731-112 - Water pump Axley - Free user manual and instructions
Find the device manual for free 731-112 Axley in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Type de produit | Water pump |
| Brand | Axley |
| Model | 731-112 |
| Power | 600 W |
| Voltage | 220-240 V ~ 50 Hz |
| Max flow rate | 3000 L/h |
| Max head | 35 m |
| Max immersion depth | 7 m |
| Max particle size | 30 mm |
| Outlet connection | 1" (25 mm) thread |
| Cable length | 10 m |
| Protection class | IP68 |
| Housing material | Stainless steel / reinforced plastic |
| Weight | 5.5 kg |
| Dimensions (L x W x H) | 180 x 180 x 350 mm |
| Operating temperature | 0 °C to 35 °C |
| Automatic operation | Float switch with adjustable level |
| Thermal protection | Built-in overheating cut-out |
| Maintenance | Clean filter and pump inlet regularly |
| Spare parts available | Impeller, seal, capacitor, float switch |
| Warranty | 2 years |
Frequently Asked Questions - 731-112 Axley
How do I prime the pump before first use?
Fill the pump body with water through the outlet port until water overflows, then connect the hose and start. The pump is self-priming only if the suction line is below the pump level.
Why is the pump not delivering water?
Check that the suction line is not blocked and the pump is fully submerged if submersible. Ensure the float switch is not stuck in the OFF position and that the power supply is active.
Can I run the pump dry?
No. Running dry damages the seal and motor. The pump has thermal protection but avoid dry running. The float switch should prevent it in automatic mode.
How do I clean the pump?
Disconnect power. Remove the filter cover and clean the impeller and casing with a soft brush. Rinse with fresh water. Do not use solvents.
What size hose do I need?
The outlet is 1 inch (25 mm) thread. Use a matching hose with internal diameter of 25 mm or a suitable adapter.
Why does the pump cycle on and off frequently?
Check for leaks in the discharge hose or a blocked intake. Also ensure the float switch is not obstructed. Low flow demand can also cause cycling.
The pump is noisy. What should I do?
Noise may indicate air in the system, cavitation, or a worn bearing. Check water level and ensure the pump is stable. If persistent, inspect the impeller for debris.
What maintenance is required?
After each use, rinse with clean water. Periodically check and clean the filter. Inspect the cable for damage. Replace worn seals if leakage occurs.
Can the pump be repaired?
Yes. Spare parts such as the impeller, mechanical seal, and capacitor are available. Refer to the manual for disassembly instructions.
What is the maximum temperature of water that can be pumped?
The pump can handle water up to 35 °C. Do not exceed this rating to avoid motor damage.
User questions about 731-112 Axley
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Water pump in PDF format for free! Find your manual 731-112 - Axley and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 731-112 by Axley.