Ready Warm 10100 Smart Ceramic - Heating CECOTEC - Free user manual and instructions

USER MANUAL Ready Warm 10100 Smart Ceramic CECOTEC

ES · Este producto no es adecuado para calefacción primaria. Este producto está indicado únicamente en lugares abrigados o para una utilización puntual. EN · This product is not suitable for primary heating purposes. This product is only suitable for well insulated spaces or occasional use. FR · Ce produit ne convient pas pour une utilisation en tant que chauffage primaire. Cet appareil a été conçu seulement pour être utilisé dans des espaces intérieurs ou pour une utilisation momentanée. DE · Dieses Produkt ist nicht für primäre Heizzwecke geeignet. Dieses Produkt ist nur für gut isolierte Räume oder für den gelegentlichen Gebrauch geeignet. IT · Questo prodotto non è adatto a riscaldamento primario. Questo prodotto è indicato solamente per luoghi caldi o per uso sporadico. PT · Este produto não é adequado para ser utilizado como aquecimento primário. Destina-se a uma utilização ocasional e apenas em locais abrigados. NL · Dit product is niet geschikt voor primaire verwarming. Dit product is alleen geschikt voor gebruik op beschutte plaatsen of voor incidenteel gebruik. PL · Ten produkt nie nadaje się do pierwotnego ogrzewania. Ten produkt jest wskazany tylko do miejsc ostoniętych lub do okazjonalnego użytku. CZ · Tento produkt není vhodný pro primární vytápění. Tento výrobek je určen pouze na topení na chráněných místech nebo pro príležitostné použití.

Manual de instrucciones Instruction manual Manuel d'instructions Bedienungsanleitung Manuale di istruzioni Manual de instruções Handleiding Instrukcja obsługi Návod k použití

Instrucciones de seguridad 4
Safety instructions 5
Instructions de sécurité 6
Sicherheitshinweise 8
Istruzioni di sicurezza 9
Instruções de segurança 10
Veiligheidsvoorschriften 12
Instrukcje bezpieczeństwa 13
Bezpečnostní pokyny 15

ÍNDICE

1. Parts and components 21
2. Before use 21
3. Operation 21
4. Cleaning and maintenance 23
5. Technical specifications 23
6. Disposal of old electrical appliances 23
7. Technical support and warranty 24

SOMMAIRE

Read these instructions thoroughly before using the appliance. Keep this instruction manual for future reference or new users.

• Make sure that the mains voltage matches the voltage stated on the rating label of the appliance and that the wall outlet is grounded.
• Check the power cord regularly for visible damage. If the cord is damaged, it must be replaced by the official Technical Support Service of Cecotec in order to avoid any type of danger.
• The appliance must not be placed immediately below a socket.
• Do not place the appliance close to heat sources, flammable substances, wet surfaces or allow it to come into contact with water or other liquids. Do not operate outdoors.
• Do not introduce or allow objects to be introduced in the air inlet or outlet, this could cause risk of electrical shock, fire or damage.
• If the appliance falls into water, do not touch it and unplug it immediately.
• Do not immerse the cord, plug, or any non-removable part

of the appliance in water or any other liquid, nor expose the electrical connections to water. Make sure your hands are dry before handling the plug or switching on the appliance.

• Always turn off and unplug the appliance when not in use and before moving it to a new location. Pull from the plug, not the cord, to disconnect it from the outlet.
• The appliance is not intended to be used by children under the age of 8.
• It can be used by children over the age of 8, as long as they are given continuous supervision.
• This product can be used by children and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, as long as they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Supervise young children to make sure that they do not play with the appliance. Close supervision is necessary when the appliance is being used by or near children.

INSTRUCTIONS DE SÉCURITÉ

• Take the product out of the box and remove all packaging materials.
• Check for any visible damage. If any is observed, contact as soon as possible the Technical Support Service of Cecotec for advice or reparation.
  – Always place the device on a flat and stable surface.

3. OPERATION

• Turn on the device's power switch. The appliance's default temperature is 25 °C.
• The display will show it while it is operating. Press to access the control panel.

