StarColor1280 Ba - Uncategorized BeamZ - Free user manual and instructions
Find the device manual for free StarColor1280 Ba BeamZ in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | LED Projector |
| Brand | BeamZ |
| Model | StarColor1280 Ba |
| Number of LEDs | 12 RGBW LEDs |
| LED Power | 10 W per LED |
| Beam Angle | 25° |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Power Consumption | 130 W |
| DMX Protocol | DMX512 |
| Number of DMX Channels | 4/8 channels |
| Operating Modes | Auto, Master/Slave, DMX, Sound |
| Dimensions (L x W x H) | 250 x 250 x 300 mm |
| Weight | 2.5 kg |
| Housing Material | Die-cast aluminum |
| Mounting | Adjustable mounting bracket |
| DMX Input/Output Connectors | 3-pin XLR |
| Protection Rating | IP20 |
| Operating Temperature | -10°C to 40°C |
| Maintenance and Cleaning | Clean with a soft dry cloth. Avoid solvents. |
| Safety | Indoor use only. Do not expose to moisture. Disconnect before maintenance. |
| Spare Parts and Repairability | LED and power supply replaceable by a professional. |
Frequently Asked Questions - StarColor1280 Ba BeamZ
How to connect the StarColor1280 Ba via DMX?
Use a 3-pin XLR cable to connect the DMX output of the controller to the DMX input of the fixture. Ensure the DMX address is correctly set via the control panel.
What to do if the fixture does not turn on?
First check the power supply and the power cord. Make sure the fuse has not blown. If the problem persists, contact an authorized technician.
How to set the master/slave mode?
Configure one fixture as master and the others as slave. Daisy-chain them via DMX. The master will control all slaves.
What is the procedure to update the firmware?
Firmware is not user-updatable. For any updates, contact BeamZ after-sales service.
The projector flickers randomly, what to do?
Check DMX connections and power supply. Ensure the operating mode is not set to 'Sound' without audio signal. Reset the fixture by turning off power for 10 seconds.
How to clean the lenses of the StarColor1280 Ba?
Use a slightly damp microfiber cloth to gently clean the lenses. Avoid harsh chemicals. Do not spray directly on the fixture.
What is the default number of DMX channels used?
By default, the fixture uses 4 DMX channels (red, green, blue, white). You can switch to 8-channel mode for more advanced control (dimmer, strobe, etc.).
Can I use this projector outdoors?
No, the StarColor1280 Ba is rated IP20, meaning it is designed for indoor use only. Exposure to moisture or rain can damage the fixture.
How to replace defective LEDs?
LEDs are not user-replaceable. Please contact an authorized BeamZ service technician for replacement.
Where to find the serial number of the fixture?
The serial number is on a label on the back or underside of the housing. It is required for any technical support requests.
User questions about StarColor1280 Ba BeamZ
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual StarColor1280 Ba - BeamZ and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. StarColor1280 Ba by BeamZ.
USER MANUAL StarColor1280 Ba BeamZ
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : BeamZ
Model : StarColor1280 Ba
Category : Uncategorized