RA-E314B - Alarm Clock JVC - Free user manual and instructions

Product Type	Alarm Clock Radio
Brand	JVC
Model	RA-E314B
Dimensions (Approx.)	5.9 x 3.1 x 7.9 inches (150 x 80 x 200 mm)
Weight (Approx.)	1.1 lb (0.5 kg)
Power Supply	AC 120V 60Hz; Backup battery (CR2032, not included)
Radio Bands	AM / FM
Alarm Type	Dual alarm with radio or buzzer
Snooze Function	Yes, 9-minute snooze
Sleep Timer	Yes, adjustable (up to 90 minutes)
Display	LED with adjustable brightness
Clock	12/24 hour format
Volume Control	Rotary dial
Tuning	Analog wheel
Additional Features	Wake to radio or alarm; large display
Safety	Keep away from water; use only specified power adapter
Maintenance	Clean with a soft, dry cloth; avoid solvents
Spare Parts / Repairability	Backup battery replaceable; contact JVC support for other parts

Frequently Asked Questions - RA-E314B JVC

How do I set the clock on the JVC RA-E314B?

Press and hold the Clock button until the hour digits flash. Use the Hour and Minute buttons to adjust. Press Clock again to confirm. Repeat for minutes.

How do I set the alarm?

Press and hold the Alarm 1 or Alarm 2 button until the time flashes. Use the Hour and Minute buttons to set. Press the alarm button again to select wake source (radio or buzzer). Set the alarm switch to ON.

How do I use the snooze function?

When the alarm sounds, press the Snooze button. The alarm will stop and sound again after 9 minutes.

How do I set the sleep timer?

Press the Sleep button. The display shows SLEEP. Use the Hour or Minute buttons to set the desired minutes (up to 90). The radio will turn off after the set time.

How do I tune to a radio station?

Turn the Tuning dial on the side of the unit to adjust the frequency. For FM, extend the wire antenna for better reception.

How do I adjust the volume?

Use the Volume dial on the top or side of the unit. Turn clockwise to increase, counterclockwise to decrease.

How do I change the display brightness?

Press the Brightness button repeatedly to cycle through high, medium, and low brightness levels.

What should I do if the radio or alarm does not work?

First, check that the unit is plugged into a working AC outlet. If using battery backup, replace the CR2032 battery. Ensure the volume is not turned all the way down and that the alarm switch is set to ON.

How do I replace the backup battery?

Open the battery compartment on the bottom of the unit. Remove the old CR2032 battery and insert a new one with the positive side facing up. Close the compartment.

How do I perform a factory reset?

Unplug the unit from the AC outlet and remove the backup battery. Wait 30 seconds, then reinsert the battery and plug the unit back in. All settings will be cleared.

USER MANUAL RA-E314B JVC

• Thank you for buying our product.
• Please read through these operating instructions, so you will know how to operate your equipment properly. After you finished reading the instructions manual, put it away in a safe place for future reference.

WARNINGS

• Do not attempt to disassemble or alter any part of the equipment that is not expressly described in this guide. Disassembly or alteration may result in high-voltage electrical shock. Internal inspections, alterations and repairs should be conducted by qualified service personnel only.
• Ensure minimum distances of 5 cm around the apparatus for sufficient ventilation. Do not place the product in closed bookcases or racks without proper ventilation. Ensure that the ventilation is not impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.
• No naked flame sources, such as lighted candles, should be placed on the apparatus.
• It shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.
• Use of power sources, or batteries not expressly recommended for this equipment may lead to overheating, malfunction of the equipment, fire, electrical shock or other hazards. Use only the recommended power source.
• Do not use or store the equipment in humid or dusty area. Attention should be drawn to the use of apparatus in tropical and/or moderate climates.
• Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Never throw batteries in fire! Attention should be drawn to the environmental aspects of battery disposal.
• Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
• Marking plate is located at bottom enclosure of the apparatus.
• Never place the projector clock close to electric motors or other equipment generating strong electromagnetic fields. Exposure to strong magnetic fields may cause malfunctions or corrupt image.
• Do not place projector clock on places sensitive to vibrations or table edges.
• Do not look directly into the projector lens as doing this may permanently damage your sight.
• Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
• The normal function of the product may be disturbed by strong electromagnetic interference. If so, simply reboot the product to resume normal operation by following the instruction manual.

Battery handling and usage

• Only adults should handle battery. Do not allow a child to use this apparatus unless the battery cover is securely attached to the unit.
• The battery type used in the unit is 1 x CR2032 size battery (not included) which are accessible and can be replaced.
• Remove the battery cover located at the bottom of the unit to remove the batteries.

WARNING - For Products Contain Coin/Button Cell Batteries

DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

PRODUCT OVERVIEW AND CONTROL BUTTONS

1. POWER/FM button
2. HOUR/TUNING button
3. MIN/TUNING button
4. SLEEP button
5. SNOOZE/DIMMER button
6. MEM/SET button
7. AL1/VOLUME button
8. AL2/VOLUME button
9. PROJECTION ON/ROTATE/OFF button
10. LED Display
11. Alarm 1 buzzer indicator
12. Alarm 1 radio indicator
13. Alarm 2 buzzer indicator
14. Alarm 2 radio indicator
15. Projector Lens
16. Focus thumbwheel
17. Battery Cover
18. USB-C ^TM port
19. FM antenna

USB Type- C^TM and USB- C^TM are trademarks of USB Implementers Forum.

