90052 - Pump Simpson - Free user manual and instructions
Find the device manual for free 90052 Simpson in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | High Pressure Pump |
| Brand | Simpson |
| Model | 90052 |
| Category | Pump |
| Dimensions (L x W x H) | 30 x 20 x 20 cm |
| Weight | 5 kg |
| Power Supply | 230 V - 50 Hz |
| Rated Power | 1400 W |
| Maximum Pressure | 120 bar |
| Water Flow | 420 L/h |
| Pump Type | Axial |
| Body Material | Aluminum |
| Piston Material | Stainless Steel |
| Usage | High Pressure Cleaning |
| Maintenance | Check and lubricate seals regularly |
| Cleaning | Rinse with clean water after use |
| Safety | Automatic shutdown in case of overpressure |
| Spare Parts | Seal kit available |
| Repairability | Repairability rating: 8/10 |
| Warranty | 2 years |
Frequently Asked Questions - 90052 Simpson
How to install the Simpson 90052 pump?
Secure the pump on a flat, solid surface. Connect the water inlet and high pressure outlet. Plug in the 230 V power supply. Bleed the air before first use.
What oil to use for the pump?
Use a SAE 30 motor oil non-detergent. Check the level via the filler cap.
How to winterize the pump?
Drain residual water by running the pump dry for a few seconds. Store in a dry place protected from frost. Add a special pump antifreeze if necessary.
Why doesn't the pump build up pressure?
Check the water supply (sufficient flow), seals, nozzle (clogged or worn), and pressure valve. A repair kit may be necessary.
The pump makes an abnormal noise, what to do?
This may be due to lack of oil, air bubbles (bleed), or loose parts. Check the fastenings and oil level.
What is the maximum pressure of the 90052 pump?
The maximum pressure is 120 bar. Do not exceed this value to avoid damaging the pump.
Can I use the pump with hot water?
No, the water must not exceed 50 °C. Hot water would damage the seals and internal components.
How to change the pump seals?
Unscrew the cover bolts, remove the old seals and replace them with those from the specific seal kit. Lightly lubricate before reassembly.
The pump leaks from the bottom, what to do?
An oil or water leak indicates a defective seal. Check the housing seal and piston seals. Replace worn seals.
What type of nozzle to use with this pump?
Use a standard high pressure nozzle with an angle from 0° to 40°. A nozzle that is too wide will reduce pressure. Recommended flow: 420 L/h.
User questions about 90052 Simpson
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Pump in PDF format for free! Find your manual 90052 - Simpson and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 90052 by Simpson.
USER MANUAL 90052 Simpson
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Simpson
Model : 90052
Category : Pump