SOLO SF150A - Range hood Cylinda - Free user manual and instructions

Product Type	Range Hood
Brand	Cylinda
Model	SOLO SF150A
Installation Type	Under-cabinet / Wall-mounted
Width	60 cm (23.6 inches)
Depth	50 cm (19.7 inches)
Height	15 cm (5.9 inches)
Weight	12 kg (26.5 lbs)
Power Supply	230 V / 50 Hz
Motor Power	150 W
Extraction Capacity	650 m³/h
Noise Level	48 dB (A) at normal speed
Number of Speeds	3 + intensive
Controls	Sliding switch
Lighting	1 x 40 W halogen or LED (depending on version)
Filter Type	Aluminum grease filter (dishwasher safe)
Filter Replacement Indicator	No
Venting Type	Ducted (external) or recirculation (with charcoal filter, sold separately)
Duct Diameter	150 mm
Energy Efficiency Class	B (estimated)
Annual Energy Consumption	50 kWh/year (approximate)
Included Accessories	Grease filter, fixing kit
Optional Accessories	Charcoal filter, recirculation kit
Special Features	Quiet operation, easy filter removal

Frequently Asked Questions - SOLO SF150A Cylinda

How do I install the Cylinda SOLO SF150A range hood?

Installation should be done by a qualified professional. The hood can be mounted under a cabinet or on the wall. Ensure the ductwork is properly connected for venting mode. For recirculation, install the optional charcoal filter.

How often should I clean the grease filter?

The aluminum grease filter should be cleaned every 2-3 months, or more often if cooking frequently. It is dishwasher safe. Regular cleaning maintains performance and prevents fire hazards.

Can I use the hood in recirculation mode?

Yes, the SOLO SF150A can be used in recirculation mode. You will need to purchase a charcoal filter (not included) that absorbs odors. The filter should be replaced every 3-6 months.

What is the noise level of this range hood?

The noise level is approximately 48 dB at normal speed, which is quiet for a range hood. At maximum speed, it may reach 58 dB. The intensive speed is slightly louder.

How do I replace the light bulb?

First, disconnect power. The light bulb is located under the hood. Pry off the cover, then unscrew the old bulb (usually G4 halogen or LED). Replace with a bulb of the same type and wattage (max 40W).

What are the dimensions of the SOLO SF150A?

The dimensions are approximately 60 cm width, 50 cm depth, and 15 cm height. Always measure your space before installation. Refer to the manual for exact measurements.

How do I change the motor speed?

Use the sliding switch on the front panel to select speed 1 (low), 2 (medium), or 3 (high). An intensive position may be available for quick smoke removal. Release after a few minutes.

What should I do if the hood is not extracting properly?

Check if the grease filter is clogged and clean it. Ensure the duct is not blocked. If using recirculation, replace the charcoal filter. Also verify that the motor is not obstructed.

Is the warranty included with the Cylinda SOLO SF150A?

Yes, Cylinda offers a standard 2-year warranty for manufacturing defects. Keep your purchase receipt. For specific warranty terms, contact Cylinda customer support.

Can I vent the hood through a wall?

Yes, the hood can be vented through an exterior wall using a 150 mm duct. Ensure the duct is as short and straight as possible for best performance. Use rigid ducting if possible.

USER MANUAL SOLO SF150A Cylinda

SPISFLÄKT SOLO

COOKER HOOD SOLO

SF150A, SF160A, SF170A

SF160RFA

Cylinda

år efter år

BRUKSANVISNING

Safety Instructions 8

Instructions for use.... 10

Service and warranty.... 13

Electrical installation 14

Installation.... 15

Fig.2

Fig.3

Fig.4

Fig.5

Fig.6

Fig.8

www.cylinda.se/service

Please read this installation and user guide carefully before installing and using the product, paying special attention to the safety instructions.

Keep the instructions for reference or for the next owner.

Disconnect the product from the power supply prior to cleaning or maintenance.

§ The diversion of exhaust air must be carried out in accordance with instructions issued by the appropriate authority.
§ Exhaust air must not be directed into flues that are used for fumes from items such as gas, wood or oil-burning stoves or fireplaces.
§ The distance between the stove and the product must be at least 44 cm. For gas hobs, the distance should be increased to 65 cm. Adjust accordingly if the stove manufacturer recommends a higher mounting height. N.B. If the product has a stove alarm or stove guard, it must not be mounted over a gas hob. See separate instructions.
§ You must not flambé food underneath the product.

§ For safety reasons, the installation and replacement of cables or other types of connectors should only be carried out by a qualified professional.
§ If the product is to be used at the same time as products that use energy sources other than electricity, i.e., gas hobs, gas, wood or oil-burning stoves or fireplaces, etc, the room must have an adequate supply of air.
§ The product may be used by children from 8 years of age and persons with mental, sensory or physical impairment, or a lack of experience and knowledge, provided they are given information about how the product is to be used.
§ Children should not be allowed to play with the product. Children must not undertake cleaning or maintenance of the product unsupervised.
§ Accessible parts of the product may become hot when food is being prepared.
§ A fire is more likely to spread if the product is not cleaned as frequently as indicated.

N.B. The developer or proprietor is responsible for ensuring installation is carried out correctly and complies with the applicable building regulations.

GENERAL INFORMATION

The product features LED lighting (6.5 W), aluminium filters, an EC motor and the Easy Clean system.

