GG38S06AXK - Water heater GE - Free user manual and instructions

Product Type	Electric Water Heater
Brand	GE
Model	GG38S06AXK
Capacity	38 Gallons
Voltage	240V
Wattage	4500W
Dimensions (H x W x D)	48 x 20 x 20 inches
Weight	120 lbs
Energy Factor	0.95
First Hour Rating	45 Gallons
Recovery Rate	21 GPH at 90°F rise
Maximum Temperature	150°F
Tank Material	Glass-Lined Steel
Anode Rod	Aluminum
Insulation	Foam
Warranty (Tank)	6 Years
Warranty (Parts)	1 Year
Safety Features	T&P Relief Valve, Automatic Shut-Off
Maintenance	Drain Annually; Check Anode Rod Every 3-5 Years
Cleaning	Wipe Exterior with Damp Cloth; No Abrasive Cleaners
Repair	Use Genuine GE Parts; Refer to Manual for Part Numbers
Installation	Professional Installation Required; Clearances per Manual

Frequently Asked Questions - GG38S06AXK GE

How often should I drain my GE GG38S06AXK water heater?

It is recommended to drain the water heater at least once a year to remove sediment buildup, which can improve efficiency and extend the lifespan.

What is the warranty period for the GG38S06AXK?

The water heater comes with a 6-year limited warranty on the tank and a 1-year limited warranty on parts. Refer to the manual for full details.

What should I do if my water heater is leaking?

If you notice a leak, first check the T&P relief valve and drain valve. If the leak is from the tank, turn off the power and water supply, and contact a professional. The tank may need replacement.

How do I clean the exterior of the water heater?

Clean the exterior with a soft, damp cloth and mild soap. Do not use abrasive cleaners or solvents, as they may damage the finish.

Can I install the GG38S06AXK myself?

Installation should be performed by a qualified professional to ensure compliance with local codes and safe operation. Improper installation can void the warranty.

What is the recommended temperature setting?

The recommended setting is 120°F (49°C) to balance energy savings and prevent scalding. Higher temperatures increase the risk of burns and energy consumption.

How do I check the anode rod?

Turn off power and water, drain a few gallons, then remove the anode rod from the top of the tank. Inspect for corrosion; if more than 6 inches of core wire is exposed, replace it.

What should I do if the water is not hot enough?

Check the thermostat setting, ensure the circuit breaker is on, and verify that the heating elements are functioning. If the problem persists, consult a professional.

Are there any safety features on this water heater?

Yes, the GG38S06AXK includes a temperature and pressure (T&P) relief valve and an automatic shut-off mechanism to prevent overheating.

Where can I find replacement parts?

Use only genuine GE replacement parts. They can be ordered through authorized dealers or online retailers. Refer to the part numbers listed in the manual.

USER MANUAL GG38S06AXK GE

Federal law prohibits removal of this label before consumer purchase.

ENERGYGUIDE

Capacity (1st hour rating) : 68 GALLONS

Model

GG38S06AXK00

00001

Estimated Yearly Operating Cost

Cost Range of Similar Models