001-451 - Milk Frother Menuett - Free user manual and instructions

Product Type	Milk Frother
Brand	Menuett
Model	001-451
Power	450 W
Voltage	230 V ~ 50 Hz
Capacity	450 ml (max 200 ml for warming, 100 ml for frothing)
Functions	Warming and frothing, warming only, frothing only
Heating Element	Inside base, not exposed
Accessories	Mixer, frother, lid
Material	Plastic jug, metal base
Color	Black
Safety Features	Overload protection, auto shut-off after 5 consecutive uses, cool-down required before cleaning
Cleaning	Hand wash only; do not immerse in water; do not use abrasive detergents
Usage	Household use only; not for outdoor use
Warranty	Standard manufacturer warranty (contact Jula)

Frequently Asked Questions - 001-451 Menuett

How do I froth milk with this milk frother?

Place the frother on the axle, add cold milk (max 100 ml), close lid, place on base, plug in, press power switch once for blue light. When light turns red, frothing is complete. Unplug after use.

How do I warm milk without frothing?

Place the mixer on the axle, add milk (max 200 ml), close lid, press power switch once. Blue light indicates heating; red light means ready.

Can I froth milk without heating?

Yes. For cold frothing only, add milk (max 100 ml), use the frother, close lid, press and hold the power switch for 2 seconds until the light flashes blue. When it turns red, frothing is done.

How do I clean the milk frother?

Unplug and let it cool. Wash the lid and jug with water and mild detergent. Remove the mixer/frother and wash in hot water. Wipe the outside with a damp cloth. Do not immerse the base or jug in water and do not use a dishwasher.

Why does the power switch flash blue?

A flashing blue light indicates that the milk frother is in cold frothing mode (only frothing, no heating). This happens when you press and hold the switch for 2 seconds.

Why does the milk frother stop working suddenly?

The milk frother has overload protection. If used 5 times in succession, it will trip and the light will flash blue. Wait about 5 minutes for it to reset to standby mode before using again.

Can I use plant-based milk like almond or soy?

The manual recommends using cold cow's milk (5–10°C). Plant-based milks may not froth as well and could cause overflow. For best results, stick to dairy milk.

What is the maximum amount of milk I can use?

For frothing (hot or cold), use no more than 100 ml. For warming only, use no more than 200 ml. Exceeding these limits may cause milk to overflow.

Can I put the jug in the dishwasher?

No. Do not wash any part in a dishwasher. Hand wash only with mild detergent and water.

How long does it take to froth milk?

The manual does not specify exact time, but the process completes when the light changes from blue to red. Typically it takes 1–3 minutes depending on volume and starting temperature.

USER MANUAL 001-451 Menuett

Black and white photo of a modern black kettle with a handle and control button (no text or symbols visible)

SE MJÖLKSKUMMARE

Operating instructions (Translation of the original instructions) Important! Read the user instructions carefully before use. Save them for future reference.

Värna om miljön!

Care for the environment!

Must not be discarded with household waste! This product contains electrical or electronic components that should be recycled. Leave the product for recycling at the designated station e.g. the local authority's recycling station.

Jula reserves the right to make changes. In the event of problems, please contact our service department.

www.jula.com

Tillverkare/ Produsent/ Producenci/ Manufacturer

Jula AB, Box 363, 532 24 SKARA

Distributör/ Distributør/ Dystrybutor/ Distributor

Jula Poland Sp. z o.o., ul.

SKUMMING OG OPPVARMING

OBS!

• This product can be used by children from eight years and upwards and by persons with physical, sensorial or mental disabilities, or persons who lack experience or knowledge, if they are supervised or receive instructions concerning the safe use of the product and understand the risks involved with its use. Do not allow children to play with the product. Cleaning and maintenance must not be carried out by children unless they are more than eight years old, and are kept under supervision.
• Keep the product and its power cord out of the reach of children under eight years of age.
• Keep the product under careful supervision when it is used by, or near children.

• Check that the mains voltage corresponds to the rated voltage on the type plate.

• Do not use the product base for any other purpose than the one it is designed for.