GETTING STARTED

CONNECTING USB POWER

• Connect the USB cable (included) to the USB-C port located on the unit's back.
• Connect the USB cable to a 5V USB AC adapter (not included).
• The unit is in standby mode and [0:00] will flash on the display.

BATTERY BACKUP

The clock, alarm and preset stations settings can be protected against AC power failure with the batteries for a short period of time. If no backup batteries are installed or the power failure is prolonged, you will need to set the clock again.

SETTING THE CLOCK

In standby mode, press and hold the MEM/SET button until the display flashes.

• Press repeatedly the HOUR button to set the hours.
• Press repeatedly the MIN button to set the minutes.
• Press the MEM/SET button to confirm.

The hour and minute digits will stop flashing.

NOTE: Press and hold the HOUR and MIN buttons to fast forward.

RADIO OPERATION

Press the POWER/FM button to turn on the radio.

• The radio frequency will briefly appear on the display and then return to clock time.
  NOTE: The default FM radio frequency is 87,5 MHz.

- Repeatedly press the TUNING /V button to tune into the desired station.

- Press and hold the TUNING /V button for auto forward or backward radio station searching.

- Adjust the volume by repeatedly pressing the the VOLUME /V button.

NOTE: For the best FM reception, extend the FM aerial to its full length.

PRESETTING YOUR FAVOURITE RADIO STATION

Up to 10 FM radio stations can be preset.

• Tune into the station that you wish to preset.
• Press and hold the MEM/SET button for about 2 seconds, [P01] will flash on the display.
• Press the MEM/SET button to store the station.
• Repeat previous steps to store desired stations.

To listen to preset radio stations, press the MEM/SET button repeatedly to select the desired radio station.

ALARM OPERATION

NOTE: Before setting the alarm time, make sure the Clock has been set.

Setting Alarm 1 or Alarm 2

• In standby mode, press and hold the AL1 or AL2 button for 2 seconds. The hour and minute digits will flash.
• Set the alarm time by repeatedly pressing the HOUR and MIN buttons respectively.
  NOTE: Press and hold the HOUR and MIN buttons to fast forward.
• Press the AL1 or AL2 button to confirm.
• Press the AL1 or AL2 button again to select the alarm sound (OFF > BUZZER > RADIO in cycle).

Checking alarm time

Press and hold the AL1 or AL2 button for 2 seconds, the alarm time will flash on the display.

Turn off the alarm

Press the POWER/FM button to turn off the alarm. The alarm will come on again at the set time on the following days.

Snooze function

This function can be used to stop the alarm temporarily for about 9 minutes once the alarm is activated. When the SNOOZE button is pressed, the buzzer or radio alarm sounds will stop and sound again after about 9 minutes.

To cancel the alarm

Press repeatedly the AL1 or AL2 button until the alarm indicator light goes out on the display.

The sleep function is designed to automatically turn off the Radio.

Setting sleep timer

• Press the SLEEP button, [90] will light up on the display.
• Press repeatedly the SLEEP button to select the desired sleep time from 90, 80, 70, 60, 50, 40, 30, 20 or 10 minutes.
• The radio will be turned off after the selected time has elapsed.

NOTE: To check remaining sleep time, press the SLEEP button. To cancel sleep timer, press the SLEEP button until [OFF] is selected. To turn off the radio before the sleep time has elapsed, press the POWER/FM button.

PROJECTOR

• Switch on the projection clock by pressing the PROJECTION button.
• Press and hold this button for 2 seconds to flip the projection view upside down.
• To switch off the projection clock press this button again.

Turn the Focus thumbwheel to focus the projection clock image.

DIMMER CONTROL

Press repeatedly the DIMMER button to adjust the brightness of display.

CARE AND MAINTENANCE

Wipe external surfaces with a soft cloth. If the cabinet is very dirty, unplug from the mains supply and use a damp cloth soaked in a weak solution of washing up liquid and water. Allow to dry thoroughly before reusing.

SPECIFICATIONS

Power supply: 5 V / 500 mA Power consumption (max): < 3 W Power consumption (clock mode): < 1 W Radio frequency: FM 87,5 – 108 MHz Power output: 0,3 W (RMS) Backup battery: 1 x CR2032 size battery (not included)

WE RESERVE THE RIGHT TO CHANGE TECHNICAL SPECIFICATIONS.

WARNING: DO NOT USE THIS PRODUCT NEAR WATER, IN WET AREAS TO AVOID FIRE OR INJURY OF ELECTRIC CURRENT. ALWAYS TURN OFF THE PRODUCT WHEN YOU DON'T USE IT OR BEFORE A REVISION. THERE AREN'T ANY PARTS IN THIS APPLIANCE WHICH ARE REPARABLE BY CONSUMER. ALWAYS APPEAL TO A QUALIFIED AUTHORIZED SERVICE. THE PRODUCT IS UNDER A DANGEROUS TENSION.

TO AVOID DANGER OF SUFFOCATION, KEEP THE PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY.

Disposal of old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems)

This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product.

Hereby, ETA a.s. declares that the radio equipment type RA-E314B is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.JVCAUDIO.cz/doc

ÚVOD

OVLÁDANIE JASU DISPLEJA

This product is manufactured and distributed exclusively by ETA a.s., serviced and warranted by its designated partner.

"JVC" is the trademark of JVCKENWOOD Corporation, used by such company under license.