FWW 2000 - Heating EINHELL - Free user manual and instructions
Find the device manual for free FWW 2000 EINHELL in PDF.
| Brand | Einhell |
| Model | FWW 2000 |
| Category | Supplementary heating |
| Heating type | Fan heater |
| Heating power | 2000 W |
| Power supply | 230 V ~ 50 Hz |
| Power levels | 2 (1000 W / 2000 W) |
| Adjustable thermostat | Yes |
| Cold air function | Yes |
| Dimensions (W x H x D) | 22 x 27 x 16 cm |
| Weight | 1.5 kg |
| Overheat protection | Yes |
| Protection rating | IP20 |
| Color | Black and red |
| Cable length | 1.5 m |
| Transport handle | Yes |
| Safety switch | Yes (tip-over) |
| Repairability | Repairability index: 7/10 |
| Noise level | 45 dB (A) |
| Manufacturer warranty | 2 years |
Frequently Asked Questions - FWW 2000 EINHELL
User questions about FWW 2000 EINHELL
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Heating in PDF format for free! Find your manual FWW 2000 - EINHELL and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. FWW 2000 by EINHELL.
USER MANUAL FWW 2000 EINHELL
D
Achtung!
5.3 Zeitvorwahl (Timer)
When using the appliance, a few safety precautions must be observed to avoid injuries and damage. Please read the complete operating instructions and safety regulations with due care. Keep this manual in a safe place, so that the information is available at all times. If you give the appliance to any other person, hand over these operating instructions and safety regulations as well. We cannot accept any liability for damage or accidents which arise due to a failure to follow these instructions and the safety instructions.
1. Safety instructions
- Read the operating instructions before using the appliance for the first time. The appliance may only be used as described therein. All other usages are not permitted.
- Keep the instructions in a safe place and give them to third parties if necessary.
- Check that the appliance has been delivered in perfect condition. If it has suffered any damage, do not connect the appliance to the power supply.
●This appliance is only suitable for heating air in enclosed spaces.
●Not suitable for commercial purposes.
●Do not lay the power cable over parts of the appliance which get hot.
●Never open the appliance or touch live parts – danger of death!
●Never use the appliance with wet hands. - Position the appliance in such a way that the mains plug is accessible at all times.
- If the appliance is not used for a lengthy period of time, disconnect it from the mains supply.
●Do not use the appliance in rooms in which inflammable materials (for example solvents, etc.) or gases are used or stored. - Keep highly inflammable substances and gases away from the appliance.
- Do not use in areas where there is a fire risk (for example wooden sheds).
●Only use the heater with its mains lead fully extended.
●Not suitable for installation on permanently installed electrical cables. - Do not insert any foreign objects in the appliance's openings – danger of electric shock and damage to the appliance.
- Keep children and people on medication or under the influence of alcohol away from the appliance.
●Maintenance and repair work may only be carried out by authorized trained personnel. - Check the appliance, particularly the mains lead, for signs of damage every time before use. In
case of damage, contact a qualified electrician or customer services in the country where you are situated (in Germany, ISC GmbH)
●Water or other fluids must never come into contact with the appliance - Danger of death!
●Only connect the appliance to an earthed socket.
●Do not position the equipment directly below a socket.
●Never cover the heater, as this can lead to a build up of heat which may damage the appliance, or lead to fire (Fig. 3).
●Do not use the appliance for animal husbandry or livestock breeding.
- If the appliance is used for a lengthy time the housing can become very hot. Position the appliance in such a way as to prevent accidental contact.
●Never position the appliance on deep pile carpets.
●Children or infirm persons may use the appliance only under supervision. Children are not allowed to use the appliance as a toy.
●Ensure that a minimum distance of 100 cm to the equipment is maintained.
●This appliance has not been designed for use by people (including children) with limited physical, sensory or mental capacities or those with no experience and/or knowledge unless they are supervised by a person who is responsible for their safety or they have received instructions from such a person in how to use the appliance safely. Children must always be supervised in order to ensure that they do not play with the appliance.
●Mounting the appliance in the bathroom is not permitted.
●The heater may not be used near a bath, shower or swimming pool.
CAUTION:
Read all safety regulations and instructions. Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury.
Keep all safety regulations and instructions in a safe place for future use.
GB
2. Layout (Fig. 1)
1 Safety grille
2 Foot
3 Power cable
4 On/Off main switch
5 Temperature setting button
6 LED display
7 Timer function button
8 On/Standby button
9 "▲" button (higher) / "▼" button (lower)
3. Intended use
The equipment is designed exclusively for use as an additional heater in dry, closed rooms. It primarily emits heat by radiation straight on to objects and people who are in front of the appliance.
The appliance can be used indoors in a free standing position or mounted on a wall. Maintain all minimum distances. The appliance may only be used completely assembled and standing vertically.
The appliance may only be used for the tasks it is designed to handle. Any other use is deemed to be a case of misuse. The user/operator and not the manufacturer will be liable for any damage or injuries caused as a result thereof.
4. Technical data:
Rated voltage: 220 - 240 V \~ 50 Hz
Heat output: 1800-2000 W
Adjustment range of thermostat: 5 – 36 °C
Protection type: IP X0
5. Starting up
Caution: Before using the appliance for the first time, check that the voltage supply is the same as the voltage details set out on the rating plate.
●Read the safety regulations in section 1.
- When the appliance is used for the first time or after a long period of rest it may emit an odor for a short time. This is not a fault.
If the equipment should topple or fall over, the power supply will be cut off by a safety switch integrated in the equipment.
5.1 Switching on the appliance
With the main ON/OFF switch (Fig. 2/Item 4) the appliance is cut off completely from the power supply. Switch the main switch on first, and off last when you no longer need the appliance.
After the main switch is switched on, the equipment will be in standby mode. With the On/Standby button (Fig. 2 / Item 8) you can switch the equipment on or to standby mode.
5.2 Heating mode
Press the On/Standby button (Fig. 2 / Item 8) to switch on the equipment. The lowest heat output (1000 W) is then set (I).
Press the "▲" button to switch on the highest heat output (II). Press the "▼" button to reset to the lowest heat output.
5.3 Timer function
Note: An OFF time from 1 - 18h can be set.
Set the heating mode as described above. Press the timer function button (7). The currently set time will blink on the display. The selected time can be increased by pressing the "▲" button. The selected time can be decreased by pressing the "▼" button. To switch off the time selection, press the timer function button (7) again, and press and hold "▼" until "00" appears, or press the On/Standby button (8).
5.4 Setting the desired temperature
Note: A desired temperature from 5 – 36°C can be set.
Set heating mode as described above. Press the temperature setting button (5). The currently set temperature will blink on the display. The selected temperature can be increased by pressing the "▲" button. The selected temperature can be decreased by pressing the "▼" button.
5.5 Overheating guard
In case of excessive heating, the appliance shuts down automatically. If this occurs, turn off the appliance, disconnect the mains plug and wait a few minutes for the appliance to cool. After eliminating the cause (e.g. a covered air grille), the appliance can be switched on again.
6. Maintenance and cleaning
●Before carrying out any cleaning and maintenance work the appliance must be turned off, disconnected from the power supply and cooled down.
●Maintenance and repair work may only be carried out by an authorized electrical servicing contractor or ISC GmbH.
- Check the mains lead at regular intervals for signs of defects or damage. A damaged mains lead may only be replaced by an electrician or ISC GmbH in compliance with the relevant regulations.
- Use a damp cloth to clean the casing.
- Remove dust pollution with a vacuum cleaner.
7. Storage
The heater has to be stored in a dry place, covered if possible.
8. Ordering spare parts
Please provide the following information on all orders for spare parts:
●Model/type of the appliance
●Article number of the appliance
●ID number of the appliance
●Part number of the required spare part
For our latest prices and information please go to www.isc-gmbh.info
9. Disposal and recycling
The appliance is supplied in packaging to prevent it from being damaged in transit. The raw materials in this packaging can be reused or recycled. The appliance and its accessories are made of various types of material, such as metal and plastic. Defective components must be disposed of as special waste. Ask your dealer or your local council.
F
Attention!
Notified Body: Notified Body No.: Reg. No.:
2000/14/EC_2005/88/EC
Annex V
Annex VI
Noise: measured L_wA = dB(A) ; guaranteed L_wA = dB(A) P = KW; L/∅ = cm Notified Body:
2004/26/EC
Emission No.
Standard references:
EN 60335-1; EN 60335-2-30; EN 62233; EN 55014-1;
EN 55014-2; EN 61000-3-2; EN 61000-3-3;
Subject to change without notice Wiesenweg 22, D-94405 Landau/Isar
Documents registrar: Landauer Josef
natural_image
Symbol of a trash bin crossed out by two diagonal lines (no text or numbers present)
©Nur für EU-Länder
Never place any electric tools in your household refuse.
To comply with European Directive 2002/96/EC concerning old electric and electronic equipment and its implementation in national laws, old electric tools have to be separated from other waste and disposed of in an environment-friendly fashion, e.g. by taking to a recycling depot.
Recycling alternative to the demand to return electrical devices:
As an alternative to returning the electrical device, the owner is obliged to cooperate in ensuring that the device is properly recycled if ownership is relinquished. This can also be done by handing over the used device to a returns center, which will dispose of it in accordance with national commercial and industrial waste management legislation. This does not apply to the accessories and auxiliary equipment without any electrical components which are included with the used device.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers accompanying products is permitted only with the express consent of ISC GmbH.
F
All of our products undergo strict quality checks to ensure that they reach you in perfect condition. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made:
- These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. We do not charge you for this guarantee.
- Our guarantee only covers problems caused by material or manufacturing defects, and it is restricted to the rectification of these defects or replacement of the device. Please note that our devices have not been designed for use in commercial, trade or industrial applications. Consequently, the guarantee is invalidated if the equipment is used in commercial, trade or industrial applications or for other equivalent activities. The following are also excluded from our guarantee: compensation for transport damage, damage caused by failure to comply with the installation/assembly instructions or damage caused by unprofessional installation, failure to comply with the operating instructions (e.g. connection to the wrong mains voltage or current type), misuse or inappropriate use (such as overloading of the device or use of non-approved tools or accessories), failure to comply with the maintenance and safety regulations, ingress of foreign bodies into the device (e.g. sand, stones or dust), effects of force or external influences (e.g. damage caused by the device being dropped) and normal wear resulting from proper operation of the device. This applies in particular to rechargeable batteries for which we nevertheless issue a guarantee period of 12 months.
The guarantee is rendered null and void if any attempt is made to tamper with the device.
-
The guarantee is valid for a period of 2 years starting from the purchase date of the device. Guarantee claims should be submitted before the end of the guarantee period within two weeks of the defect being noticed. No guarantee claims will be accepted after the end of the guarantee period. The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used.
-
In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. Please keep your sales receipt in a safe place, as it is your proof of purchase. It would help us if you could describe the nature of the problem in as much detail as possible. If the defect is covered by our guarantee then your device will either be repaired immediately and returned to you, or we will send you a new device.
Of course, we are also happy offer a chargeable repair service for any defects which are not covered by the scope of this guarantee or for units which are no longer covered. To take advantage of this service, please send the device to our service address.
F BULLETIN DE GARANTIE
Chère Cliente, Cher Client,
- D
- Achtung!
- Zeitvorwahl (Timer)
- Safety instructions
- CAUTION:
- GB
- Layout (Fig. 1)
- Intended use
- Technical data:
- Starting up
- Switching on the appliance
- Heating mode
- Timer function
- Setting the desired temperature
- Overheating guard
- Maintenance and cleaning
- Storage
- Ordering spare parts
- Disposal and recycling
- F
- Attention!
- ©Nur für EU-Länder
- F BULLETIN DE GARANTIE
- Chère Cliente, Cher Client,
Brand : EINHELL
Model : FWW 2000
Category : Heating