4300 - Saw Vevor - Free user manual and instructions
Find the device manual for free 4300 Vevor in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product type | Circular saw |
| Brand | Vevor |
| Model | 4300 |
| Power | 4300 W |
| Power supply | 230 V / 50 Hz |
| Blade diameter | 250 mm |
| Rotation speed | 2800 rpm |
| Maximum cutting depth | 90 mm at 90°, 60 mm at 45° |
| Cutting angle | 0 to 45 degrees |
| Dimensions (L x W x H) | 80 x 60 x 70 cm |
| Weight | 25 kg |
| Main functions | Straight cuts, angle cuts, cross cuts |
| Maintenance and cleaning | Dust regularly, lubricate moving parts |
| Safety | Blade guard, safety switch, anti-restart |
| Spare parts and repairability | Replacement blades, motor carbon brushes, belts available |
| General information | Domestic and professional use, detailed manual provided |
Frequently Asked Questions - 4300 Vevor
How to change the blade on the Vevor 4300 saw?
Unplug the device, use a wrench to loosen the central nut, remove the flange and the blade. Install the new blade respecting the rotation direction, tighten the nut and plug it back in. Refer to the manual for the tightening torque.
What is the maximum cutting depth of this saw?
The maximum cutting depth is 90 mm at 90 degrees and 60 mm at 45 degrees. Adjust the depth according to the thickness of the material to be cut.
Can I use this saw to cut metal?
No, this saw is designed for wood and derived materials. For metal, use an appropriate blade and reduce the speed, but this is not recommended by the manufacturer.
How to adjust the cutting angle?
Loosen the angle locking handle, tilt the base plate to the desired angle (0 to 45 degrees), then tighten the handle. Check the angle with a square.
What to do if the blade jams during cutting?
Release the trigger immediately, unplug the saw, and remove the piece. Check that the blade is sharp and that the cutting depth is suitable. Never force the blade.
What periodic maintenance is necessary?
Clean the ventilation openings and the base plate after each use, lightly grease the moving parts, check the tightening of screws and the condition of the power cord. Replace the motor carbon brushes every 200 hours.
Can I use blades of different diameters?
No, use only 250 mm blades with a compatible bore. An incorrectly sized blade may damage the protective guard and cause accidents.
How to change the motor carbon brushes?
Unplug the saw, locate the brush holders on the motor, flip down the caps, remove the worn brushes, insert the new brushes and close the caps. Use brushes of the same size.
The saw has a blade guard. How to maintain it?
The protective guard must be cleaned so that it pivots freely. Regularly check that it returns to position automatically after cutting. If the system is stuck, contact a professional.
Where can I find the detailed manual for the Vevor 4300 saw?
The complete manual is downloadable from notice-facile.com. You will find diagrams, safety instructions and troubleshooting procedures. Keep the manual at hand.
User questions about 4300 Vevor
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Saw in PDF format for free! Find your manual 4300 - Vevor and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 4300 by Vevor.
USER MANUAL 4300 Vevor
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Vevor
Model : 4300
Category : Saw