99-3031B - Car accessory Metra - Free user manual and instructions

USER MANUAL 99-3031B Metra

Interior view of a car dashboard with air filters, a digital display screen, and a red warning triangle (no visible text or symbols)

Chevrolet Captiva Sport (w nav) 2014-2015

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle specific applications

KIT FEATURES

• ISO DIN radio provision with pocket
- Painted scratch resistant matte black to match the factory finish

KIT COMPONENTS

Technical line drawing of a rectangular electronic device with mounting brackets (no text or symbols)

Two isometric diagrams of metal plate components with mounting brackets and holes (no text or symbols)

Isometric line drawing of a rectangular electronic device with mounting holes (no text or symbols)

TABLE OF CONTENTS

Dash Disassembly ....2 Kit Assembly ....3

WIRING & ANTENNA CONNECTIONS

Wiring Harness: See metraonline for harness interface solutions

Antenna Adapter: 40-CR10 (sold separately)

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver
- 9/32" socket wrench

Attention! Let the vehicle sit with the key out of the ignition for a few minutes before removing the factory radio. When testing the aftermarket equipment, ensure that all factory equipment is connected before cycling the key to ignition.

DASH DISASSEMBLY

1. Unclip and remove the trim panel on the top of the dash. (Figure A)
2. Remove (2) 9/32" screws securing the radio trim panel, then unclip and remove. (Figure B)
3. Unclip the entire lower console panel and set aside. (Figure C)
4. Remove (4) 9/32" screws securing the radio. Slide the radio out, then unplug and remove.

Continue to Kit Assembly

Interior view of a car dashboard with air vent and top-mounted panel (no text or symbols visible)

Technical line drawing of a vehicle air intake manifold with no visible text or symbols

(Figure B)(Figure A) (Figure C)

Diagram of a car gear shift lever mechanism with directional arrows indicating motion (no text or symbols)

KIT ASSEMBLY

1. Slide the radio brackets into the radio bezel. (Figure A)
2. Slide the pocket between the radio brackets, then secure using (4) Phillips screws provided. (Figure B)
3. Remove the metal DIN sleeve and trim ring from the aftermarket radio.
4. Slide the radio into the bracket/pocket assembly, then secure using screws supplied with the radio. (Figure C)

Technical diagram of a mechanical bracket assembly with directional arrows indicating movement (no text or symbols)

(Figure A)

1. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess. Test the radio for proper operation.
2. Slide the radio into the dash, then secure using the factory screws.
3. Reassemble the dash in reverse order of disassembly to complete the installation.

Technical line drawing of a device casing with control panel and directional arrows (no text or symbols)

(Figure B)

Technical line drawing of a mechanical housing or enclosure with internal components and mounting features (no text or symbols)

(Figure B)

If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 386-257-1186 ext. 8300, or email at [e-mail]. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.

Metra recommends MECP certified technicians