AXRC-GM5 - Unspecified AXESS - Free user manual and instructions

USER MANUAL AXRC-GM5 AXESS

Installation instructions for part AXRC-GM5

AXRC-GM5

GM Data Bus Interface

2005-2006

INTERFACE FEATURES

• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, and speed sense)
  • Used in both amplified and non-amplified sound systems

• Used in models without OnStar
• Retains all warning chimes
• High level speaker input
- Retains balance and fade
- Micro "B" USB updatable

INTERFACE COMPONENTS

- AXRC-GM5 interface • AXRC-GM5 harness

APPLICATIONS

CHEVROLET

Equinox 2005-2006

OLDSMOBILE

Torrent 2006

Table of Contents

Connections to be made....2

Installing the AXRC-GM5....3

Initializing the AXRC-GM5....3

TOOLS REQUIRED

• Wire cutter • Crimp tool • Tape
• Connectors (example: butt-connectors, bell caps, etc.)

CAUTION! All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running.

AXRC-GM5

Connections to be made

From the AXRC-GM5 harness to the aftermarket radio:

• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the amp turn-on wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.

The following (3) wires are only for multimedia/navigation radios that require these wires.

• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.

AXRC-GM5

Installing the AXRC-GM5 Initializing the AXRC-GM5

With the key in the off position:

• Connect the AXRC-GM5 harness into the interface.
• Connect the AXRC-GM5 harness to the vehicle.

Attention: If the interface loses power for any reason, the following steps will need to be performed again.

• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
  Note: If the radio does not come on within 60 seconds, turn the key to the off position, disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions of the installation for proper operation, before reassembling the dash.

Installation instructions for part AXRC-GMS

IMPORTANT

If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.

Metro recommends MECP certified technicians