92-3057P - Car accessory Metra - Free user manual and instructions

USER MANUAL 92-3057P Metra

Before starting, compare items on your invoice with items received. Carefully check through packaging material.

If an item is missing, please call:

Crutchfield at 1-888-955-6000

120 92-3057P

Saturn

Revision 09/17/03

Parts Supplied:

Isometric line drawing of a rectangular enclosure with circular cutouts and mounting holes (no text or symbols)

Technical line drawing of a trimplate component (no text or symbols)

Isometric line drawing of a support tray component (no text or symbols on the diagram itself)

(4) 1/4" Hex Screws

Technical line drawing of a bracket with mounting bracket (no text or symbols on the diagram itself)

(2) Studs

(2) 3/8" Nuts

Kit assembly instructions are on the following pages.

CRUTCHFIELD®

Copyright 2003 Crutchfield Corporation

Installation Kit

120 92-3057P

DIN Receiver Assembly

1. Press posts on trimplate into holes on kit frame to snap parts together and secure with hex screws (Figure 1).
2. Use a utility knife to cut out shaft supports in trimplate to create a DIN opening (Figure 2).
3. Push clips on support tray into slots on rear of kit frame to secure (Figure 1).
4. Use pliers to break off tabs on mounting bracket that are shown as shaded (Figure 3). The "A" tabs are the only tabs that should remain.
5. Secure mounting bracket to top of kit frame with studs and nuts supplied (Figure 1).
6. Remove DIN sleeve from receiver and slide into opening in trimplate. Secure sleeve to trimplate by bending the securing tabs (Figure 4).
7. Slide receiver into sleeve/kit assembly.

Tools Required ▼ 1/4" & 3/8" Sockets Utility Knife Small Flat Blade Screwdriver Pliers

FIGURE 2

Shaft Supports

Saturn

Shaft Supports Mounting Bracket Nut Support Tray Trimplate Hex Screws DIN Sleeve Stud Kit Frame FIGURE 1

FIGURE 3 Mounting Bracket "A" Tab Break off shaded tabs "A" Tab

FIGURE 4
Securing Tabs
Bend tabs after sleeve is inside assembly.

Hand holding a small mechanical component, possibly a tool or bracket, with no visible text or symbols.

CRUTCHFIELD®
Copyright 2003 Crutchfield Corporation

Installation Kit

120 92-3057P

Saturn

Shaft Receiver Assembly

1. Press posts on trimplate into holes on kit frame to snap parts together and secure with hex screws (Figure 1).
2. Push clips on support tray into slots on rear of kit frame to secure (Figure 1).
3. Use pliers to break off tabs on mounting bracket that are shown as shaded (Figure 2). The "A" tabs should be the only tabs remaining.
4. Secure mounting bracket to top of kit assembly with studs and nuts supplied (Figure 1).
5. Choose the proper spacers (supplied with your order) to allow receiver nosepiece to extend 1/8" to 1/4" beyond face of trimplate (Figure 3).
6. Insert receiver shafts (with spacers in place) through openings in trimplate. Secure receiver and faceplate with shaftnuts supplied with receiver.
7. Attach control knobs.

FIGURE 1 Mounting Bracket Nut Spacers (supplied with your order) Control Knobs Trimplate Support Tray Hex Screws Kit Frame Stud Faceplate Shaftnuts

Tools Required ▼ 1/4" & 3/8" Sockets Deep Socket (size depends upon receiver) Pliers

FIGURE 2 Mounting Bracket "A" Tab Break off shaded tabs "A" Tab

FIGURE 3 1/8"-1/4" Spacer

CRUTCHFIELD®

Copyright 2003 Crutchfield Corporation