WLF-2500 - Effect machine Eurolite - Free user manual and instructions
Find the device manual for free WLF-2500 Eurolite in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Fog Machine |
| Brand | Eurolite |
| Model | WLF-2500 |
| Power Supply | 230 V / 50 Hz |
| Power Consumption | 2500 W |
| Warm-up Time | Approx. 3-4 minutes |
| Fluid Tank Capacity | 2.5 liters |
| Fluid Consumption | Approx. 100 ml/min at full output |
| Fog Output | Approx. 1500 m³/min |
| Dimensions (L x W x H) | 400 x 250 x 250 mm |
| Weight | 8 kg |
| Control | Manual, DMX, remote control (optional) |
| Safety Features | Thermal fuse, automatic shut-off when empty |
| Maintenance | Regular cleaning with distilled water; descale as needed |
| Spare Parts | Heating element, pump, fuse, fluid tank gasket |
| Reparability | User-replaceable fuse and fluid tank; other repairs by qualified personnel |
Frequently Asked Questions - WLF-2500 Eurolite
What type of fog fluid should I use with the Eurolite WLF-2500?
Use only high-quality water-based fog fluids specially designed for fog machines. Avoid using oil-based fluids to prevent damage to the heating element. Eurolite recommends its own brand or compatible fluids.
How long does it take for the WLF-2500 to warm up?
The warm-up time is approximately 3 to 4 minutes. The machine will indicate it is ready by a steady LED or a short beep.
Can I use the WLF-2500 outdoors?
The machine is designed for indoor use. Outdoor operation may affect fog density and is only recommended in windless conditions and with proper protection from moisture.
How do I clean the fog machine?
After every 20 hours of use, flush the system with distilled water. Fill the tank with distilled water and run the machine for a few minutes until the tank is empty. Do not use vinegar or descaling agents unless specified.
What is the maximum continuous runtime?
The machine can operate continuously as long as the fluid tank is filled. However, to extend the heater's life, it is recommended to give the machine a 10-minute break after 2 hours of continuous operation.
Can I control the WLF-2500 with DMX?
Yes, the WLF-2500 supports DMX control through a standard 3-pin XLR connector. It uses one DMX channel for fog output intensity and optionally a second for fan speed.
What safety features does the WLF-2500 have?
The machine includes a thermal fuse that cuts power if overheating occurs, and an automatic shut-off when the fluid level is low to prevent the pump from running dry.
How often should I replace the fuse?
Only replace the fuse if it blows. Check the fuse rating (e.g., T10A 250V) and replace with an identical type. If fuses blow repeatedly, have the machine inspected by a technician.
Can I use a remote control with this machine?
Yes, the WLF-2500 comes with a wired remote control with a 5-meter cable. An optional wireless remote is also available.
What does the blinking LED indicate?
A blinking LED during operation usually indicates a fault: a rapid blink may signal low fluid, while a slow blink can mean the machine is too hot or needs cleaning. Consult the manual for exact codes.
User questions about WLF-2500 Eurolite
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Effect machine in PDF format for free! Find your manual WLF-2500 - Eurolite and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. WLF-2500 by Eurolite.
USER MANUAL WLF-2500 Eurolite
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Eurolite
Model : WLF-2500
Category : Effect machine