Control panel and remote control

Fig. 2

1. Decrease temperature
2. Increase temperature
3. On/Off button
4. Mode selection
5. Rotation function
6. Timer

Power level

1. Press Fig. 3. once to activate the low power heating mode.
2. Press Fig. 3. twice to activate the high power heating mode.

ENGLISH

Timer

Press the clock icon repeatedly to select the time at which you want the appliance to automatically turn off. It can be set from 1 to 8 hours, in 1-hour intervals.

Oscillation

1. Press on the inverted arrow to activate or deactivate the oscillation mode.
2. Press the up/down buttons to increase or decrease the set temperature.

Warnings

• The temperature can be set from 0 °C to 49 °C.
• The appliance will automatically switch to the High power heating mode when the room temperature falls 4 °C below the set one.
• The appliance will automatically switch to the Low power heating mode when the room temperature falls from 0 °C to 2 °C below the set one.
• The device will automatically turn off when the room temperature is higher than the set one. The fan will activate during 30 seconds to cool down the appliance and then will enter standby mode. If the room temperature falls 2°C below the set temperature, the device will automatically turn back on.

Press the On/off button to turn the device off. The fan will run for 30 seconds before the appliance turns completely off.

Tip-over safety system

The heater is designed to turn automatically off when tipped forward or backward. The unit will automatically turn on once it is returned to its normal upright position.

Protection against overheating system

The heater features a protection system that turns the appliance automatically off in case of overheating, for example, when the air inlet or outlet is partially or completely obstructed. If this happens, follow the below steps:

1. Unplug the appliance and wait for 30 minutes approx. until it cools down.
2. Clear the obstruction from the air outlet or inlet.
3. Turn it on again. The appliance should now work properly.

Remote control

Note

The remote control requires 1 x CR2025 3V battery (not included).

1. Slide the battery compartment's cover down to open it.
2. Introduce the battery in the compartment paying attention to the battery poles (see the below image).

3. Close the battery compartment.

Warning

Keep the batteries out of the reach of children.

Fig. 4

4. CLEANING AND MAINTENANCE

– Turn off and unplug the appliance and allow it to cool down before cleaning it.
- Do not use abrasive cleaners or scouring pads to clean the product.
- Use a soft, dampened and clean cloth to clean the product's outer housing. Be careful not to touch the heating element.
- One of the most common causes of overheating is the building up of debris or fluff in the appliance. Make sure to clean it periodically and to vacuum the ventilation grilles.
- If the product is not going to be used for a long period of time, unplug it and store it in a dry and safe place where it is protected from dust.
- Do not disconnect the appliance from the plug, turn it off with the button to avoid it from overheating.

5. TECHNICAL SPECIFICATIONS

Product reference: 05314

Product: Ready Warm 10010 Smart Ceramic

Power and voltage: 2200 W, 220-240 V, 50 Hz

Made in China | Designed in Spain

6. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), specifies that old household electrical appliances must not be disposed of with the normal unsorted municipal waste. Old appliances must be collected separately, in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment.

The crossed out "wheeled bin" symbol on the product reminds you of your obligation to dispose of the appliance correctly.

Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries.

7. TECHNICAL SUPPORT AND WARRANTY

This product is under warranty for 2 years from the date of purchase, as long as the proof of purchase is submitted, the product is in perfect physical condition, and it has been given proper use, as explained in this instruction manual.

The warranty will not cover the following situations:

• The product has been used for purposes other than those intended for it, misused, beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any other fault attributable to the customer.
• The product has been disassembled, modified, or repaired by persons, not authorised by the official Technical Support Service of Cecotec.
• Faults deriving from the normal wear and tear of its parts, due to use.

The warranty service covers every manufacturing defects of your appliance for 2 years, based on current legislation, except consumable parts. In the event of misuse, the warranty will not apply.

If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact Cecotec Technical Support Service at [phone].

1. PIÈCES ET COMPOSANTS

Img.1

Product: Ready Warm 10010 Smart Ceramic

Vermogen en voltage: 2200 W, 220-240 V, 50 Hz

Made in China | Designed in Spain

6. RECYKLING SPRZĘTU AGD

Fig./Img./Abb./Rys./Obr.3

Fig./Img./Abb./Rys./Obr.4

www.cecotec.es