Ping ET50 - Measuring equipment Ermenrich - Free user manual and instructions
Find the device manual for free Ping ET50 Ermenrich in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Laser Distance Meter |
| Model | Ping ET50 |
| Brand | Ermenrich |
| Measuring Range | 0.05 – 50 m |
| Measuring Accuracy | ± 1.5 mm |
| Laser Class | Class II (630–670 nm, < 1 mW) |
| Units of Measurement | m / ft / in |
| Display | Backlit LCD, 4 lines |
| Dimensions (H × W × D) | 120 × 50 × 25 mm |
| Weight (with batteries) | 100 g |
| Power Supply | 2 × AAA batteries (1.5 V) |
| Battery Life | Up to 5000 measurements |
| Auto Power Off | After 3 minutes of inactivity |
| Measurement Functions | Distance, area, volume, continuous measurement, Pythagoras |
| Memory | Last 20 measurements |
| Data Interface | Bluetooth® (optional, for data transfer) |
| Operating Temperature | 0 °C to +40 °C |
| Storage Temperature | -10 °C to +60 °C |
| Dust/Water Protection | IP54 (dust and splash water) |
| Included Accessories | Wrist strap, pouch, batteries, user manual |
| Maintenance & Cleaning | Wipe with dry cloth; clean laser lens with cotton swab |
| Safety Notes | Do not look into laser beam; avoid direct eye exposure |
| Spare Parts & Repairability | Batteries and wrist strap replaceable; no user-serviceable parts inside |
| General Information | Conforms to EN 60825-1:2014 for laser safety |
Frequently Asked Questions - Ping ET50 Ermenrich
How do I change the measurement unit?
Press the UNIT button repeatedly to cycle through m, ft, and in.
What batteries does the Ping ET50 use?
It uses two AAA 1.5V batteries. Insert them with correct polarity as shown in the battery compartment.
How do I perform a continuous measurement?
Press and hold the MEASURE button for 2 seconds to enter continuous mode. The device will update the reading every 0.5 seconds.
What is the maximum measuring distance?
The maximum range is 50 meters under favorable conditions (good target reflectivity, no bright ambient light).
How do I clean the laser lens?
Use a soft, dry cotton swab to gently wipe the lens. Do not use solvents or abrasive materials.
Why does the device show an error?
Common causes: target too far or too reflective, low battery, or laser beam interrupted. Check conditions and replace batteries if needed.
Can I use the device outdoors?
Yes, but in bright sunlight the range may decrease. Use the target plate (optional) for better results.
How do I recall previous measurements?
Press the MEM button to scroll through the last 20 stored measurements. Press and hold to clear all.
Is the device water resistant?
It has IP54 protection, meaning it is dust and splash water resistant. Do not submerge in water.
What should I do if the laser stops working?
Ensure batteries are fresh and inserted correctly. If the issue persists, contact Ermenrich support.
User questions about Ping ET50 Ermenrich
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Measuring equipment in PDF format for free! Find your manual Ping ET50 - Ermenrich and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Ping ET50 by Ermenrich.
USER MANUAL Ping ET50 Ermenrich
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Ermenrich
Model : Ping ET50
Category : Measuring equipment