CPS180PHN - Inverter CyberPower - Free user manual and instructions
Find the device manual for free CPS180PHN CyberPower in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | UPS Inverter |
| Model | CPS180PHN |
| Brand | CyberPower |
| Input Voltage | 120V AC |
| Output Voltage | 120V AC |
| Capacity | 180 VA / 90 W |
| Battery Type | Sealed Lead-Acid |
| Number of Outlets | 4 |
| Dimensions (W x D x H) | 6.0 x 3.0 x 12.0 inches |
| Weight | 5.0 lbs |
| Runtime at Half Load | Approximately 10 minutes |
| Surge Protection | Yes |
| Warranty | 3 years |
| Maintenance | Keep clean and replace battery every 3-5 years |
| Safety Certifications | UL, cUL |
Frequently Asked Questions - CPS180PHN CyberPower
How do I replace the battery in my CyberPower CPS180PHN?
Turn off the UPS and unplug it. Open the battery compartment on the bottom, disconnect the wires, and replace with a same-specification lead-acid battery (e.g., CyberPower RB1290). Reconnect and close the compartment.
What is the runtime of the CPS180PHN at full load?
At full load (90W), the runtime is approximately 2-3 minutes. At half load (45W), it extends to about 10 minutes.
Can I connect a generator to the CPS180PHN?
Yes, but ensure the generator produces clean power (e.g., inverter generator) and do not exceed input voltage limits. It is recommended to connect the generator to the UPS only when the UPS is in bypass mode.
How do I test the UPS?
Press and hold the test button on the front panel for 2 seconds. The UPS will run a self-test, checking battery and circuits. An alarm may sound briefly.
What types of devices can the CPS180PHN support?
It is designed for small electronics such as computers, monitors, routers, and modems. Total wattage should not exceed 90W.
Is the CPS180PHN noisy?
Under normal operation, it is nearly silent. An alarm sounds during battery mode or low battery, and the fan may activate under heavy load.
How do I install the CPS180PHN?
Place the UPS on a flat surface near the devices. Plug the UPS into a wall outlet. Connect your devices to the battery backup outlets. Turn on the UPS by pressing the power switch. Allow the battery to charge for 24 hours before first use.
How do I reset the UPS after a fault?
Unplug the UPS from AC power and turn off. Wait 30 seconds, then plug back in and turn on. If the fault persists, refer to the manual or contact CyberPower support.
How long does the battery last before needing replacement?
The battery typically lasts 3 to 5 years depending on usage and environment. Replace sooner if runtime decreases significantly.
Where can I purchase a replacement battery for the CPS180PHN?
Replacement batteries can be purchased from the CyberPower website or authorized dealers. Use model RB1290 for compatibility.
User questions about CPS180PHN CyberPower
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Inverter in PDF format for free! Find your manual CPS180PHN - CyberPower and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. CPS180PHN by CyberPower.
USER MANUAL CPS180PHN CyberPower
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : CyberPower
Model : CPS180PHN
Category : Inverter