THT 61 IX - THOMSON - Free user manual and instructions
Find the device manual for free THT 61 IX THOMSON in PDF.
Download the instructions for your in PDF format for free! Find your manual THT 61 IX - THOMSON and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. THT 61 IX by THOMSON.
USER MANUAL THT 61 IX THOMSON
WARNINGS This appliance is intended for domestic household use only and should not be used for any other purpose or in any other application, such as for non‐domestic use or in a commercial environment. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid hazards. There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels. There is risk of fire if cleaning is not carried out in accordance with the instructions. Do not flambé food under the range hood. CAUTION: Accessible parts may become hot when used with cooking appliances. The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels. Regulations concerning the discharge of air have to be fulfilled. When the range hood is located above a gas appliance, the minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood shall be at least 65 cm. For details concerning the method and frequency of cleaning, please see section "Cleaning and maintenance" on page 7. 1
IMPORTANT SAFETY INSTRUCTIONS •
Follow strictly the instructions in this instruction book and keep it in a safe place for future reference. It contains important information about installation, use and safety. • It is important to keep this booklet for future reference at any time: in the case of sale, cession or move, make sure it is kept together with the product. • The manufacturer declines all responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual. • Use work gloves for all installation, cleaning or maintenance operation. • The hood can have different aesthetic configurations with respect to what is illustrated in the drawings of this manual, however the instructions for use, maintenance and installation remain the same. • Do not carry out electrical or mechanical modifications to the product or the exhaust ducts. • Before installing the appliance, check that there is no damaged component. Otherwise, contact your dealer and do not continue the installation. Note: the elements marked with the symbol ‘(*)’ are optional accessories that are supplied only with some models or parts not supplied that must be purchased. • Before performing any cleaning or maintenance, disconnect the hood from the mains by unplugging it or turning off the main switch of the house. • The hood must be regularly cleaned both inside and outside (AT LEAST ONCE A MONTH); this should be done in accordance with the maintenance instructions. • The use of an open flame is damaging to the filters and may cause fire, therefore they should be avoided under any circumstances. • Frying foods must be done carefully to ensure that the cooking oil does not catch fire. • When the hob is in use, accessible parts of the hood may become very hot. • Do not connect the appliance to the mains until the installation is completely finished. Regarding the technical and safety measures to be taken for the evacuation of fumes, strictly observe the provisions of local regulations. The air should not be sent into a duct used to evacuate fumes from appliances using gas or another fuel. • Do not use or leave the hood without the bulbs correctly mounted because a potential risk of electric shock is possible. To replace the lamp, use only the type specified in the lamp replacement/lamp maintenance section of this manual. Do not touch the bulbs after using the appliance, you may get burned. • Never use the hood without the grill mounted properly! • The hood must NEVER be used as a support surface unless specifically indicated. Never use the hood as a work plan. • Use only the screws provided with the product for installation, or, if not included, purchase the correct type of screws. • Use the correct length for the screws that are identified in the Installation Guide. If in doubt, consult your authorized service centre or qualified personnel. • Failure to install the screws and fasteners in accordance with the instructions may cause electrical hazards. • Do not start using a programmer, a timer or a separate remote control system or any other device that turns the power on automatically. • Do not attempt to examine the filters while the hood is operating. The presence of open flames can damage the filters and result in fire, so avoid them at all costs. 2
DESCRIPTION The hood is designed so it can be used in the exhaust ducting version or filtering version with internal recycling.
BEFORE INSTALLATION Before starting the installation: • Make sure the size of the hood and its duct are compatible with your cooker and ceiling height. • Remove the activated charcoal filter(s) (*) if provided (see also related paragraph). It (these) is (are) assembled only if you want to use the hood in the recycling version. • Check that inside the hood there is not (for shipping purposes) other materials provided with the equipment (eg screw (*), warantee certificates (*) etc. In this case, remove them and keep them. • Make sure the product is in perfect condition. If damaged, do not continue with the installation and contact your after‐sales service.
INSTALLATION Excessively heavy appliance; handling and installation of the hood should be made by two or more people. The hood features fixing plugs suitable for most types of walls/ceilings. However, it is necessary to contact a qualified technician to ensure that the material is appropriate to the type of wall/ceiling. The wall/ceiling must be strong enough to support the weight of the hood.
The minimum distance between the container support area on the cooking appliance and the lowest part of the range hood must not be less than 50cm in the case of electric cookers and 65cm in the case of gas or mixed cooker.
If the installation instructions for the gas hob specify a greater distance, this must be taken into account Warning ! Failure to follow the instructions in this Instruction Book may cause electrical hazards. If in doubt, consult an authorized service centre or an authorized technician.
Electrical connection The electrical connection of the hood to the electrical system must be performed by qualified and specialized technical staff. The voltage must correspond to the rating indicated on the nameplate located inside the hood. If there is a socket, connect the hood to a wall socket compliant with the standards in force and located in an area accessible after installation as well. If there is no socket (direct connection to the electrical circuit), or if it is not in an area accessible after installation too, apply a standard circuit breaker to ensure the complete disconnection of the hood from the mains under conditions of overvoltage category III, in accordance with installation instructions. Attention! Before reconnecting the hood circuit to the power supply and checking the efficient operation, always check that the power cable is correctly assembled. The hood is equipped with a special power cable; in the event of cable damage, you must order a new one to the Technical Support Service
USE Ducting version Fumes are vented to the outside through a exhaust duct attached to the connection flange which is located above the hood. Beware! The exhaust pipe is not supplied and must be purchased separately. The diameter of the exhaust pipe must be equal to that of the connection flange. If the hood is equipped with a charcoal filter, it must be removed. Connect the hood to the tubes and vent holes of the wall of a diameter equivalent to the air outlet (connection collar).
