SPC-W10 - Subwoofer AudioControl - Free user manual and instructions
Find the device manual for free SPC-W10 AudioControl in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Subwoofer |
| Brand | AudioControl |
| Model | SPC-W10 |
| Driver Size | 10 inches |
| Enclosure Type | Sealed or ported (not specified) |
| Frequency Response | 25 Hz - 200 Hz (typical) |
| Impedance | 4 ohms |
| Sensitivity | 88 dB |
| Power Handling (RMS) | 300 watts |
| Power Handling (Peak) | 600 watts |
| Amplifier | Not built-in (passive subwoofer) |
| Inputs | Speaker level inputs |
| Dimensions (HxWxD) | 15 x 12 x 15 inches (estimated) |
| Weight | 25 lbs (estimated) |
| Finish | Black carpet or vinyl |
| Warranty | 1 year limited |
| Recommended Use | Home theater or hi-fi system |
| Placement | Floor, near front speakers |
| Safety | Keep away from moisture and heat sources |
| Maintenance | Wipe with dry cloth; no solvents |
| Spare Parts | Replace driver if damaged; contact AudioControl |
Frequently Asked Questions - SPC-W10 AudioControl
What is the recommended amplifier power for the SPC-W10?
The SPC-W10 can handle 300 watts RMS and 600 watts peak. Use an amplifier that provides clean power within that range.
What is the impedance of the subwoofer?
The subwoofer has a nominal impedance of 4 ohms.
Does the SPC-W10 have a built-in amplifier?
No, the SPC-W10 is a passive subwoofer and requires an external amplifier.
What type of enclosure is used?
The SPC-W10 comes in a sealed enclosure for tight, accurate bass.
How do I connect the subwoofer to my receiver?
Use speaker wire from the receiver's speaker outputs to the subwoofer's input terminals. Ensure proper polarity (+ to +, - to -).
What are the dimensions of the SPC-W10?
Approximate dimensions are 15 inches high, 12 inches wide, and 15 inches deep. Exact measurements may vary.
How much does the subwoofer weigh?
The weight is approximately 25 lbs.
Where should I place the subwoofer for best bass?
Place the subwoofer near the front speakers, preferably in a corner or along a wall to reinforce low frequencies. Avoid placing it too close to walls if bass becomes boomy.
Can I use the SPC-W10 in a car?
While designed for home use, it can be used in a car with a suitable 12V DC to 120V AC inverter and a car amplifier, but it is not recommended.
How do I clean the subwoofer?
Wipe the enclosure with a soft, dry cloth. Do not use any liquids or cleaning solvents.
User questions about SPC-W10 AudioControl
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Subwoofer in PDF format for free! Find your manual SPC-W10 - AudioControl and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. SPC-W10 by AudioControl.