28360 - Paint gun Draper - Free user manual and instructions
Find the device manual for free 28360 Draper in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | HVLP Paint Spray Gun |
| Brand | Draper |
| Model | 28360 |
| Spray Pattern | Adjustable (round, horizontal, vertical) |
| Nozzle Size | 1.5 mm |
| Fluid Delivery | Gravity feed (200 ml cup) |
| Operating Pressure | 20 – 50 PSI (1.4 – 3.5 bar) |
| Air Inlet | 1/4 inch NPS |
| Weight | 1.2 kg (2.65 lbs) |
| Dimensions (L x W x H) | 25 x 15 x 8 cm |
| Material | Aluminum body, stainless steel needle and nozzle |
| Viscosity Range | 20 – 30 seconds (Ford cup #4) |
| Viscosity Cup Included | Yes |
| Cleaning | Disassemble and clean with solvent after use |
| Maintenance | Lubricate moving parts regularly |
| Safety Features | Air regulator, trigger lock |
| Spare Parts Available | Nozzle kits, needle sets, seals |
| Repairability | User-serviceable with available parts |
| Warranty | 2 years (subject to registration) |
| General Information | Suitable for automotive, woodworking, and DIY painting |
Frequently Asked Questions - 28360 Draper
What kind of paint can I use with the Draper 28360 spray gun?
The Draper 28360 is designed for use with solvent-based paints and lacquers. Water-based paints can also be used, but require thorough cleaning after use. Always thin paint according to the recommended viscosity (20-30 seconds in Ford #4 cup).
How do I adjust the spray pattern on this paint gun?
The spray pattern is adjusted using the pattern control knob on the rear of the gun. Turn clockwise for a round pattern, counterclockwise for a flat (vertical or horizontal) pattern. The fluid flow is controlled by the trigger. Adjust the air pressure on the regulator to fine-tune atomization.
What is the recommended air pressure for using the Draper 28360?
The recommended operating pressure is 20 to 50 PSI (1.4 to 3.5 bar). Start at the lower end and increase until you achieve a fine, even spray without overspray. Use the built-in air regulator to set the pressure.
How do I clean the spray gun after use?
First, empty the paint cup. Then, flush the gun with appropriate solvent (thinner for oil-based, water for water-based) by spraying through. Disassemble the nozzle, needle, and air cap, and clean them with a soft brush. Wipe all parts dry and lubricate moving parts with lightweight oil before reassembly.
Can I use this spray gun for water-based paints?
Yes, the Draper 28360 can be used with water-based paints. However, you must clean it thoroughly with water immediately after use to prevent drying and clogging. Some water-based coatings may require a specific tip kit.
What nozzle size does the Draper 28360 come with?
The standard nozzle size is 1.5 mm. This is suitable for most automotive and woodworking paints. Optional nozzle kits (1.3 mm, 1.8 mm) are available for different coating viscosities.
How do I replace the nozzle and needle?
Ensure the gun is disconnected from air supply. Use the provided wrench to unscrew the fluid nozzle. Remove the needle from the rear after loosening the needle chuck. Install the new needle and nozzle, then tighten securely. Adjust the needle stroke using the adjustment screw.
Why is my spray gun spitting or producing an uneven pattern?
Common causes: low air pressure, clogged nozzle, incorrect paint viscosity, or dirty air cap. Check pressure, clean all parts, thin paint if needed, and ensure the air cap holes are not blocked. Also verify the needle assembly is properly seated.
Is the Draper 28360 compatible with all air compressors?
It will work with any compressor that can supply minimum 6 CFM at 40 PSI and has a 1/4 inch NPS air fitting. A larger tank (≥ 25 liters) is recommended for continuous use. Use a moisture trap to avoid water contamination.
Where can I find spare parts for the Draper 28360?
Spare parts such as nozzle sets, needle assemblies, seal kits, and air cap are available from Draper authorized dealers or online stores. Always quote the model number (28360) when ordering. Refer to the user manual for part numbers.
User questions about 28360 Draper
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Paint gun in PDF format for free! Find your manual 28360 - Draper and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 28360 by Draper.
USER MANUAL 28360 Draper
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Draper
Model : 28360
Category : Paint gun