Shape - Synthesizer DPW Design - Free user manual and instructions
Find the device manual for free Shape DPW Design in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Eurorack Synthesizer Module |
| Model | Shape |
| Brand | DPW Design |
| Main Function | Wavefolder / Waveshaper |
| Width | 8 HP |
| Depth | 30 mm |
| Power Supply | +12V / -12V (Eurorack standard) |
| Current Draw | +12V: 50 mA, -12V: 20 mA |
| Inputs | 1x Audio Input (CV or audio), 1x CV Input (Shape control) |
| Outputs | 1x Audio Output |
| Controls | Shape knob (manual control), CV attenuator (optional) |
| CV Range | 0-5V / 0-10V (typical) |
| Frequency Response | 20 Hz - 20 kHz |
| Construction | PCB with aluminum front panel |
| Weight | Approx. 80 g |
| Power Connector | 10-pin ribbon cable (Euro standard) |
| Warranty | 2 years (limited) |
| Country of Origin | Netherlands (DPW Design based in NL) |
| Compliance | RoHS, CE |
Frequently Asked Questions - Shape DPW Design
How do I power the Shape module?
Connect the included 10-pin ribbon cable to your Eurorack power bus board, ensuring the red stripe aligns with -12V. The module draws approximately 50 mA on +12V and 20 mA on -12V.
What is the Shape module used for?
The Shape is a wavefolder that adds harmonic complexity to audio signals. It can also process control voltages for shaping envelopes or LFOs.
How do I calibrate the module?
The Shape module comes pre-calibrated from the factory. If recalibration is needed, adjust the internal trimmer while applying a known voltage to the CV input. Refer to the official manual for detailed steps.
Can I use the Shape with line-level signals?
Yes, but for best results, use Eurorack-level signals (10Vpp). Line-level signals may require amplification before patching into the module.
What is the maximum depth of the module?
The module depth is approximately 30 mm from the front panel to the rear of the PCB. Ensure your case has adequate clearance.
How do I clean the front panel?
Use a soft, dry cloth to wipe the front panel. Avoid using solvents or abrasive cleaners. For stubborn dirt, slightly dampen the cloth with water.
What type of patch cables should I use?
Standard 3.5 mm mono patch cables are compatible. Use quality cables to ensure reliable connections and minimize noise.
Does the module support through-zero?
No, the Shape module does not feature through-zero operation. It is a classic wavefolder design.
Can I daisy-chain power from another module?
It is not recommended to daisy-chain power cables. Use a dedicated power distribution board to supply clean power to each module.
Where can I find the user manual?
The user manual is available for free download in PDF format from the DPW Design website or notice-facile.com.
User questions about Shape DPW Design
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Synthesizer in PDF format for free! Find your manual Shape - DPW Design and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Shape by DPW Design.
USER MANUAL Shape DPW Design
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : DPW Design
Model : Shape
Category : Synthesizer