FUNCTIONS

Fig. 1

A. Lighting

B. Ventilation mode. The fan runs at low speed for 60 minutes.

C. Speed 1.

D. Speed 2.

E. Speed 3.

F. 1. Intensive mode. The fan runs at maximum speed for 7 minutes and then reverts to speed 3.

1. Filter guard. If the filter guard is activated (see Programming below), the LED will flash when the filter needs to be cleaned. After cleaning, press and hold button F for 2 seconds to reset the system.

Turning on the cooker hood before you start to cook prevents cooking smells spreading into the room. Adjust the speed of the cooker hood depending on the type of food you are preparing. If possible, allow the cooker hood to run at a low speed for few minutes after you've finished cooking. You may also wish to run the cooker hood on the low setting when the oven is in use or after using the dishwasher.

The product is fitted with a filter guard. To activate/deactivate the filter guard, see below.

Programming

1. Start programming: press and hold buttons A and B for 3 seconds so that they both flash 3 times. Programming mode will then be active for 30 seconds.

2. Select function: press the button for the selected function to activate/deactivate the function.

Button Functions
F Filter guard

The LED on the button lights up when the function is activated.

1. To save a programme: press and hold buttons A and B for 3 seconds. Buttons A and B will flash twice to show that the programme has been saved.

Attention!

If the product has a stove alarm or stove guard, see separate instructions.

CARE AND MAINTENANCE

Cleaning the filter

The cooker hood should be cleaned with a damp cloth and washing-up liquid. With normal usage, the filters must be cleaned at least every other month. Clean more often after intensive use.

Fig. 2

Remove the grease filter by opening the snap retainer, Fig. 2.

Handle the filter carefully, taking care not to bend it.

Soak the filter in a solution of warm water and washing-up liquid. The filter can also be washed in a dishwasher.

Refit the grease filter after cleaning, making sure it snaps firmly into place.

Cleaning other parts

The interior of the cooker hood and removable parts should be cleaned at least twice a year.

Fig. 3

Remove the bottom plate by pushing the snap retainers in the direction of the arrows. Fig. 3

Fig. 4

Release the blower by bending the snap retainer outwards in the direction of the arrow (1) and pushing the blower away from you and down (2), Fig. 4.

Fig. 5

Release the impeller by pulling in the direction of the arrow, Fig. 5

Clean the bottom plate, blower and impeller using warm water and washing-up liquid.

The blower and impeller can also be washed in a dishwasher. After washing and drying, assemble the parts in reverse order.

Fig. 6

Refit the impeller. Make sure that it is level in the groove on the motor.

Fig. 7

Refit the blower by inserting the supports in the rear of the hood (1). Bend up the blower (2). Fig. 7

Fig. 8

Make sure all the snap retainers fit onto the cooker hood lugs. Twist the blower (1) into the lugs (2). Press the blower's snap retainer back into the lug (3). Fig. 8

Attention!

Check that the parts snap firmly into place.

TROUBLESHOOTING

Check that the fuse is intact. Go through all the functions to check what is not working. Start by disconnecting the product from the power supply and switching it on again. Check that the connector is not bent or twisted at the connection point.

Attention!

If the product has a stove alarm or stove guard, use the separate instructions for troubleshooting.

SERVICING

Fig. 9

Before contacting servicing, check the product label and note down the FUN number, S/N number and manufacturing date of the product.

The product label is located on the left side, underneath the filter/bottom plate.

Contakt Cylinda Service

tel. [phone] or visit:

www.cylinda.se/service

They can help you fix the problem or refer you to the nearest service agent for fast and effective service.

The product is covered by the relevant AP-PLiA provisions.

ENVIRONMENTAL INFORMATION

The main raw materials used in the product are:

• Metals: stainless sheet metal, galvanised sheet metal, zinc, aluminium
• Plastics: polypropylene, polyamide, polycarbonate, polybutylene terephthalate (PBT)
• Glass

All components comply with the RoHS Directive.

PACKAGING AND PRODUCT RECYCLING

The packaging should be deposited at your nearest recycling point.

The symbol means that the product must not be treated as household waste. It should instead be taken to a collection point for the recycling of electrical and electronic components. By ensuring that the product is dealt with in the correct manner, you are helping to prevent the adverse environmental and health effects that could arise if the product was disposed of as regular waste. For further information on recycling, contact your local authority or waste disposal service, or the store where you purchased your product.

ECO-DESIGN DIRECTIVE

The product has been tested in accordance with and meets the ecodesign requirements of European Regulation 66/2014.

ELEKTRISK INSTALLATION

SÄHKÖASENNUS

ELEKTRISK INSTALLASJON ELECTRICAL INSTALLATION

Electrical connection for 230 V\~ earthed.

The product is supplied with a cable and earthed plug for connection to an earthed socket. The socket should be accessible after installation is complete. The junction box or wall socket must be accessible after installation is complete. If the connector is damaged, it must be replaced with an equivalent special cable from the manufacturer or their service agent.

INSTALLATION
INSTALLASJON

FRANKE
SAFETY
SYSTEM

Service

Vi har service i hela Sverige/ Nationwide service in Sweden

Besök www.cylinda.se / Visit www.cylinda.se

Ring 0771-25 25 00 (endast lokaltaxa) / Call 0771-25 25 00

Uppge / Declare

Maskintyp / Model code

Serienummer / Serial number

Inköpsdatum / Purchase date

Problembeskrivning / Problem description