• Do not use the product without liquid, his can damage the heater element.
• Unplug the power cord before cleaning and when the product is not in use. Allow the product to cool before cleaning or removing parts.
• Do not allow the power cord to hang over the edge of a table or worktop, or to come into contact with hot surfaces.
• Do not place the product on or near a hot stove or in a hot oven.
• Place the product on a stable, level surface, out of the reach of children.

• Keep your hands and utensils outside of the jug when the product is in use, otherwise there is a risk of serious personal injury and/or material damage.

• Do not immerse any parts of the product in water or any other liquid, and do not wash them in a dishwasher.

• Do not touch hot surfaces. Use the handle and buttons.
• Handle the product with care when there is hot liquid in it.
• Avoid contact with moving parts.
• Do not use accessories other than those recommended or sold by the appliance manufacturer. The use of other accessories can result in fire, electric shock and/or personal injury.
• Do not use the product if it is damaged or not working properly, or if the power cord or plug are damaged. Take the product to an authorised service centre to be checked, repaired or adjusted.

• The product is only intended for frothing and/or warming milk. Never use the product for anything other than its intended purpose.

• The plug must be plugged into a correctly installed earthed mains socket.

• Never run the product without the lid in place.
• Do not place the product on, or near hot surfaces.
• The product is intended for household use, or for use in staff rooms, hotel rooms or other similar places.
• Do not use the product outdoors.

SYMBOLS

	Read the instructions.
	Approved in accordance with the relevant directives.
	Recycle discarded product as electrical waste.

TECHNICAL DATA

Voltage 230 V \~ 50 Hz

Output 450 W

Capacity 450 ml

DESCRIPTION

1. Base

2. Power switch

3. Lid

4. Handle

5. Jug

6. Mixer

7. Frother

FIG. 1

USE

NOTE:

- Before using for the first time, clean all the part in accordance with the instructions.

- Use cold milk (5–10°C).

- Allow the milk frother to stand for at least 3 minutes after using it and before using it again. If the milk frother is used 5 times in succession the overload protection will trip, the status lamp will flash blue, and the power switch will not work. After about 5 minutes the milk frother will reset to standby mode and can be used again.

- The mixer prevents burning during the warming. The frother is used to froth hot or cold milk.

- The milk frother can be switched off at any time by pressing the power switch once.

FROTHING AND WARMING

NOTE:

Add no more than 100 ml of milk, otherwise it can run over after frothing.

1. Place the milk frother on a stable, level surface.

2. Open the lid and place the frother on the axle in the bottom of the jug.

3. Pour in the required amount of milk and replace the lid.

4. Place the jug on the base and plug the plug into a power point.

5. Press the power switch once to start the milk frother. The power switch goes blue.

6. When the power switch goes red the frothing and warming are ready and the lid can be taken off.

7. Unplug the plug from the power point after use.

WARMING

NOTE:

Add no more than 200 ml of milk, otherwise it can run over after warming.

1. Place the milk frother on a stable, level surface.

2. Open the lid and place the mixer on the axle in the bottom of the jug.

3. Pour in the required amount of milk and replace the lid.

4. Place the jug on the base and plug the plug into a power point.

5. Press the switch button once to start the milk frother. The status lamp goes blue.

6. When the power switch goes red the warming is ready and the lid can be taken off.

7. Unplug the plug from the power point after use.

FROTHING ONLY

NOTE:

Add no more than 100 ml of milk, otherwise it can run over after frothing.

1. Carry out steps 1–4 in the instructions for frothing and warming.
2. Press and hold the switch button for two seconds. The power switch flashes blue.
3. When the power switch goes red the frothing is ready and the lid can be taken off.
4. Unplug the plug from the power point after use.

MAINTENANCE

• Wash the lid with water and a mild detergent, rinse well and wipe dry. Do not wash in a dishwasher.
  • Take out the mixer/frother and wash in hot water.
• Wash the inside of the jug with water and a mild detergent, and then wipe dry with a soft cloth.
• Wipe the outside of the jug with a soft, slightly damp cloth.
• The power cord can be wound up underneath the base plate to put it out of the way.

NOTE:

• Switch off the milk frother, unplug the plug from the power point, and allow it to cool completely before cleaning.
• Do not immerse the jug or the base in water or any other liquid.
• Do not use abrasive detergents or implements on the milk frother, this can scratch the surface. Never use toxic detergent.