Sequencer 3 - Controller Vemer - Free user manual and instructions
Find the device manual for free Sequencer 3 Vemer in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Controller / Sequencer |
| Brand | Vemer |
| Model | Sequencer 3 |
| Dimensions (approx.) | 100 x 60 x 30 mm |
| Weight (approx.) | 100 g |
| Power Supply | 230 V AC, 50/60 Hz |
| Power Consumption | 5 W max |
| Number of Outputs | 3 |
| Output Type | Relay, 10 A / 250 V AC |
| Main Functions | Sequence control with adjustable timing; independent channel programming; ON/OFF modes |
| Timing Range | 0.1 seconds to 10 minutes per step |
| Display | LED indicators for each channel and power |
| Control Interface | Front panel push buttons and rotary switch |
| Mounting | Wall mount or DIN rail |
| Operating Temperature | -10°C to 50°C |
| Protection Rating | IP20 (indoor use only) |
| Maintenance & Cleaning | Wipe with a dry, soft cloth. Do not use liquids or solvents. |
| Safety | Double insulation; complies with CE standards |
| Spare Parts & Repairability | Contact Vemer customer service for spare parts. Repairs should be done by qualified personnel. |
| General Information | Designed for lighting control, signage, and industrial sequencing applications. |
Frequently Asked Questions - Sequencer 3 Vemer
How do I set the timing for each channel?
Use the rotary switch to select a channel, then adjust the timing with the Time Set knob. Refer to the manual for precise steps.
Can I connect the Sequencer 3 to a 12V power supply?
No, the device requires 230 V AC. Using a lower voltage may damage the controller.
How many devices can I control per output?
Each output relay is rated for 10 A at 250 V AC. Ensure total load does not exceed this limit.
What does the sequence pattern do?
The sequence turns on each channel one after another in a loop. You can set ON and OFF times independently.
Is the Sequencer 3 waterproof?
No, it has an IP20 rating, meaning it is only protected against dust and dripping water. Keep it indoors.
How do I reset the device to factory settings?
Press and hold the Reset button for 5 seconds until all LEDs flash. This clears all programmed times.
Can I use the Sequencer 3 for Christmas light displays?
Yes, it is ideal for decorative lighting. Ensure the connected lights do not exceed the relay rating.
What cables are needed for installation?
Use standard 230 V rated wires for power and load connections. Minimum 1.5 mm² cross-section is recommended.
My device is not powering on. What should I check?
First, verify the power supply is connected and the Power LED is lit. Check the fuse – a spare is located near the terminals.
Where can I download the full user manual?
The manual is available for free on notice-facile.com in PDF format. Use the download button on this page.
User questions about Sequencer 3 Vemer
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Controller in PDF format for free! Find your manual Sequencer 3 - Vemer and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Sequencer 3 by Vemer.
USER MANUAL Sequencer 3 Vemer
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Vemer
Model : Sequencer 3
Category : Controller