Ride 8+ - Electric scooter URBANGLIDE - Free user manual and instructions

USER MANUAL Ride 8+ URBANGLIDE

Protective equipment Driver’s advice Procedures and driving conditions Usage of the charger Battery Maintenance Transport Using the scooter Rebus Security USE The different parts Folding step Unfolding step Using the screen Mounting the handlebar Adjusting of the folding device UT OU OR BB

Please read the manual carefully before using the product and read the risks and safety tips in the manual. The use of an electrical product can be dangerous if the user is not watchful. Misuse and non-respect with the safety instructions does not affect the company in event of accident. Self-judgment and common sense are necessary for users to detect the possible dangers. Please verify the current regulations and laws in your country to know where and how to use your product legally. You must comply with the rules and laws that applicable to vehicles and pedestrians. ° Protective equipment Always wear the following protective equipment: Approved and certified helmet according to your location Knee pads and elbow patches Long sleeve t-shirt and long pants Gloves Shoes with rubber soles, never drive in barefoot or sandal. Verify to make the laces made and keep them as far as possible from the wheels and the internal system. + Driver’s advice This device may be used by children over 8 years of age and by persons with reduced physical, sensory or mental capabilities or lack of experience or knowledge, if properly supervised, or if instructions for use of safely, were given to them and the risks were apprehended. Children under 8 must not play with the product. Cleaning and user maintenance should not be performed by unattended children. Do not touch the engine or the brakes of the product immediately after use, these parts may be extremely hot. The maximum weight of use is 120 kg. Procedures and driving conditions Please verify the current laws and rules in your country before using the product. Look around when using the product and pay attention to all possible risks. It is important to respect the rights and properties of everyone. For your safety do not start the accelerator if you are not on the product. This product is not designed to make jumps, acrobatic tricks and skids. Never drive on roads, near vehicles, stairs, hills, swimming pools or other streams. Please hold the handlebars with both hands. Never go on the product with more than one person. Be sure to keep your fingers and other body parts away from hot parts during use (Brake, motor, chain). Never use the product with a Mp3 player, or with your smartphone at hand. Never use the product to pull anything, as this may damage the components and wear outthe battery. Never put the product in contact with water, the electrical components can be damaged and create a dangerous situation. Roll only on flat and solid surfaces. Avoid surfaces with gravel, holes, ice, which can lead to loss of control of the product. Do not drive at night or in areas where visibility is reduced. Do not ride indoors where there are carpets as they can interfere. After each use, verify that each piece is in its proper place, and that it is not damaged. Before each use, verify the following points:

The brakes are in good condition All components are in good condition and in their places The parts with defects in the last use have been repaired or replaced according to the manufacturer's conditions. People who have medical follow-up or treatment such as: cardiac people, pregnant women, irresponsible people, people with back or neck problems, should not use the product. When notusing your scooter, use the kickstand to keep itupright. To do this, straighten the metal bar located under the tray of your scooter. You can adjust the height of the handlebar using the buttons on the sleeve. Press the button and pull your handlebars up to raise your handlebars. ° Usage of the charger A plastic cap is located on the loading port of your scooter, remove it to load your product, and do not forget to put it back before using your scooter so as not to damage the loading port. Before using the product, it is necessary to charge it. A long charge may be necessary before the first use. Please refer to the battery indicator, you can charge your battery at any time to ensure the constant power. It is not necessary to wait until the battery is completely empty to charge it. Please do not use the charger of other brand, these can damage the battery of your product. To ensure a normal life cycle, it is important to charge your battery at least once every 3 months, even if you are not using the product. It is imperative to use the supplied charger which is specially designed for this scooter. Avoid shocks and contact with water, these are factors not covered by the warranty that may damage the battery. The supplied charger is "smart", it will stop at 100% of the charge and not damage the battery. The charger must be in perfect condition during each use, verify the wires, the condition of connection ends and connectors. If the product does not charge, the charger may be defective, it needs to be replaced. The charger must be used only by an adult, it is important to unplug it from both sides when not charging. ° Battery Please do not store the battery in extreme temperatures. Store it below 30 ° C and above 0 ° C. If you do not use your product for 60-90 days, the battery may get worse. This loss of autonomy is due to lack of use and is therefore not covered by the warranty. At the end of its cycle, the battery must be discarded separately from the undifferentiated generic waste. Discard the batteries in the containers provided for this purpose. The recovery and recycling of batteries contributes to protect the environment and material resources conservation.