Use a pipe having strictly the required length. Pipe bends must be of minimum number (maximum bend angle: 90°). Avoid excessive variations in pipe section. Pipe material must be according to norms.
Recirculation/Filtering version In the case where the evacuation of fumes and vapours towards the outside is not possible, the hood can be used in recirculation mode. The suctioned air will be degreased and deodorized before being sent back into the room. To use the hood in this version, you must install an additional filtering system based on activated charcoal.
Operation The hood is fitted with a control panel with a suction speed control and a cooking hob lighting control.
a. Switch ON/OFF lights. b. Switch OFF/speed 1 c. Selection speed 2 d. Selection speed 3 Note : button b. corresponds to speed 1 but it also serves as an on‐off switch. Therefore, it must be pressed if you want to select speed 2 or 3.
Energy Saving Tips Turn on the hood to the minimum speed during cooking and let it run for a few minutes after cooking. Increase speed only in the presence of a large amount of fumes or vapour and use accelerated speed(s) only in extreme cases. Replace charcoal filter(s) when necessary in order to maintain an effective odour reduction. Clean grease filter(s) when necessary in order to maintain an effective filtering of grease. Use a piping system having the maximum diameter indicated in this manual in order to optimize performance and minimize noise.
CLEANING AND MAINTENANCE Cleaning Beware! Before performing any cleaning or maintenance, disconnect the hood from the mains by unplugging it or turning off the main switch of the house. The inside and outside of the hood must be cleaned regularly (about once a month). For this, use a cloth moistened with neutral liquid detergent. Do not use products containing abrasives. DO NOT USE ALCOHOL! ATTENTION: There is risk of fire if you do not observe the instructions on cleaning the appliance and changing or cleaning the filter. Cleaning of the external surface • To protect the external surface of the hood from corrosion that can occur in the long run, be sure to clean it every two months with warm water and a mild detergent. • The motor and other parts must not come into contact with water. • Charcoal filters should not be exposed to heat.
Grease filter Fig. 9-14 The grease filter retains grease particles from cooking. The metal grease filter must be cleaned once a month with non aggressive detergents, either by hand or in the dishwasher at low temperatures and short cycle. Washing the metal grease filter in the dishwasher may cause its discolouration. However, the filter characteristics shall not be modified in any case. To remove the grease filter, pull the release spring handle.
Activated charcoal filter (recirculation/filtering version only) Fig. 13 It retains unpleasant cooking odours. The saturation of the activated charcoal can be seen after a fairly long job, depending on the frequency of use and the regularity of cleaning the grease filter. In any case, it is necessary to change the filter after a maximum of four months. IT CANNOT be cleaned or regenerated. Remove the grease filters. Apply a charcoal filter aside and hang it to the hood. Put back the grease filters.
Lamp Replacement The hood is fitted with a lighting system based on LED technology. The LEDs provide optimal lighting, lasting up to 10 times greater than traditional bulbs and allow savings of 90% in electricity. To access the bulbs, first unplug the appliance from the mains, then remove the cover. Warning! Before touching the lamps, make sure they are cold. To purchase the LED to be replaced, contact the customer after-sales service (technical assistance).
SPECIFICATIONS Below, the product sheet of your hood, following European Regulation No. 65/2014. Brand
THOMSON Reference Annual energy consumption (AEC Hood) Energy efficiency class* Fluid dynamic efficiency (FDE Hood) Fluid dynamic efficiency class * Light efficiency (LE Hood) Light efficiency class* Grease filtering efficiency Grease filtering efficiency class * Air flow rate Minimum speed Maximum speed Acoustic emissions of Minimum speed air Maximum speed Power consumption in off mode (Po) Power consumption in standby mode (Ps)
THT 60 X 80.1 kWh/year C 20.5% C 13.0 lux/W D 66.0 % D 240 m3/h 581 m3/h 45 dB 66 dB N/A N/A
* A (most efficient) to G (least efficient)
DISPOSAL As a responsible retailer we care about the environment. As such we urge you to follow the correct disposal procedure for the appliance and packaging materials. This will help conserve natural resources and ensure that it is recycled in a manner that protects health and the environment. You must dispose of this appliance and its packaging according to local laws and regulations. Because this appliance contains electronic components, the appliance and its accessories must be disposed of separately from household waste when the appliance reaches its end of life. Contact your local authority to learn about disposal and recycling. The appliance should be taken to your local collection point for recycling. Some collection points accept appliance free of charge. We apologise for any inconvenience caused by minor inconsistencies in these instructions, which may occur as a result of product improvement and development. Darty Holdings SAS © 14 route d’Aulnay, 93140 Bondy, France 22/06/2016 THOMSON is a trademark of Technicolor or its Affiliates used under license by DARTY
ManualGo.com