DTR-10t - Electronic timer ENTES - Free user manual and instructions
Find the device manual for free DTR-10t ENTES in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Digital Timer/Controller |
| Brand | ENTES |
| Model | DTR-10t |
| Dimensions (H x W x D) | 90 x 36 x 64 mm |
| Weight | 0.12 kg |
| Power Supply | 230 V AC, 50/60 Hz |
| Power Consumption | < 2 VA |
| Display | LCD, 5 digits |
| Time Range | 0.01 sec to 9999 hours |
| Output Type | Relay, 1 changeover contact |
| Contact Rating | 10 A / 250 V AC |
| Operating Temperature | -10°C to +55°C |
| Mounting | DIN rail (EN 60715) |
| Protection Degree | IP20 (front), IP10 (terminals) |
| Main Functions | On-delay, off-delay, interval, cyclic timer |
| Maintenance | No user maintenance required; clean with dry cloth |
| Safety | Overvoltage category II, double insulation |
| Spare Parts | Not available as separate parts; replace unit |
| General Information | CE marked, RoHS compliant |
Frequently Asked Questions - DTR-10t ENTES
How do I set the time delay on the DTR-10t?
Press the SET button to enter programming mode. Use the ▲ and ▼ buttons to adjust the time. Confirm with SET again.
What is the maximum load the relay can switch?
The relay can switch up to 10 A at 250 V AC (resistive load). For inductive loads, derating may apply.
Can the DTR-10t be used for cyclic timing?
Yes, it supports cyclic timer mode with separate ON and OFF times.
How do I connect the power supply?
Connect 230 V AC to terminals A1 and A2. Ensure the power is off during connection.
What do the symbols on the display mean?
The display shows the current time or set parameters. Symbols like ON, OFF indicate relay status.
How to reset the timer to factory settings?
Press and hold the RST button for 5 seconds until the display shows rES. Release to reset.
Is the device suitable for outdoor use?
No, the DTR-10t has protection degree IP20 (front), suitable for indoor, dry locations only.
What is the function of the potential-free contact?
The relay output is a potential-free changeover contact (COM, NO, NC), ideal for switching external loads.
How to install the device on a DIN rail?
Clip the device onto a standard DIN rail (35 mm). Ensure the locking mechanism engages securely.
What should I do if the device does not power on?
Check the power supply voltage at terminals A1-A2. Verify the fuse (if any) and correct polarity.
User questions about DTR-10t ENTES
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Electronic timer in PDF format for free! Find your manual DTR-10t - ENTES and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. DTR-10t by ENTES.
USER MANUAL DTR-10t ENTES
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : ENTES
Model : DTR-10t
Category : Electronic timer