HP4671 - Lisseur PHILIPS - Free user manual and instructions

USER MANUAL HP4671 PHILIPS

Congratulations on your purchase and welcome to Philips! To fully benet

from the support that Philips offers, register your product at www.philips.

The new Philips Salon Airstylist Pro has been specially designed to give

beautiful styling results in a fast and easy way. The styler comes with

exchangeable attachments, some of them with a ceramic coating, for

creating various hairstyles. We hope you will enjoy using your Salon

~ : gentle airow for easy styling

6 (red): warm and powerful airow for fast styling

6 (blue): cool airow to x your style

H Super Shine natural bristle brush

Read this user manual carefully before you use the appliance and save it

for future reference.

Keep the appliance away from water. Do not use it near or over

water contained in baths, washbasins, sinks etc. When you use the

appliance in a bathroom, unplug it after use. The proximity of water

presents a risk, even when the appliance is switched off.

Do not insert metal objects into the air inlet grille to avoid electric

Check if the voltage indicated on the appliance corresponds to the

local mains voltage before you connect the appliance.

Check the condition of the mains cord regularly. Do not use the

appliance if the plug, the mains cord or the appliance itself is damaged.

If the mains cord is damaged, you must have it replaced by Philips, a

service centre authorised by Philips or similarly qualied persons in

order to avoid a hazard.

This appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person

responsible for their safety.

Children should be supervised to ensure that they do not play with

For additional protection, we advise you to install a residual current

device (RCD) in the electrical circuit that supplies the bathroom. This

RCD must have a rated residual operating current not higher than

30mA. Ask your installer for advice.

The attachments become hot during use. Prevent contact with the

Never block the air inlet grille.

If the appliance overheats, it switches off automatically. Unplug the

appliance and let it cool down for a few minutes. Before you switch

the appliance back on, check the grilles to make sure they are not

blocked by uff, hair, etc.

Always unplug the appliance after use.

Wait until the appliance has cooled down before you store it.

Always switch off the appliance before you put it down, even if it is

Do not wind the mains cord round the appliance.

Do not use the appliance on articial hair.

Do not use the appliance for any other purpose than described in

ENGLISH 7Never use any accessories or parts from other manufacturers or that

Philips does not specically recommend. If you use such accessories

or parts, your guarantee becomes invalid.

Keep the attachments clean and free of dust, dirt and styling products

such as mousse, spray and gel.

Electromagnetic elds (EMF)

This Philips appliance complies with all standards regarding

electromagnetic elds (EMF). If handled properly and according to the

instructions in this user manual, the appliance is safe to use based on

scientic evidence available today.

Do not use the appliance on wet hair, dry your hair with a towel rst. The

Airstylist Pro is most effective on towel-dry hair.

1 Comb or brush the hair so that it is untangled and smooth.

2 Use a comb to divide the hair into locks.

Do not put too much hair in one lock.

Connecting and disconnecting attachments

Always connect the appropriate attachment before you put the plug in

1 Choose the desired attachment and snap it onto the appliance

2 To remove the attachment from the appliance, press the release

button (1) and pull the attachment off the appliance (2). (Fig. 3)

Always connect the appropriate attachment before you put the plug in

ENGLISH8Styling with the retractable bristle brush

We advise you to perform a curl test to determine how long you have to

hold the brush in your hair to achieve a good result. Start with 8 to

10 seconds. You may have to hold the brush in your hair longer for tighter

curls. Less tight curls require less than 8 seconds.

1 Snap the retractable bristle brush onto the appliance.

See chapter ‘Preparing for use’.

2 Put the plug in the wall socket.

3 Take a lock of hair and wind it round the brush. Make sure you

wind the end of the lock in the required direction.

Do not wind too much hair round the brush at a time.

The thinner the lock of hair, the tighter the curl. Do not wind a lock

of hair more than twice round the brush.

Make sure the lock of hair is in contact with the barrel of the brush.

Note: To give your hair optimum lift and volume, wind the hair at right angles

4 Select the preferred setting to switch on the appliance (Fig. 4).

~: gentle airow for easy styling

6 (red): warm airow for fast styling

5 Hold the brush in place as long as required (normally 8 to

6 Assoonasthehairfeelsdry,xthecurlwithacoolairow(blue

6 setting) for long-lasting results. (Fig. 5)

7 Switch off the appliance. Press the retractable bristle knob (1) and

turn it in the direction of the arrow (2) to remove the brush from

ENGLISH 9Super Shine natural bristle brush

Use the Super Shine natural bristle brush to add shine and create texture,

especially for medium-length hair

1 Snap the natural bristle brush onto the appliance.

See chapter ‘Preparing for use’.

2 Place the brush in the hair.

3 Select setting ~ or 6 (red) to switch on the appliance.

4 Make brushing movements from the top of the head downwards,

while you slightly turn the brush (inwards or outwards, depending

on the desired effect).

5 Finishoffwithacoolairow(blue6setting)toxyourstyle.

6 Whenyouhavenishedstylingyourhair,switchofftheappliance.

Styling with the shape brush

Use the shape brush to polish and shape your hair.

1 Snap the shape brush onto the appliance.

See chapter ‘Preparing for use’.

2 Place the brush in the hair.

3 Select setting ~ or 6 (red) to switch on the appliance.

4 Make brushing movements from the top of the head downwards.

5 Move the brush away from the head while you turn the brush. The

hair is lifted and falls lightly back onto the head.

6 Whenyouhavenishedstylingyourhair,switchofftheappliance.

Remove the attachments from the appliance before you clean them.

Never rinse the appliance with water.

1 Make sure the appliance is unplugged.

ENGLISH102 Clean the appliance with a small brush or a dry cloth.

3 Clean the attachments with a moist cloth.

If you have used styling products on your hair before or during styling,

clean the ceramic-coated attachments thoroughly with a moist cloth after

Make sure the attachments are dry before you use or store them.

Make sure the appliance is unplugged.

2 Remove the attachment (see chapter ‘Preparing for use’).

3 Put the appliance in a safe place and let it cool down.

Do not wind the mains cord round the appliance.

Do not throw away the appliance with the normal household waste

at the end of its life, but hand it in at an ofcial collection point for

recycling. By doing this, you help to preserve the environment (Fig. 7).

If you need information or if you have a problem, please visit the Philips

website at www.philips.com or contact the Philips Customer Care

Centre in your country (you nd its phone number in the worldwide

guarantee leaet). If there is no Customer Care Centre in your country,

go to your local Philips dealer or contact the Service Department of

Philips Domestic Appliances and Personal Care BV.

ENGLISH 11Troubleshooting

If problems arise with your hairstyler and you are unable to solve them

with the information below, please contact the nearest Philips service

centre or the Philips Customer Care Centre in you country.

Problem Cause Solution

Check if the power supply works. If

it works, plug another appliance

into the socket to check whether

Make sure the appliance is plugged

in. Then select the preferred setting

to switch on the appliance.

switched itself off.

Unplug the appliance and let it cool

down for a few minutes. Before you

switch the appliance back on, make

sure the grille is not blocked by uff,

Make sure that the voltage

indicated on the appliance

corresponds to the local mains

If the mains cord is damaged, you

must have it replaced by Philips, a

service centre authorised by Philips

or similarly qualied persons in

order to avoid a hazard.