KN-COP-DP-10YB - Gas detector KIDDE - Free user manual and instructions
Find the device manual for free KN-COP-DP-10YB KIDDE in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Type | Carbon Monoxide (CO) Detector |
| Brand | KIDDE |
| Model | KN-COP-DP-10YB |
| Sensor Type | Electrochemical |
| Display | Digital LCD showing CO concentration in PPM |
| Power Source | 2 x AA alkaline batteries (included) |
| Alarm Loudness | 85 dB at 10 feet (3 meters) |
| Test/Reset Button | Yes |
| Peak Level Memory | Displays the highest CO level recorded |
| End of Life Warning | Chirps and displays "End" after 10 years |
| Operating Temperature | 4°C to 38°C (40°F to 100°F) |
| Operating Humidity | 5% to 95% relative humidity |
| Dimensions (H x W x D) | 114 x 81 x 38 mm (4.5 x 3.2 x 1.5 inches) |
| Weight | 227 g (0.5 lbs) |
| Installation | Wall-mount or tabletop |
| Certification | UL 2034 listed |
| Warranty | 10-year limited warranty |
| Maintenance | Test weekly; vacuum dust from vents monthly |
| Spare Parts | No user-serviceable parts; batteries replaceable |
| Safety | Complies with UL 2034 and NFPA 720 requirements |
Frequently Asked Questions - KN-COP-DP-10YB KIDDE
How do I install the KN-COP-DP-10YB carbon monoxide detector?
Mount the detector on a wall or ceiling using the included bracket. Place it at least 5 feet (1.5 meters) above the floor, away from fuel-burning appliances and humidity sources. Insert two AA batteries and test the unit.
What does the digital display show?
The digital LCD shows the current carbon monoxide concentration in parts per million (PPM). It updates every 15 seconds. When CO is detected, the display backlight turns red and the alarm sounds.
How do I test the alarm?
Press and hold the Test/Reset button for 5 seconds. The alarm should sound 4 beeps, then 4 pauses, and the display will show "XXX" or "888" to verify the sensor and electronics are working. If not, replace the batteries or the unit.
What should I do when the CO alarm sounds?
Immediately move to fresh air and call emergency services. Do not re-enter the premises until it has been aired out and the source identified. If the alarm is a low battery chirp, replace the batteries.
How long does the battery last?
The detector uses 2 AA alkaline batteries, which typically last up to 1 year depending on usage. The low battery warning chirps every 30 seconds for at least 30 days. Replace both batteries at the same time.
What is the end-of-life warning?
After approximately 10 years of operation, the detector will chirp 2 times every 30 seconds and display "End". Replace the entire unit immediately.
Can I temporarily silence the alarm with the Test/Reset button?
Yes, pressing the Test/Reset button silences the alarm for about 5 minutes in case of a nuisance alarm. However, if the CO level is still high after that, the alarm will sound again. Only use this feature if you are sure the danger is not real.
How do I clean and maintain the detector?
Dust the vents with a soft brush or vacuum cleaner at least once a month. Do not use solvents or sprays. Test the unit weekly by pressing the Test/Reset button. Keep it away from paint, smoke, and strong fumes.
Where should I place the detector in my home?
Install one on every floor and in each sleeping area. Ideal locations are on walls or ceilings near bedrooms. Avoid installing near kitchens, garages, or heating vents to prevent false alarms. Keep it at least 5 feet from fuel-burning appliances.
What is the Peak Level Memory feature?
The detector records the highest CO concentration since the last reset. Press the Peak Memory button to view the peak value on the display. Hold the button to clear the memory. This helps you identify exposure levels during an event.
User questions about KN-COP-DP-10YB KIDDE
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Gas detector in PDF format for free! Find your manual KN-COP-DP-10YB - KIDDE and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. KN-COP-DP-10YB by KIDDE.
USER MANUAL KN-COP-DP-10YB KIDDE
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : KIDDE
Model : KN-COP-DP-10YB
Category : Gas detector