FLVG7523BW - Tumble dryer FRIGIDAIRE - Free user manual and instructions
Find the device manual for free FLVG7523BW FRIGIDAIRE in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Freestanding tumble dryer |
| Brand | Frigidaire |
| Model Number | FLVG7523BW |
| Capacity | 7.5 cubic feet |
| Drying System | Automatic moisture sensing |
| Control Type | Dial selector with push-button settings |
| Heat Settings | Low, Medium, High, Air Dry |
| Drying Cycles | Normal, Heavy Duty, Delicates, Quick Dry, Wrinkle Release, Air Dry |
| Sensor Dry | Yes |
| Drum Material | Stainless steel |
| Lint Filter | Removable top lint screen |
| Door Swing | Reversible - can be installed to open left or right |
| Vent Type | 4-inch rear or side venting |
| Dimensions (W x D x H) | 27" x 28.5" x 43.5" (68.6 x 72.4 x 110.5 cm) |
| Weight | 120 lb (54 kg) |
| Power Supply | 120 V, 60 Hz, 15 A (gas-powered; requires natural gas or LP connection) |
| Safety Features | Door switch stops the drum when opened; thermal fuse protects against overheating |
| Maintenance | Clean lint screen after every load; inspect and clean vent system periodically |
| Spare Parts & Repairability | Manufacturer-approved replacement parts and service available; user-accessible filter and drum components |
Frequently Asked Questions - FLVG7523BW FRIGIDAIRE
How often should I clean the lint filter?
Clean the lint screen before or after every load. A clogged lint filter reduces airflow, making drying less efficient and increasing the risk of fire. The filter is located on top of the dryer under the door; simply pull it out, roll off lint, and replace it.
Why does my dryer take too long to dry clothes?
Check for lint buildup in the filter and venting, which is the most common cause. Also make sure the load is not too large and that the selected cycle matches the fabric type. If the moisture sensor is dirty, clean it gently with a soft cloth and mild detergent.
Can I install this dryer in a small closet?
Yes, but the dryer must be vented to the outside with a rigid or flexible metal duct. Keep clearance as recommended in the manual, typically at least 1 inch on sides and 5 inches from the rear, to ensure proper airflow and prevent overheating.
What type of venting does this dryer require?
This is a vented dryer that uses a 4-inch metal exhaust duct. Plastic or foil ducts are not recommended because they can sag and trap lint. The vent should be as short and straight as possible for maximum efficiency.
Can I plug this gas dryer into a standard wall outlet?
Yes, the gas dryer uses standard 120 V power for the drum motor, controls, and ignition. However, gas connection requires a dedicated natural gas or LP supply line with an approved shut-off valve. Installation must be done by a qualified technician or according to local codes.
How do I reverse the door on this dryer?
Reversing the door involves removing the door hinge screws, moving the door catch and striker, and reattaching the door from the opposite side. Detailed instructions can be found in the user manual; a non-magnetic screwdriver is usually the only tool required.
Why does my dryer stop before the clothes are completely dry?
The automatic moisture sensor may be over-sensing due to high humidity in the room, a dirty sensor, or improper load size. Try using the More Dry or High Heat setting, clean the sensor strips, and ensure the vent is unobstructed. If the problem persists, use a timed drying cycle.
How do I clean the moisture sensor?
The moisture sensor strips are located in the drum near the lint filter opening. Wipe them gently with a soft cloth and a little rubbing alcohol to remove residue. Do not scrape them. Clean every 6 months to maintain accurate dryness readings.
What is the maximum load capacity for this dryer?
The dryer has a 7.5 cubic foot drum, which can handle approximately 35-40 pounds of dry clothes depending on fabric weight. For best results, follow the one third full rule for bulky items to allow proper tumbling.
Does this dryer have a wrinkle release setting?
Yes, the Wrinkle Release cycle periodically tumbles clothes without heat to prevent wrinkles after the cycle ends. You can also press the Wrinkle Release option before starting to add a short cool-down period after drying.
User questions about FLVG7523BW FRIGIDAIRE
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Tumble dryer in PDF format for free! Find your manual FLVG7523BW - FRIGIDAIRE and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. FLVG7523BW by FRIGIDAIRE.
USER MANUAL FLVG7523BW FRIGIDAIRE
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : FRIGIDAIRE
Model : FLVG7523BW
Category : Tumble dryer