CV460 - Water filter Jandy - Free user manual and instructions
Find the device manual for free CV460 Jandy in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product type | Sand filter for pool |
| Brand | Jandy |
| Model | CV460 |
| Diameter | 460 mm |
| Tank material | High-density polyethylene |
| Filter media type | Glass or silica (recommended) |
| Sand capacity | Approximately 75 kg |
| Maximum working pressure | 2.5 bar |
| Nominal flow rate | 20 m³/h |
| Connection | 50 mm (2") |
| Multi-port valve | Built-in, 6 positions |
| Cleaning | Manual backwash |
| Use | Residential pool |
| Max water temperature | 40 °C |
| Empty weight | Approximately 25 kg |
| Operating weight | Approximately 100 kg |
| Manufacturer warranty | 2 years |
| Standards | Compliant with European standards |
| Routine maintenance | Weekly backwash and pressure check |
| Repairability | Spare parts available (seals, valves, etc.) |
Frequently Asked Questions - CV460 Jandy
How to install the Jandy CV460 filter?
Place the filter on a flat and stable surface. Connect the multi-port valve to the piping respecting the flow directions (inlet, return, waste). Fill the tank with sand or filter glass up to half, then complete the assembly.
What type of sand to use in the CV460?
Use #20 silica sand (0.4-0.8 mm) or filter glass. The recommended quantity is approximately 75 kg.
How to perform a backwash?
Turn off the pump, set the valve to 'backwash' position, restart the pump until the waste water is clear (2-3 minutes), then turn off the pump and set the valve to 'rinse' for 30 seconds. Finally, set the valve to 'filter'.
What is the normal operating pressure?
The working pressure is usually between 0.5 and 1.5 bar. The maximum allowed pressure is 2.5 bar. If it exceeds 2 bar, a backwash is necessary.
How to clean the filter at the end of the season?
Perform a backwash, empty the tank, remove the sand (or do chemical descaling). Store the filter in a dry place, protected from frost.
What to do in case of water leak?
Check the O-rings of the valve and the lid. Replace them if necessary. Tighten the clamps and ensure the pressure gauge seal is in good condition.
Can sand be replaced with filter glass?
Yes, filter glass is compatible and offers better particle retention. Make sure to respect the same volume as sand (about 15% less by weight).
How to maintain the multi-port valve?
Lubricate the O-rings with silicone grease once a year. Ensure the positions click correctly. If it becomes hard to turn, replace the seals.
Which pump to pair with the CV460 filter?
A pump with a flow rate of 20 m³/h at 10 m head is recommended, for example the Jandy PlusHP 1.5 HP.
Is the CV460 filter guaranteed?
Yes, the manufacturer warranty is 2 years against manufacturing defects. Wear parts (seals, pressure gauge) are not covered.
User questions about CV460 Jandy
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Water filter in PDF format for free! Find your manual CV460 - Jandy and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. CV460 by Jandy.
USER MANUAL CV460 Jandy
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Jandy
Model : CV460
Category : Water filter