Architect Model P250 EQ - Receiver AudioControl - Free user manual and instructions
Find the device manual for free Architect Model P250 EQ AudioControl in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Stereo Receiver with Graphic Equalizer |
| Brand | AudioControl |
| Model | Architect Model P250 EQ |
| Power Output | 250W per channel (2 channels) into 8 ohms |
| Frequency Response | 20 Hz - 20 kHz ±0.5 dB |
| Total Harmonic Distortion (THD) | < 0.05% |
| Signal-to-Noise Ratio | > 100 dB |
| Input Impedance | 47 kΩ |
| Number of Inputs | 5 line-level inputs (RCA), 1 phono input |
| Number of Outputs | Preamp outputs, speaker outputs (binding posts), headphone jack |
| Equalizer Bands | 10-band graphic equalizer per channel |
| Dimensions (W x H x D) | 17 x 5.25 x 14 inches (432 x 133 x 356 mm) |
| Weight | 28 lbs (12.7 kg) |
| Power Consumption | 500 W max, < 1 W standby |
| Power Supply | 120V/60Hz (US), 230V/50Hz (EU) switchable |
| Cooling | Fanless, convection cooled |
| Chassis Material | Brushed aluminum front panel, steel chassis |
| Remote Control | Infrared remote included |
| Additional Features | Loudness contour, mono/stereo switch, tape monitor loop, rack mountable |
| Cleaning Instructions | Wipe with a soft, dry cloth; avoid solvents |
| Safety | Class I, grounded; do not expose to moisture |
| Repairability | Serviceable by qualified technician; schematic available |
Frequently Asked Questions - Architect Model P250 EQ AudioControl
How do I set up the graphic equalizer?
Use the sliders on the front panel to adjust each frequency band. Start with all sliders at the center (0 dB) position, then adjust based on your listening preference or room acoustics. Use the EQ bypass switch to compare with and without equalization.
What is the recommended speaker impedance?
The receiver is designed for speakers with an impedance of 4 to 16 ohms. For best performance, use 8 ohm speakers. Ensure the total load is within the amplifier's rating.
How do I connect a turntable?
Connect your turntable's RCA cables to the phono input. If your turntable has a moving magnet (MM) cartridge, the phono preamp is built-in. For moving coil (MC) cartridges, you may need an external preamp. Ensure the ground wire is connected to the grounding terminal.
The receiver does not power on; what should I check?
First, ensure the power cord is securely connected to the wall outlet and the receiver. Check the power switch on the front panel. If using a power strip, make sure it is turned on. Also, verify that the standby LED is lit. If not, inspect the fuse (located near the power inlet) and replace if blown.
How do I use the tape monitor loop?
Connect your tape deck's record out to the receiver's tape monitor input, and the tape deck's playback in to the receiver's tape monitor output. Press the tape monitor button on the front panel to listen to the tape signal. This loop is also useful for external processors.
What is the loudness contour feature?
The loudness contour boosts low and high frequencies at lower volume levels to compensate for the ear's reduced sensitivity. Press the loudness button to engage it. It is typically used when listening at low volumes.
Can I bi-amp my speakers with this receiver?
The P250 EQ is a two-channel receiver and does not support bi-amping directly. However, you can use an external crossover and a separate amplifier for bi-amping. Alternatively, use the preamp outputs to connect to additional amplifiers.
How do I clean the front panel?
Use a soft, dry cloth to gently wipe the front panel. For stubborn dirt, slightly dampen the cloth with water and mild soap. Avoid abrasive cleaners, alcohol, or solvents that may damage the finish.
Is the receiver rack-mountable?
Yes, the P250 EQ has rack-mount ears attached. It fits a standard 19-inch rack and takes up 3 rack units (5.25 inches) of space. Ensure proper ventilation when rack-mounted.
Where can I find the user manual?
The user manual is available for free download in PDF format from notice-facile.com. Visit the product page for the AudioControl Architect Model P250 EQ and click the download button.
User questions about Architect Model P250 EQ AudioControl
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Receiver in PDF format for free! Find your manual Architect Model P250 EQ - AudioControl and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Architect Model P250 EQ by AudioControl.
USER MANUAL Architect Model P250 EQ AudioControl
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : AudioControl
Model : Architect Model P250 EQ
Category : Receiver