+ Maintenance Please store your product in a dry, dust-free place, and avoid leaving it in a humid area or under the sun for too long. To clean your appliance, use a damp cloth and mild detergent. Do not use alcohol, gasoline, kerosene, or other corrosive chemical solvents to clean your appliance, which will damage its appearance and structure. Constantly verify the condition of components of your product, if any part is damaged, please replace it before using the product. If a part is not working, falling and injuring may occur. Do not disassemble the scooter in case of breakdown, otherwise the warranty will cancel. Before any intervention, it is advisable to turn off your scooter. For all spare parts, please contact your dealer ° Transport If you wish to transport your product by air or other means of transport as well as its battery, please contact the local authorities and the carrier beforehand to obtain the possible prohibitions and limits of transport. Lithium batteries are considered dangerous in many countries. Please make sure that the access and transport are allowed before travelling. International law prohibits the transport of lithium batteries by air. ° Using the scooter To turn on your product, press the Power button, then press the accelerator to advance. To move forward, place both feet on the board, and use the right trigger on your handlebars to advance your scooter. To brake, you can use the left trigger on your handlebar, or press the rear fender with your foot to reduce the speed of your scooter. Before each use, please check that the wheels are not clogged, that the brakes are working and that no warning message is displayed. Using the scooter for long periods can cause vibrations that can be unpleasant, make poses regularly. When stopped, use the stand to stabilize your product. Unfold it with your foot. To warn other users of your presence, use the horn located on the handlebars. Use the LED on the front of your product to light your way in dark places. ° Rebus THIS TROTTINETTE CONTAINS LITHIUM BATTERIES THAT MUST BE RECYCLED SAFELY.Recycling: The battery must be removed before being discarded. Before any work, remember to turn it off and unplug it from the power outlet.

USE The different parts Multifunctional display ON/OFF Electric brake Accelerator Charging port Plateau Mechanical rear brake Front suspension Rear wheel Front wheel —— Motor Lever handler To move forward, place both feet on the board, and use the right trigger on your handlebars to move your scooter forward. To brake, you can use the left trigger on your handlebars, or pull the rear mudguard with your foot to reduce the speed of your scooter. Folding steps Unfolding Folding

1. Switch off the scooter and store the stand.

2. Press the folding button with your foot or hand and fold the scooter.

3. Continue bending until you hear the "click" sound.

Press the folding Location of the bending button axis after bending CAUTION: Do not pinch your fingers when folding the scooter! Unfolding steps Location of the bending axis after bending Press the folding button

1. Press the folding button.

2. Hold the scooter platform and raise the handlebar until you hear the "click" sound. If you have not heard the

sound, repeat and hold the folding button with your foot to make it easier to unfold. Using the screen Screen 1. The battery indicator shows the remaining Buton battery level in real time.

2. To turn the scooter on, press the On/Off button,

to turn it off, press it for 3 seconds.

3. Once turned on, press the On/Off button once

to turn on the front light. Press it once more to turn it off.

4. Once turned on, press the On/Off button twice

to change the speed mode. When the "S"is not displayed, you are in first gear, when the "S"is flashing, you are in second gear, and when itis static, you are in third gear.

Mounting the handlebar Assembly Q Ce

10 assemble the nanalebars of your scooter, follow these steps:

1. Insert the two handles into the handle of your scooter.

2. Screw the two handles

To disassemble the handlebars of your scooter, follow these steps:

1. Unscrew the two handles of the handle of your scooter.

2. Remove both handles.

Adiusting of the folding device 1.When the space in the folding device is too large, the upper screw can be turned to the right with an Allen key and the left and right screws must be adjusted. Screw adjustment o Locking pin 2.Before adjustment, make sure that the scooter is in the adjustment lock state and after adjustment, that the folding switch is elastic and can be used normally. The locking pin may normally fall down.

TROUBLESHOOTING Problem Possible cause Solution The battery is not charged. Charge the battery, check if the red light is on. Connections or cables are disconnected. Check that the battery is firmly seated in the product. The battery needs to be Charge the battery, check if the red charged. light is on. Make sure the power cable is well The battery is not fully connected. charged. The battery may need to be replaced. Overload, cut-off Overloading may result in product failure. Turn off the product, wait 15 seconds, then turn it on again. Fuse burnt Overloading can burn fuses, you may have to replace them. For this, contact the after-sales service. Prior to this, check the condition of all cables and connectors. The brakes are not properly adjusted. Check the condition of the brakes, and try to loosen. If this does not work, please contact the after-sales service. It has overloaded Check that the user weighs less than the previously recommended weight. Check that there are no objects obstructing the proper operation of the product. Bad driving condition. Make sure you are on flat, dry, and constant ground. The tires / wheels are damaged. Check the condition of the wheels of the product.

For any information, contact our after-sales service at the following address: Support@urbanglide.com You will also find many tutorial videos concerning the maintenance and maintenance of your product on our YouTube channel: UrbanGlide Channel Finally, do not hesitate to follow us on our social networks Instagram and Facebook to follow our news. Urbanglide.fr Urbanglide Urbanglide Channel ) Q ©

/ PACT DECLARATION OF CONFORMITY Ubu(|de We undersigned PACT GROUP hereby declare that the product. Model: URBANGLIDE RIDE 8Plus Type: Electric scooter Function: Electric scooter for individual transport Product description: Electric kick scooter with adjustable speeds for individual transport. S/N : 202105UGR8PSAS0001 - 202105UGR8PSAS2000 Meets all standards and technical directives below: DIRECTIVES

2. Aparafusar as duas pegas

2. Retire ambas as pegas.