20472.N - Unclassified Vimar - Free user manual and instructions
Find the device manual for free 20472.N Vimar in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Brand | Vimar |
| Product Type | Staircase timer switch |
| Model | 20472.N |
| Power Supply | 230 V AC, 50 Hz |
| Maximum Switching Current | 10 A for resistive loads, 4 A for inductive loads |
| Number of Channels | 1 |
| Time Range | 30 seconds to 20 minutes |
| Control Method | Push-button or switch input |
| Mounting Type | 35 mm DIN rail |
| Module Width | 1 module (17.5 mm) |
| Depth | 58 mm |
| Net Weight | 110 g |
| Protection Degree | IP20 |
| Operating Temperature | -20 °C to +50 °C |
| Wire Cross Section | Up to 2.5 mm² |
| Status LED | Yes, indicates power and output state |
| Enclosure Material | Self-extinguishing plastic |
| Safety Features | Reinforced insulation, protected against voltage surges |
| Maintenance | No regular maintenance required |
| Repair Policy | No user-serviceable parts; contact authorized Vimar service |
| Compliance | CE, IEC 60669 |
| Package Contents | Timer module, mounting instructions |
Frequently Asked Questions - 20472.N Vimar
What is the default switch-off delay?
The default delay is set to approximately 1 minute, but you can adjust it using the front control knob.
Can I use LED lamps with this timer?
Yes, for LED lamps you must use a compatible ballast or a parallel resistor to avoid flickering. Refer to the manual for recommended wiring.
How do I set the on-time?
Turn the adjustment knob on the front to the desired time, from 30 seconds up to 20 minutes.
What does the LED indicator mean?
The LED shows that the timer is powered and also indicates the output state - it lights when the load is switched on.
How do I reset the timer during a cycle?
Press the connected push-button again; the timing restarts from the preset value.
Can it control other loads besides lighting?
Yes, it can switch resistive loads such as fans, heaters, and coils, provided the current does not exceed 10 A.
Does the module require a neutral wire?
No, the module is designed for a two-wire connection - only line and switched line are needed.
What is the maximum switching current?
The maximum current is 10 A for resistive loads and 4 A for inductive loads like motors or relays.
How to connect a push-button for manual control?
Connect the push-button to the control input terminal and the line supply as shown in the wiring diagram in the manual.
Is the Vimar 20472.N compatible with three-wire wall switches?
Yes, it works with common three-wire switches and can also be used with push-buttons for staircase lighting control.
User questions about 20472.N Vimar
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Unclassified in PDF format for free! Find your manual 20472.N - Vimar and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 20472.N by Vimar.
USER MANUAL 20472.N Vimar
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Vimar
Model : 20472.N
Category : Unclassified