, to remove any traces of personal care products (e.g. deodorant) and dry the skin with a towel.

• Make sure that the skin is washed thoroughly and is absolutely dry.

• Switch the appliance ON.

• Pull your skin taut using your free hand to make the hairs lift up. To use in the armpit area, stretch your arm up over the head.
• Guide the lady shaver smoothly and without undue pressure over the skin so that both the longer and the shorter hairs are cut evenly. (fig 6)
• For comfort of use and a smooth and efficient result the shaver is fitted with a floating head that adapts to every contour of the areas to be shaved.
• Use the appliance against the direction of the growth of hair.
• Switch OFF the lady shaver after use.

4. USING THE BIKINI ACCESSORY (MOD.RF5360)

Your bikini accessory (6mm) will enable you to shave and trim the hair of the bikini area.

Operating instructions:

• Fit the bikini accessory (G) onto the shaving head (A).
• Move your appliance slowly over the bikini area, against the hair.
• For better efficiency of the appliance, remove the hair regularly using the brush or by completely removing the accessory and blowing on it, in order to avoid jamming.
• At the end of the session, remove the bikini accessory with the plastic fitting at its base.

5. USING THE BIKINI HEAD (MOD. RF7360) AND COMBS

The bikini head (k) comes with two combs (3mm and 6mm) (L) which lift up the long hairs of the bikini area so they can be cut by the blade.

Operating instructions:

• Remove the shaving head by pressing the release buttons on the head (E) and pull the head gently upwards (fig 1).

• Fit in the bikini head, using the two hooks located at the back of the head, then swivel it until it clicks. (fig 10&11),

• Fit the desired comb (3 or 6 mm) onto the bikini head (fig 7):

• If you want a hair length of about 3mm , use the 3mm comb.

• If you want a hair length of about 6mm, use the 6mm comb.

• At the end of the session, remove the comb using the plastic fitting at its base and slide it along the bikini head.

• After use, remove the bikini head by pressing the release buttons on the head (E) and gently pulling the head upwards (fig 12).
• To put the shaving head back on the appliance: insert the head using the two hooks located at the back of the head, then swivel it until it clicks (fig 2&3).

6. USING THE BIKINI HEAD

without a comb for a neat bikini outline

If you want a close shave, use the bikini line trimmer head without a comb:

• Stop and unplug the appliance.
• Remove the comb (fig 8).
• Switch on the appliance.
• Hold the appliance at right angles to your skin and move it slowly against the hair.
• After use, remove the bikini head by pressing the release buttons on the head (E) and gently pulling the head upwards (fig 12).
• Stop and unplug the appliance.

7. CLEANING AND CARE INSTRUCTIONS

Clean the shaver after each use!

- Dry cleaning

-Stop and unplug the appliance.

• Press both release buttons (E) and lift up the shaving head (fig 1)

• Open the shaving head by moving the blade release button (D) on the shaving head (fig 4.)

• Brush the shaving unit with the cleaning brush supplied. Also clean the area under the cutting unit and brush clean the upper cover (fig 5).

- Cleaning with water

• Stop and unplug the appliance.

• Press both release buttons (E) and lift up the shaving head (fig 1)

• Open the shaving head by moving the blade release button (D) on the shaving head (fig 4.)

• Press both release buttons (E) and lift up the shaving head (fig 1)

• Open the shaving head by moving the blade release button (D) on the shaving head (fig 4.)

-Rinse the foil mesh and the cutting unit under running water (fig 14) Remove remaining hair with the brush. Let the shaver dry before closing the shaving head.

• The housing may be wiped down using a damp cloth with a little was

• Replace the head on the shaver by pushing it into the upper part of the housing and then pressing it into the housing until it clicks (fig 2&3).

RINSING THE BIKINI HEAD (RF7360)

• Stop and unplug the appliance.
• Remove the bikini head by pressing the release buttons on the shaving head (E) and pulling the head gently upwards (fig 12).
• You can then put the bikini head under gently running cold water for 5 to 10 seconds .
• Shake the bikini head briskly then dry it with a towel.
• Replace the head on the shaver by pushing it into the upper part of the housing and then pressing it into the housing until it clicks (fig 2&3).

WASHING THE COMBS AND BIKINI ACCESSORY

• Put them under gently running cold water then dry them with a soft cloth before storing.

8. IN THE EVENT OF A PROBLEM

"Inefficiency of your shaver!":
- Have you thought of stretching your skin during shaving?
- Have you cleaned the shaving head properly? Is it worn?
- Is the shaving head worn? To change it, go to one of our approved service centres.
- Is the cutting head well positioned in its housing?

• "Operating problem!":
• Are the batteries placed in the right direction (RF3330/7360)?

9. MAINTENANCE

Change the batteries

The appliance has to be equipped with functional batteries.
- If the batteries are not new, keep some spare batteries so you can cb needed.
- Open the battery compartment by removing the battery cover from the in three alkaline Micro (AAA) batteries (fig 13.
- Replace the battery cover.

10. HELP PROTECT THE ENVIRONMENT!

• Your appliance contains numerous reusable or recyclable materials.

• Before disposing of your appliance at the end of its useful life, remove the batteries and take them to one of the collection points designed for that purpose. You can also take your appliance to an Approved Rowenta Service Centre who will take care of its disposal.

1. DESCrizIONE DELL'APPARECCHIO