CA1051 - Coffee machine JATA - Free user manual and instructions

USER MANUAL CA1051 JATA

Labeled diagram of a coffee machine with numbered parts for identification and assembly reference.

DATOS TÉCNICOS • DADOS TECNICOS • TECHNICAL DATA

Marzo 2019

Mod. CA1051

230 V~

50/60 Hz

950 W

1. Water tank lid.

2. Filter holder anchorage.

3. Warming cups plate.

4. Pilot light.

5. Steam regulator.

6. Steamer.

7. On / off button.

8. 1 cup button.

9. 2 cups button.

10. Filter holder.

11. Filter for 1 cup.

12. Filter for 2 cups.

13. Water tank.

14. Tray.

15. Spoon.

16. Needle.

COMPONENTI PRINCIPALI

- Carefully read these instructions before using the coffee maker for the first time and keep them for future enquiries.

- This appliance can be used by children at the age of 8 or more and people with physical, sensory or mental capabilities or lack of experience and knowledge if they have been given an appropriate supervision or instruction concerning the safety use of the appliances and understand the dangers involved.

- Keep all plastic bags and packaging components out of the reach of children. They are potentially dangerous.

- Do not connect the coffee maker to the mains without checking that the voltage on the rating plate and that of your household are the same.

- Make sure the plug has an adequate earth base.

- Don't allow children play with the appliance. Keep the appliance out of the reach of children.

- Keep the appliance and the cable cord out of the reach of children less than 8 years old.

- VERY IMPORTANT: do not immerse the appliance in water or other liquids.

- Never use the jug on an electric or gas cooker, nor in a microwave, do not use it when it has a fissure.

- Avoid placing the jug on a cold or wet surface.

- Do not remove the filter holder when the coffee maker is working. You must wait until all the water and steam have come out of the tank.

- This appliance is designed for domestic use only.

• The cleaning and maintenance done by users, can not be done by children without any supervision, unless they are over 8 years and they are under supervision.
• If the cable were to deteriorate it must be changed by an Authorised Service Centre.

INSTRUCTIONS OF USE

BEFORE THE FIRST USE

• Before using the coffee maker for the first time, clean the filters, the spoon, the water tank and the steam with soap and water. Rinse well all the components.
• You also can clean the inner side of the coffee maker, to do it, fill the filter with water and switch it on several times without coffee.

START

• Open the water tank lid (1) and remove the water tank (13). Fill with clean and fresh water till the MAX indication and insert the water tank in its place.
• Plug the coffee maker to the mains and push the on button (7). The pilot light will flash.
• When connecting the coffee maker for the first time, it must be pre-heated. To do it, press the buttons 1 and 2 cups (8 and 9) at the same time during 3 seconds. The coffee maker will start to heat and the indicator light (4) will flash till reaching the correct temperature to make coffee, keeping the light fixed.

COFFEE

• Before making any operation, always be sure that the steam regulator (5) is in off position “-”.
• Chose the filter (11 or 12), place it in the filter holder (10) and fill it depending on the coffee quantity you need:
• 1 cup of coffee: fill the filter for 1 cup (11) with the spoon filled of ground coffee (7 g).
• 2 cups of coffee: fill the filter for 2 cups (12) with the spoon filled twice of ground coffee (14 g).
• Press the coffee with the back side of the spoon, being sure there is not coffee remains in the edge of the filter holder.
• Insert the filter holder (10) in its place by aligning the handle with the indication ☐, pushing up and turning to the right, to the 🔒 indication until it is correctly inserted. Make sure that the handle of the filter holder stays in perpendicular position when closing (90°).
• Place the cup or the cups in the tray (14) under the filter holder and switch on the coffee maker into the mains.
• Press the button for 1 cup (8) to get a cup of coffee with (50 ml) or 2 cups button if you need 2 coffee cups with (100 ml). It will switch on the pilot light (2) and the coffee will start to flow. Once reached the programmed quantity, it will stop. You can press the same button to stop the coffee outlet.
• Once finished, press the off button (7) and unplug the appliance.

ADJUST THE COFFEE VOLUME

• Press the button for 1 cup or 2 cups (8 and 9) during 3 seconds. The indicator light (4) will flash and the coffee will start to flow.
• Press the same button to stop the coffee outlet.
• The coffee maker will memorize that coffee quantity and once pressed the buttons for 1 cup or 2 cups (8 or 9) you will get that programmed quantity of coffee.
• Note:
• Maximum adjustable volume is 200 ml.
• Minimum adjustable volume is 30 ml.
• To adjust again the original quantity, press the buttons 1 and 2 at the same time during 3 seconds. The pilot light (4) will flash and the adjustable volume will change once the pilot light stops flashing.

WARMING CUPS

- Place the cups upside down in the warming plate (3). When the coffee maker is hot, the plate with heat the cups. The heated cups help to create and keep a frothy coffee.

ATTENTION

The coffee maker will switch off automatically after around 15 minutes from its operation, to comply with Directive 2009/125/EC of the European Parliament.

STEAM

• This coffee maker is provided with a steamer (6) to heat milk or other liquids.
• Turn the steam regulator (5) to the "lul" position, doing that the coffee maker will reach the correct temperature to create steam. The pilot light (4) will start to flash, when it is already fixed, the coffee maker will have reached the temperature and it is ready to generate steam.
• Pour the liquid to be heated into a jar or another container and insert the steamer into it. Turn the steam regulator (5) into the steam position (☐). The steam will start to go out and the pilot light (4) will be flashing at the same time.
• Once the liquid is hot, turn the steam regulator (5) to the off position “-”, the steam will stop and the indicator will be fixed.

MAINTENANCE AND CLEANING

• Before you proceed to cleaning make sure the coffee maker is unplugged from the mains.
• Remove the tray to clean it.
• Clean the coffee maker body with a slightly damp cloth.
• Do not use abrasive or chemical products, metallic scourers, etc. which may deteriorate the surfaces of the appliance.
• Once a month, depending on the use that is given to the coffee maker, it is convenient to proceed with the cleaning of the deposit to eliminate the calcareous remains that the water can leave. It is convenient to treat them as follows:

- Pour a 50% white vinegar solution into the tank and wait for 15 minutes.

- Plug in the coffee maker without coffee in the filter and allow all the solution to flow out.

- Next, make the coffee maker work only with water a couple of times.

- Cleaning the steamer: in case of obstruction use the included needle (16) to clean the steam hole.

ENVIRONMENT PROTECTION

• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.

ATTENTION

GARANTIA GERAL (2 ANOS) - GARANTIA TOTAL

In the rest of countries, the holder of the guarantee will enjoy all the rights that his legislation in force concedes.

FRANÇAIS: