Powershred DS-1200C - Shredder FELLOWES - Free user manual and instructions

Product Type	Shredder
Brand	Fellowes
Model	Powershred DS-1200C
Category	Document shredder
Cut Type	Cross-cut
Sheet Capacity	Up to 12 sheets per pass (80 gsm)
Shred Size	4 x 40 mm (P-3 security level)
Throat Width	230 mm (9 inches)
Bin Capacity	23 liters
Dimensions (H x W x D)	400 x 380 x 200 mm
Weight	5.0 kg
Power Supply	220-240 V, 50/60 Hz
Motor Power	120 W
Safety Features	Auto start/stop, reverse, thermal overload protection, safety lock
Maintenance	Lubricate with Fellowes shredder oil after every 30 minutes of use; empty bin when full
Special Functions	Jam prevention, energy saving mode, continuous run time 5 minutes
Warranty	1 year limited warranty

Frequently Asked Questions - Powershred DS-1200C FELLOWES

What type of cut does the Powershred DS-1200C produce?

The Fellowes Powershred DS-1200C uses a cross-cut mechanism, shredding paper into small particles of 4x40 mm for higher security.

What is the maximum sheet capacity?

It can shred up to 12 sheets of 80 gsm paper per pass. Exceeding this may cause jams.

Can it shred credit cards and staples?

Yes, it can shred credit cards and small staples without issue. Avoid shredding CDs or adhesive labels.

How do I clear a paper jam?

Use the reverse function to back out the paper. If jam persists, unplug the shredder and carefully remove the jammed paper from the cutter entry.

How often should I lubricate the shredder?

Lubricate every 30 minutes of continuous use or when shredding slows down. Use Fellowes shredder oil applied across the full width of the paper entry.

What does the safety lock do?

The safety lock prevents accidental operation, especially important when the shredder is not in use or when cleaning.

What is the bin capacity?

The removable bin holds 23 liters of shredded material, reducing emptying frequency.

Can the shredder run continuously?

It has a continuous run time of up to 5 minutes, after which it needs a 15-minute cooldown to prevent overheating.

What documents can I shred?

It handles paper, credit cards, and staple-bound documents. Avoid plastic, adhesive labels, and thick materials.

Is the shredder energy efficient?

Yes, it has an energy saving mode that powers down after 2 minutes of inactivity, reducing power consumption.

USER MANUAL Powershred DS-1200C FELLOWES

Exterior view of a black industrial paper-cutting device with visible internal components and control buttons (no text or symbols)

Please read these instructions before use.

Do not discard: keep for future reference.

Fellowes

Quality Office Products Since 1917

KEY

A. SafeSense® Technology
B. Paper/Card entry
C. Handle
D. Window

E. Pull-out Bin
F. Disconnect power switch
○ 1.0FF
12. ON
G. See safety instructions

H. Control Switch and Indicator lights

R 1. Reverse

0 2. OFF

I 3. Auto-On (green)

4 Overheat (red)

SafeSense

® indicator (yellow)

CAPABILITIES

Will shred: Paper, credit cards, staples, small paper clips and junk mail

Will not shred: Continuous forms, adhesive labels, transparencies, newspaper,

CD/DVDs, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted above

Paper shred size:

Cross-Cut 4mm x 50mm

Maximum:

Sheets per pass 12*

Paper entry width.... 225mm

* A4 (70g), paper at 220-240V, 50/60 Hz, 2.45Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Maximum recommended daily usage rates: 120 sheets; 10 credit cards. 12 sheets per pass to avoid jams.

Fellowes SafeSense ^® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

WARNING: IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

• Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. — away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.
• Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.

• Do not use if damaged or defective. Do not disassemble shredder. Do not place near or over heat source or water.

• This shredder has a Disconnect Power Switch (F) that must be in the ON (I) position to operate shredder. In case of an emergency move switch to OFF (O) position. This action will stop shredder immediately.

• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a wall outlet or socket of the voltage and amperage designated on the label. The outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.

Continuous operation:

Up to 5 minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 5 minutes will trigger a 30-minute cool down period.

PAPER/CARD

Plug in and put disconnect power switch in ON (I) position

Set to Auto On (1)

Feed paper/card straight into paper entry and release

When finished shredding set to OFF (0)

ADVANCED PRODUCT FEATURES

SafeSense® Technology Stops shredding immediately when hands touch the paper opening.

SET-UP AND TESTING

Set to Auto-On (I)

Touch test area and look for the SafeSense ^® indicator to illuminate

SafeSense ^® is active and working properly

For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER

All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding, and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

Set to Off (0)

*Apply oil across entry

Set to Reverse (R) 2-3 seconds

CLEANING AUTO-START INFRARED SENSORS

Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry).

TO CLEAN THE SENSORS

Turn off and unplug shredder

Locate Auto-start infrared sensor

Dip cotton swab in rubbing alcohol

Using cotton swab, wipe away any contamination from the paper sensors.

CAUTION

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.

SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding.

PAPER JAM

Set to Reverse (R) for 2-3 seconds

Alternate slowly back and forth

Set to Off (0) and unplug

Gently pull uncut paper from paper entry. Plug in.

Set to Auto-On (I) and resume shredding

LIMITED PRODUCT WARRANTY

Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 2 years from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any

additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.

Australia Residents Only:

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits under Fellowes' Warranty are in addition to other rights and remedies under a law in relation to the shredder.

Declaration of Conformity

Fellowes Manufacturing Company

Yorkshire Way, West Moor Park, Doncaster, South Yorkshire, DN3 3FB, England declares that the product Model DS-1200Cs conforms with the requirements of the Restriction of Hazardous Substances Directive (2011/65/EU), the Low Voltage Directive (2006/95/EC), the Electromagnetic Compatibility Directive (2004/108/EC), the WEEE directives (2002/96/EC), and below harmonized European EN Standards:

Safety: EN 60950-1

EMC Standard: EN55014-1 EN55014-2 EN61000-3-2 EN61000-3-3

Year Affixed: 12

Itasca, Illinois, USA

January 1, 2013

W.E.E.E.

This product is classified as Electrical and Electronic Equipment. Should the time come for you to dispose of this product please ensure that you do so in accordance with the European Waste of Electrical and Electronic Equipment (WEEE) Directive and in compliance with local laws relating to this directive.

For more information on the WEEE Directive please visit www.fellowesinternational.com/WEEE

Questions or Concerns?

www.fellowes.com	Customer Service & Support
Troubleshooting	Troubleshooting
Registration	Replacement parts
Manuals	General questions

Australia [phone]

Europe 00800-1810-1810

United Kingdom [phone]

United States [phone]