AD30HTC - Guitar amplifier ORANGE - Free user manual and instructions
Find the device manual for free AD30HTC ORANGE in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Guitar amplifier head |
| Brand | Orange |
| Model | AD30HTC |
| Amplifier Technology | All-tube (valve) |
| Power Output | 30 Watts |
| Number of Channels | 2 (Normal and Hi-Gain) |
| Preamp Tubes | 3 x 12AX7/ECC83 |
| Power Tubes | 4 x EL84 |
| Reverb | Spring reverb |
| Effects Loop | Yes (series) |
| Speaker Outputs | 1x16 Ohm, 2x8 Ohm, 1x4 Ohm |
| Input Impedance | 1 MOhm |
| Controls | Gain, Volume, Treble, Mid, Bass, Reverb |
| Dimensions (W x H x D) | 55 x 27 x 27 cm (21.7 x 10.6 x 10.6 in) |
| Weight | 18 kg (39.7 lb) |
| Power Consumption | 200 W |
| Mains Voltage | 230V (50Hz) or 115V (60Hz) depending on region |
| Ventilation | Passive (ventilated grille) |
| Construction | Sturdy plywood cabinet with vinyl covering |
| Included Accessories | Footswitch (for channel and reverb) |
| Warranty | 2 years (subject to region) |
Frequently Asked Questions - AD30HTC ORANGE
How do I clean the Orange AD30HTC amplifier?
Use a soft, dry cloth to wipe the exterior. Avoid using any liquids or abrasive cleaners. For the grille, gently vacuum with a brush attachment.
What type of tubes does the AD30HTC use?
The AD30HTC uses 3x 12AX7/ECC83 preamp tubes and 4x EL84 power tubes.
How often should I replace the tubes?
Power tubes typically last 1-2 years with regular use. Preamp tubes last longer. Replace if you notice noise, distortion, or decreased output.
Do I need to bias the power tubes?
Yes, the AD30HTC requires biasing when replacing power tubes. It is recommended to have a qualified technician perform this adjustment.
What speaker cabinets can I use with the AD30HTC?
You can use cabinets with total impedance of 16Ω, 8Ω, or 4Ω. Use the matching output jacks: 1x16Ω, 2x8Ω, or 1x4Ω.
How do I connect the footswitch?
Plug the footswitch into the 'Footswitch' jack on the rear panel. It allows you to switch between channels and toggle reverb on/off.
Why is there no sound from my amplifier?
Check all cable connections, ensure the amp is powered on and not in standby. Verify the speaker cable is properly connected to the correct impedance output. Also check if the channel volume is turned up.
The reverb is not working. What can I do?
Make sure the reverb knob is turned up and the footswitch is not set to bypass reverb. If still not working, the spring tank or driver may require servicing.
Can I use the AD30HTC with an effects pedal?
Yes, you can connect pedals between your guitar and the amp input, or use the effects loop for time-based effects. The effects loop is series type.
Where can I find the serial number?
The serial number is located on the rear panel of the amplifier, near the power cord socket.
User questions about AD30HTC ORANGE
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Guitar amplifier in PDF format for free! Find your manual AD30HTC - ORANGE and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. AD30HTC by ORANGE.
USER MANUAL AD30HTC ORANGE
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : ORANGE
Model : AD30HTC
Category : Guitar amplifier