HTX26GASWWW - Tumble dryer HOTPOINT - Free user manual and instructions
Find the device manual for free HTX26GASWWW HOTPOINT in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Tumble Dryer |
| Brand | Hotpoint |
| Model | HTX26GASWWW |
| Fuel Type | Natural Gas or Propane (convertible) |
| Electrical Requirements | 120V, 60Hz, 15A |
| Dimensions (W x D x H) | 27 x 28 x 42 inches |
| Weight | 120 lbs |
| Capacity | 7.0 cu ft |
| Drum Material | Stainless Steel |
| Control Type | Electronic, push-button |
| Number of Cycles | 8 Dry Cycles including Normal, Delicates, Timed Dry |
| Drying System | Moisture Sensor with Auto Dry |
| Temperature Settings | 3 (High, Medium, Low) |
| Lint Filter | Removable, washable mesh |
| Door Swing | Reversible, windowed |
| Venting Type | 4-way rear, left, right, bottom venting |
| Wrinkle Prevent Option | Yes, up to 30 minutes |
| End of Cycle Signal | Adjustable volume |
| CERTIFICATIONS | UL, CSA, ENERGY STAR |
| Warranty | 1 year parts and labor |
Frequently Asked Questions - HTX26GASWWW HOTPOINT
What type of gas connection does this dryer require?
The Hotpoint HTX26GASWWW can use either natural gas or propane. It comes with a natural gas orifice; a propane conversion kit (sold separately) is needed for LP use. Standard 1/2-inch NPT gas supply line is recommended.
Can I vent this dryer through a wall?
Yes, the dryer supports 4-way venting: rear, left, right, and bottom. You can route the exhaust through a wall using a rigid or flexible metal duct. Ensure the vent is not blocked and is as short as possible.
How do I clean the lint filter?
Remove the lint filter from the dryer door opening. Open the filter and gently brush off lint with your fingers or a soft cloth. For deeper cleaning, wash the filter with mild soap and water every few months. Ensure it is completely dry before reinserting.
What should I do if the dryer does not heat?
First, check that the gas supply valve is open and the power cord is plugged in. Examine the circuit breaker or fuse. If the gas is on, the igniter may be faulty. Also ensure the lint filter is clean and the exhaust vent is not clogged. If problem persists, contact a qualified technician.
Can I stack this dryer on a washer?
Yes, a stacking kit (sold separately) is available to mount the HTX26GASWWW on top of a compatible Hotpoint front-load washer. Follow the kit instructions carefully to ensure stability.
What is the recommended clearance around the dryer?
Allow at least 1 inch on the sides and rear, and 2 inches at the front. For closet installations, provide a vent opening of at least 120 square inches to ensure proper airflow.
How do I reverse the door swing?
The door is reversible. Remove the hinge screws, detach the door, swap the hinge and striker plate to the opposite side, then reattach. Instructions are in the user manual; it takes about 15 minutes.
What is the energy consumption of this dryer?
The Hotpoint HTX26GASWWW is ENERGY STAR certified. Typical gas consumption is about 20,000 Btu/hour. Electric consumption for the motor and controls is about 500 watts per cycle.
How do I silence the end-of-cycle buzzer?
Press and hold the 'Signal' button for 3 seconds until the indicator light turns off. The buzzer will be muted. Repeat to re-enable.
Where can I find replacement parts?
Order genuine Hotpoint parts from the manufacturer's website or authorized dealers. Common parts like lint filter, door seal, and gas valve are available. Always use the model number HTX26GASWWW when ordering.
User questions about HTX26GASWWW HOTPOINT
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Tumble dryer in PDF format for free! Find your manual HTX26GASWWW - HOTPOINT and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. HTX26GASWWW by HOTPOINT.