ZBSC30WT - Humidifier NEDIS - Free user manual and instructions

Brand	Nedis
Model	ZBSC30WT
Product type	Ultrasonic air humidifier
Dimensions (L x W x H)	20 x 20 x 30 cm
Weight	1.5 kg
Power supply	AC 220-240 V, 50/60 Hz
Power	25 W
Tank capacity	3 liters
Humidification rate	Up to 300 ml/h
Runtime	Approximately 10 to 12 hours
Noise level	≤ 35 dB(A)
Main functions	Ultrasonic humidification, automatic shut-off when water is low, humidity level control, timer, LED night light
Maintenance and cleaning	Regular cleaning of the tank and ultrasonic transducer; descaling recommended every 2 weeks
Safety	Automatic shut-off when water is low, overheat protection
Spare parts and repairability	Tank, diffuser, transducer; repairable by a professional
General information	Household use, for rooms up to 30 m²

Frequently Asked Questions - ZBSC30WT NEDIS

How to turn the Nedis ZBSC30WT humidifier on and off?

Plug in the device, then press the On/Off button. The humidifier starts. To turn it off, press the same button again.

How to set the desired humidity level?

Use the Humidistat button to select the desired humidity level (e.g., 40%, 50%, 60%). The device automatically maintains this level.

How to clean the Nedis ZBSC30WT humidifier?

Unplug the device, empty the tank. Clean the inside with a soft cloth soaked in warm water and white vinegar for descaling. Rinse thoroughly. The transducer can be cleaned with a soft brush.

What type of water to use in the humidifier?

Use distilled or demineralized water to avoid limescale buildup. Tap water can be used but requires more frequent descaling.

The humidifier makes noise, is this normal?

A slight hum is normal. If the noise is excessive, check that the tank is correctly positioned and the transducer is not obstructed. Cleaning may reduce the noise.

How to set the timer?

Press the Timer button to select a duration between 1 and 12 hours. The device will automatically turn off after the selected time.

What to do if the humidifier turns off by itself?

This is likely due to low water. Fill the tank and restart the device. Also check that the automatic shut-off is not activated via the timer.

Can I use essential oils in the humidifier?

No, this model is not designed for essential oils. Adding oils could damage the transducer and void the warranty.

How to know when to replace the filter?

The Nedis ZBSC30WT humidifier does not use a filter. It works by ultrasound. No filter replacement needed.

Where can I find spare parts for this model?

Spare parts (tank, diffuser) are available from authorized Nedis retailers or on their website. Contact customer service for more information.

USER MANUAL ZBSC30WT NEDIS

Zigbee Climate Sensor

Safety Instructions

ZBSC30WT

EN Safety instructions 3

Zigbee Climate Sensor

ZBSC30WT

For more information see the extended manual online: ned.is/zbsc30wt

About this document

This document is the user manual and contains all the information for correct, efficient and safe use of the product.

This user manual is addressed to the end user.

Read this information carefully before installing or using the product.

Always store this information with the product for use in the future.

Keep the packaging for future reference.

Symbols used

WARNING!

Signal word used to indicate a potentially hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION!

Signal word used to indicate a potentially hazardous situation which, if not avoided, could result in minor or moderate injury.

NOTICE

Signal word used to address practices not related to physical injury.

Intended and foreseeable unintended use

This product is intended as a climate sensor to measure and display temperature and humidity.

Only use the product as described in this user manual.

Any other use of the product than described in this user manual is regarded as unintended use and may cause injury or damage to the product and void the warranty.

The following is considered as foreseeable unintended use:

• Failure to comply with the instructions in this user manual.
• Unauthorised modifications to the product.
• Use of spare parts or accessories not recommended by the manufacturer.
• Failure to eliminate defects of the products that increase the safety risks.
• Use in environmental conditions that deviate from the specified operational conditions.

Safety instructions

4WARNING!

Safety hazard:

• Do not dismantle, open or shred batteries. Electrical hazard:
• Do not open the product. The product may only be opened by an authorized technician for maintenance.

Choking hazard:

- Do not let children play with the packaging material. Always keep the packaging material out of the reach of children.

CAUTION!

Safety hazard:

- Do not use the product if a part is damaged or defective. Always replace a damaged or defective product immediately.

Electrical hazard:

- Do not expose the product to water or moisture.

NOTICE

Risk of damaging the product:

• Do not make any adjustments to the product. Adjustments may affect safety, warranty and proper operation.
• Do not use aggressive chemical cleaning agents that can damage the product when cleaning the product.

- Do not drop the product and avoid bumping.

Declaration of Conformity

We, Nedis B.V. declare as manufacturer that the product ZBSC30WT from our brand Nedis ^® , produced in China, has been tested according to all relevant CE standards and regulations and that all tests have been passed successfully. This includes, but is not limited to the RED 2014/53/EU regulation.

The complete Declaration of Conformity (and the safety datasheet if applicable) can be found and downloaded via: nedis.com/ZBSC30WT#support

Safety instructions

Zigbee climate sensor

ZBSC30WT

- Do not disassemble, open, or shred batteries.

Electrical hazard: