KH 228 WET AND DRY LADY SHAVER - Electric shavers BALANCE - Free user manual and instructions
Find the device manual for free KH 228 WET AND DRY LADY SHAVER BALANCE in PDF.
User questions about KH 228 WET AND DRY LADY SHAVER BALANCE
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Electric shavers in PDF format for free! Find your manual KH 228 WET AND DRY LADY SHAVER - BALANCE and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. KH 228 WET AND DRY LADY SHAVER by BALANCE.
USER MANUAL KH 228 WET AND DRY LADY SHAVER BALANCE
natural_image
Three different types of hairbrushes shown in blue, yellow, and white (no visible text or symbols)Operating and safety instructions
page 4 - 6

text_image
Diagram of a 3D mechanical part with numbered parts labeled ① to ⑥
text_image
Labeled anatomical diagram of an insect larva with numbered parts for identification
natural_image
Simple line drawing of a mechanical component or device (no text or symbols)
natural_image
Simple line drawing of a mechanical device with no visible text or symbols
natural_image
Simple line drawing of a mechanical component or device with no visible text, numbers, or symbols.Safety advice
Please read carefully through the following information about safety and proper use.
Before reading, fold out the page with the illustrations and make yourself familiar with all the functions of the shaver.
Be careful to keep these safety advice notes and if necessary pass them on to a third party.
△ Warning! People with sensitive skin or allergies to cosmetics or similar conditions who suffer sudden skin irritations in reaction to shaving should first try the shaver on a small place on an arm or leg as a test.
△ To avoid injury, never use the shaver if it has a damaged foil or cutter.
△ Never allow the shaver to be immersed in water for long periods.
△ Never use shaving cream. It could cause the inner cutter to stick.
△ Only use shaving foam or soap lather.
△ Clean the shaver under running water.
△ Do not use salty water, cleaning agents or hot water.
△ Do not dismantle the shaver body as this can lead to an ineffective watertight seal.
△ If the shaver does not work properly, have it examined at an authorised service centre.
△ Use the shaver only for the purposes described above.
Before using for the first time
This wet/dry lady shaver can be used with shaving foam as a wet shaver or a dry shaver. It is also intended for use in the shower. Tests have shown that better results are achieved with warm water and shaving foam.
The shaver is perfect for use in the shower.
Try using it as a wet shaver with shaving foam for about 3 weeks and experience the difference compared to dry shaving.
Cleaning is child's play. Just rinse the shaving head under running water. It's that easy.
Description of components
① Protective cap
② Housing for outer foil
③ Outer foil
④ Outer cutter/long hair trimmer
⑤ Guide
⑥ Inner cutter
⑦ Inner cutter support block
⑧ Shaving head release button
⑨ On/Off switch
⑩ Continuous operation switch
⑪ Battery compartment lid
Changing the batteries
Change the batteries when required without delay (see Figs. 12 to 14). If the cutter motion becomes slower, it is time to change the batteries.
Never use the shaver if the batteries are weak.
1) Remove the battery compartment lid ⑪ (see ⑫).
2) After checking the correct polarity, insert two AA batteries (see 13).
3) Refit the battery compartment lid again (see 14).
You should remove the batteries if the shaver is to remain unused for a long period.
Using the shaver
- Apply a generous amount of shaving foam to your skin.
- Take off the protective cap ① and switch on the shaver ⑨.
- You will obtain the best results if you move the shaver up and down keeping the shaving head flat against your skin so that the foil and cutters are able to work effectively at the same time. If necessary, trim long hairs with the trimmer ④ before shaving.
Maintenance/cleaning
Press the release button ⑧ to release the shaving head and take off the housing.
Switch on the shaver and rinse the inner cutter under running water.
DO NOT USE HOT WATER!
Then switch off the shaver, close the housing and dry carefully. When the shaving head is dry, replace the protective cover ①.
Statement of conformity
We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, Germany, hereby declare that this product conforms with the following EC regulations:
EC low voltage regulations, Electromagnetic compatibility, Applicable harmonised standards.
Type / Description: Wet and dry lady shaver KH 228
Bochum, 31.10.2002

text_image
Kouwen8Hans Kompernaß - Managing Director -